GE JN327HWW Support and Manuals
Get Help and Manuals for this General Electric item
Popular GE JN327HWW Manual Pages
Use and Care Manual - Page 1
Range Hoods
GEAppliances.com
Safety Information 2, 3
Operating/Care and Cleaning Instructions
Charcoal Filter 5 Grease Filter 4 Hood Light 5 Hood Surfaces 5 Controls 4
Installation Instructions 6-14
Consumer Support
Consumer Support . . . . .Back Cover Warranty 15
*
Owner's Manual and Installation Instructions
JV247*-Vent & Recirculation options
JV248*-Vent & Recirculation options
JN327...
Use and Care Manual - Page 2
... and electrical wiring must always be referred to accumulate on low or medium settings. Sufficient air is small and contained in this model range hood. All other hidden utilities. C.
D.
Use proper pan size. The fire is needed for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE) and the local code authorities. The fire department is specifically...
Use and Care Manual - Page 4
... cool before replacing. Installation Instructions Operating Instructions
Consumer Support
Care and cleaning of the filter. Be sure electrical power is OFF.
NEVER OPERATE THE HOOD WITHOUT THE FILTER IN PLACE.
With careful handling, the metal filter will then slip out of the retaining tabs on the back. Order genuine GE part number WB02X8391.
Control Knobs (on some models)
Switch Pad...
Use and Care Manual - Page 5
... charcoal filter should be replaced after 6 to find the location of a dealer nearest you, please call our toll-free number:
National Parts Center 800.626.2002
GEAppliances.com
Operating Instructions Installation Instructions
Painted Surfaces (on hood usage). To inquire about purchasing stainless steel appliance cleaner or polish, or to 12 months (depending on some models)
Do not use...
Use and Care Manual - Page 6
... the ducts. DUCTWORK REQUIREMENTS
NOTE: Read the ductwork sections only if you have to the range hood.
Equivalent lengths of duct pieces are equivalent to a section of some typical ducts.
* ...these instructions
for installation using the tin snips, in order to improper installation is available at service panel and lock the service disconnecting means to prevent power from your GE ...
Use and Care Manual - Page 8
... pan head)
Exhaust Adaptor
1
(for repair or replacement.
• If the unit is damaged by the installer (if other than the width of the customer.
• If the unit is installed per
manufacturer's installation instructions. • If you are going to vent your range hood to width
30″ min. Installation Instructions
DAMAGE - SHIPMENT/INSTALLATION
• If the unit is damaged...
Use and Care Manual - Page 9
...;4″ x 10″ Rectangular)
JV338
IMPORTANT: If the hood is available for your model from the below choices. Only an electrical access hole will require and that your installation will be installed in a recirculating, non-vented, ductless manner, do not knock out any vent openings in the hood.
C Outside rear exhaust
(Horizontal duct-31⁄4″...
Use and Care Manual - Page 10
... FOR DUCTED INSTALLATIONS ONLY (JV247, JV248,
JV347, JV348 and JV367 models)
If the hood is to be inside the hood. Reinstall the...is visible. Remove the baffle from the inside the hood.
Set the cover and its mounting screws.
5 REMOVE WIRING ....
Remove rear rectangular duct knockout only.
10 Installation Instructions
2 REMOVE EXHAUST ADAPTOR
If exhausting/venting using the 31&#...
Use and Care Manual - Page 12
... the hood as a template and mark the locations on the cabinet for ductwork, electrical wiring and keyhole screw slots.
HOLE
11⁄4″
95⁄8″
hole for duct and electrical wiring. Wood shims (recessed-bottom cabinets only-shims must be a minimum of 3/8″ thick and cut out any vent openings in wall)
D. Installation Instructions...
Use and Care Manual - Page 13
... hole in the top cabinet while raising the hood.
Mounting screw (4)
Keyhole (4)
NOTE: DO NOT PUSH ON THE FAN BLADE. CL
Cabinet
17 SECURE HOOD
Slide the hood back against the wall. Tighten the mounting screws. Installation Instructions
14 SCREW IN PART WAY
Drive a mounting screw (from your GE supplier for optional power supply location
NOTE: If...
Use and Care Manual - Page 14
.... Installation Instructions
19 INSTALL LIGHT BULB
NOTE: A light bulb is complete. Metal grease filter or charcoal filter The installation is not shipped with an ordinary screw base, not more than 60 Watts, or a type A17 or T2 Compact Fluorescent (CFL) light bulb with the hood. Turn off at www.gelighting.com
20 FOLLOW ELECTRICAL CODE
Complete the electrical...
Use and Care Manual - Page 15
...
GE Range Hood Warranty.
This warranty is needed to the original purchaser and any succeeding owner for products purchased for service. All warranty service provided by a GE Authorized Servicer is product repair as provided in an area where service by our Factory Service Centers, or an authorized Customer Care® technician.
Consumer Support
Warrantor: General Electric...
Use and Care Manual - Page 16
... abilities and impairments.
Printed in this manual cover procedures to qualified service personnel. GE Appliances Website
GEAppliances.com
Have a question or need assistance with disabilities, check out our Website today. Schedule Service
GEAppliances.com
Expert GE repair service is still in the packing material. Other servicing generally should the need to their homes (VISA...
Quick Specs - Page 1
...Listed by
Underwriters
R
Laboratories
For answers to accommodate either an over-the-range microwave oven or a standard hood. GE® Standard Range Hood
Dimensions (in the cabinet over the range to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000. GE Appliances
JN327H -
Quick Specs - Page 2
...Round ducting - Provides light to fit standard round duct work. • Model JN327HWW - Bisque on white • Model JN327HCC - White on bisque • Model JN327HBB - GE Appliances
JN327H - GE® Standard Range Hood
JN327HWW/CC/AA
Features and Benefits
• Non-Vented - Black on black
Specification Revised 8/05 321446 Hood is designed to illuminate cooking surface below...
GE JN327HWW Reviews
We have not received any reviews for GE yet.