Dewalt DXPW3425 Support and Manuals
Get Help and Manuals for this Dewalt item
View All Support Options Below
Free Dewalt DXPW3425 manuals!
Problems with Dewalt DXPW3425?
Ask a Question
Free Dewalt DXPW3425 manuals!
Problems with Dewalt DXPW3425?
Ask a Question
Dewalt DXPW3425 Videos
DeWalt DXPW3425 Pressure Washer Review
Duration: 6:30
Total Views: 16,247
Duration: 6:30
Total Views: 16,247
DeWalt Professional 3400 PSI (Gas - Cold Water) Pressure Washer Honda Engine - DXPW3425 Review
Duration: 5:22
Total Views: 1,408
Duration: 5:22
Total Views: 1,408
DeWalt DXPW3425 Pressure Washer AAA 7109378 10-16 Rev0 Simpson Pump seal rebuild
Duration: 38:18
Total Views: 24,425
Duration: 38:18
Total Views: 24,425
DeWalt Professional 3400 PSI (Gas - Cold Water) DXPW3425 Review
Duration: 6:00
Total Views: 1,777
Duration: 6:00
Total Views: 1,777
Popular Dewalt DXPW3425 Manual Pages
Instruction Manual - Page 2
... pressure pump
Engine
Refer to the engine instruction manual for pressure washers is not available, an SAE 15W-40 oil may be used. If this oil is recommended, as these contain a rust inhibitor and an anti-foaming agent. Nozzle holder C. Professional spray gun D. Engine K. Gas cap O. Wheel E. Engine dipstick/oil plug H. FIG. 1 j F
Pump
For best results, pump oil designed specifically...
Instruction Manual - Page 3
... enough fresh air.
• ONLY use an engine inside homes, garages, crawlspaces or other partly enclosed areas. English
Specifications
MODEL
WEIGHT
DXPW3425
82 lbs (37.2 kg)
HEIGHT
22" (55.9 cm)
WIDTH
21" (53.3 cm)
Length
34" (86.4 cm)
PSI*
3400 (23442 kPa)
GPM*
2.5 (9.5 L/min))
Engine
HONDA** GX200 196 cc
* Rated Pressure and Rated Water Flow is within manufacturing...
Instruction Manual - Page 4
....
6. Read all instructions before using this instruction manual and the engine instruction manual for expansion.
4 ...Code, unless the engine is a violation of California statutes section 130050 and/or sections 4442 and 4443 of California. Save these instructions...pressures quickly. This Product Is To Be Used Only By Trained Operators. Forest Service land and may not be installed...
Instruction Manual - Page 6
... can happen
How to prevent it is damaged, worn, has melted from contacting the engine, or shows any signs of cracks, bubbles, pinholes, or other serious injury. Replace the hose immediately if it
• Your pressure washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh which could result in length...
Instruction Manual - Page 12
...Risk of pump as flowers and shrubs. Turn
engine off before
squeezing gun trigger. Fig. 7
2. Ensure nozzle is fully engaged (forward) before changing nozzles.
1. Changing Nozzles ...pumped 1 gallon (3.8 liters) of spray. Before spraying, check the item to change nozzles while pressure washer is a low-pressure operation.
Warning: Flying object could cause risk of chemical hose...
Instruction Manual - Page 13
... not installed on the spray wand.
4. Wipe any pets or animals. Fig. 9
Pump operates in a well-ventilated area. The thermal relief valve will not siphon if the black soap nozzle is
running or hot.
DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! DANGER: Carbon Monoxide. NOTICE: Risk of injury, read the pressure washer instruction manual and the engine instruction manual...
Instruction Manual - Page 14
... the possibility of the sight glass. Check engine oil level. The oil level should come to engine instruction manual for correct procedure.
NOTICE: Use of fuels with a pump octane rating of 5 gallons per EPA regulations and will damage
the unit and void the warranty.
2. Connect high pressure hose (P) to the pump. 10. Place the fuel valve lever (M) in this
product per...
Instruction Manual - Page 15
... by changing quick
connect nozzle. Shutting Down (Fig. 17, 18)
1.
Refer to pump will not start , check the oil level and add oil as needed.
15. WARNING: Risk of unsafe operation.
Expect the gun to stop water flow. Release trigger to kickback when triggered. 17.
Turn water source off while pressure washer engine is not in hose or
spray gun...
Instruction Manual - Page 16
...). How To Change Pump Oil 1. Loosen pump oil fill plug (BB). 2. Refill pump using the nozzle kit supplied and the following instructions:
1.
Fig. 20 Y
Fig. 21
16 Engine
Consult the engine instruction manual for the manufacturer's recommendations for any water pressure. 3. If this oil is equipped with oil at the factory. Shut off the pressure washer and turn...
Instruction Manual - Page 17
... until protector fluid exits pump outlet. Pressure Washer
1. Drain all water from dama ge. Start pressure washer and place spray wand into pump. 6. sTORAGE
Engine
Consult the engine instruction manual for the manufacturer's recommendations for your local dealer or authorized service center. Attach bottle to drain all water from high pressure hose, coil it and...
Instruction Manual - Page 18
...to repair or replace designated parts that is limited to repair and replacement of defective products as measured from shipping, accident, abuse, acts of the pressure washer. Use only accessories rated equal to any further loss, damages, or expenses - This warranty covers defects in the instruction manual shall void warranty.
As a factory authorized and trained Warranty Service Center...
Instruction Manual - Page 19
...the pump to mix with water to improve cleaning effectiveness. Choke control: Opens and closes carburetor choke valve.
The minimum requirements for water pressure. See engine manual.
kPa (kilopascal): Metric pressure measurement. 1 kilopascal equal 1000 pascals. The valve will open and release a gush of water in material and workmanship) Includes nozzles, hoses, spray guns...
Instruction Manual - Page 20
... corrective actions.
that has been exposed to the engine's instruction manual for a long period of normal use 22, 23, 24 Water leaking at gun/spray wand connection 25, 26 Water leaking at pump...25, 26, 27, 28 Oil leaking at pump...29, 30, 31, 32, 33, 34, 35 Pump Pulsates...12
Code 1 2 3
Troubleshooting Codes
possible cause
POSSIBLE SOLUTION
No fuel. Low...
Instruction Manual - Page 21
... pressure. 18 Chemical filter clogged. 19 Chemical screen not in cleaning solution.
20 Chemical too thick.
21 Worn seal or packing. 22 Chemical build up in chemical injector. 23 Worn or obstructed valves. 24 Worn unloader piston. 25 Worn or broken o-ring. 26 Loose hose connection. 27 Piston packings worn.
Have replaced by authorized service center. (Troubleshooting Codes...
Instruction Manual - Page 22
...em pers ists, replace plug.
Have replaced by authorized service center. Check and replace. Check and replace.
Clean vent plug; POSSIBLE SOLUTION Have replaced by authorized service center Tighten.
Refer to remove any blockage. English
(Troubleshooting Codes cont.)
Code
possible cause
28 Pump head or tubes damaged from freezing.
29 Oil seals worn. 30 Loose drain...
Dewalt DXPW3425 Reviews
We have not received any reviews for Dewalt yet.