Fender 3014 Power Amplifier Support and Manuals
Get Help and Manuals for this Fender item
View All Support Options Below
Free Fender 3014 Power Amplifier manuals!
Problems with Fender 3014 Power Amplifier?
Ask a Question
Free Fender 3014 Power Amplifier manuals!
Problems with Fender 3014 Power Amplifier?
Ask a Question
Popular Fender 3014 Power Amplifier Manual Pages
Owners Manual - Page 3
SPECIFICATIONS
2. PATCH BAY 2-4-1. ...EQUALIZATION 4-3. MAIN LEVEL CONTROL 2-3-2. MONITOR LEVEL CONTROL 2-3-3. AUX IN 2-4-7. INITIAL CONTROL SETTINGS 4-1-1. USING THE GRAPHIC EQUALIZER TO ELIMINATE ACOUSTIC FEEDBACK 4-2-1. AUX LEVEL CONTROL (3016... 3-3. UPKEEP AND SERVICE INTRODUCTION 1-2. FUSE 3-4. FRONT PANEL CONTROLS, JACKS AND LEDs 2-1. SETUP AND OPERATION 4-1.
Owners Manual - Page 4
... added into the system as possible, this "normalized" patch may be "on the air." To make setup as simple as possible, the mixer, graphic equalizer and power amplifier are pre-patched in a standard configuration that senses amplifier error due to clipping, short circuit or improper load conditions, and automatically reduces the gain until the...
Owners Manual - Page 7
...set at 5, tone controls at 0, graphic controls centered, master volume at rated output level. All specifications refer to 20 kHz
less than .05%, 50 Hz to 20 kHz
less than .05%
less than 1%
36 dB
FREQUENCY RESPONSE: (Power Amplifier...at 10: Graphic EQ in, controls at 0 db:
Power Amp in:
Power amplifier driven to rated output level 12 volts per microsecond 25 volts per microsecond
Taken ...
Owners Manual - Page 8
... audio connectors (often called "XLR" or "Cannon" connectors) on each channel may also be set relatively high; The most natural sound is the inverting (-) input. (3016 and 3018).
2-1-2. ... mixing buss and to control excessive boominess or sibilance ("s" sounds) by avoiding extreme tone control settings. INPUT IMPEDANCES: Channel Low Z input:
Channel Hi Z input: Main In:
Equalizer In:...
Owners Manual - Page 9
... IN jack (3016 and 3018), the MAIN LEVEL control also determines the graphic equalizer and power amplifier input levels.
2-3-2. EFF/REV CONTROL. The 3014 contains a five-band graphic equalizer, and the... OUT jack.
2-3-3. The EQ controls are combined in dB to suppress feedback by the settings of the channel EFF/REV controls appears at each frequency. It controls the signal level present...
Owners Manual - Page 10
... AUX IN. The TAPE IN jacks are disconnected whenever a plug is prepatched to the power amplifier (see Sections 2-4-5 and 2-4-8). 2-4. Signals from the main signal and instead connects it lacks the... on the Effects/Reverb buss are routed to the Main buss by the settings of the EFF/REV level controls on that the amplitude of the channels are...the reverb driver and to speakers.
Owners Manual - Page 11
... distortion which senses distortion in a biamped system (this feature include dedicating the power amp to the Fender powered mixer is driven by a rocker switch located on for power amplifier. However, by the phone plug becomes the power amplifier's input. LEDs.
2-5-1. The red LIMIT LED comes on first to the speaker, and the damping...
Owners Manual - Page 12
... Section 4-3-2). SETUP AND OPERATION. FIGURE 1 illustrates the simplest way to authorized service personnel.
3-4. Load problems include shorted speaker cables or loudspeakers, or a load whose impedance is in the top of the same type and rating.
fl• )(
z 1%)
FENDER D1
FIGURE 1
SPEAKER OUT
MONITOR OUT
FENDER 2841 LOUDSPEAKERS
FENDER 2235 POWER AMP
FENDER 2822 MONITORS...
Owners Manual - Page 13
...other high level signal sources, lower settings may be avoided.
4-1-4. MAIN AND MONITOR LEVEL CONTROLS. THE CAUSE OF ACOUSTIC FEEDBACK. If the received signal is amplified enough (in a sound system ... critical for the error. The MAIN control should be necessary to possible acoustic feedback.
4-2. The microphones will occur at 0, or straight up . Try setting the channel LEVEL controls...
Owners Manual - Page 14
... the amplifier to your speaker impedance, use a balancing transformer close to achieve the best overall sound from such sources as such settings impair intelligibility.
6. Avoid extreme settings or settings which ...conductor zip cord to connect the amplifier outputs to control the motion of feedback -a ringing sound will take some trial and error -the first ringing usually occurs ...
Owners Manual - Page 16
... and cause distortion. SUGGESTIONS: 1. Use the power amp section of Crossover to use a second power amplifier for guitar, with MAIN signal patch
a.
PIN I LJ PIN 3 PIN 2
FIGURE 4 S 3...and 3018 incorporate a very versatile PATCH BAY, that can be obtained by using a Switchcraft connector (part #S3FM) with the resistor network shown in line with a line level signal, such as possible....
Owners Manual - Page 17
...• Periodically check the mixer for the location of the nearest Fender Authorized Service Center. therefore, any problems should be overemphasized.
With a few precautions you can help to insure... a small amount of trouble-free service. UPKEEP AND SERVICE.
5. The Fender 30XX Series powered mixers have been designed to overtighten.
• If you leave the mixer set up when you years...
Fender 3014 Power Amplifier Reviews
We have not received any reviews for Fender yet.