Dewalt DC390B Support and Manuals
Get Help and Manuals for this Dewalt item
View All Support Options Below
Free Dewalt DC390B manuals!
Problems with Dewalt DC390B?
Ask a Question
Free Dewalt DC390B manuals!
Problems with Dewalt DC390B?
Ask a Question
Most Recent Dewalt DC390B Questions
Mission Part
there is to be two washers according to page 14, the N and the OI have only one washer for my new De...
there is to be two washers according to page 14, the N and the OI have only one washer for my new De...
(Posted by bondk007 8 years ago)
Dewalt DC390B Videos
DEWALT Bare-Tool DC390B 6-1/2-Inch 18-Volt Cordless Circular Saw
Duration: 1:04
Total Views: 4,687
Duration: 1:04
Total Views: 4,687
DEWALT Bare-Tool DC390B 6-1/2-Inch 18-Volt Cordless Circular Saw
Duration: :53
Total Views: 979
Duration: :53
Total Views: 979
Best Cordless Circular Saw; DEWALT Bare-Tool DC390B 6-1/2-Inch 18-Volt Best Cordless Circular Saw
Duration: 1:24
Total Views: 380
Duration: 1:24
Total Views: 380
The DeWalt DC390b Review - Popular Circular Saw Reviews
Duration: 1:03
Total Views: 202
Duration: 1:03
Total Views: 202
Popular Dewalt DC390B Manual Pages
Instruction Manual - Page 2
... level of severity for each signal word. BLADE LOCK BUTTON (not shown)
L.
NOTICE: ...in minor or moderate injury. SWITCH LOCK-OFF BUTTON
B. BATTERY PACK D. LOWER GUARD
RETRACTING LEVER
H. BEVEL ADJUSTMENT KNOB (...manual and pay attention to
G. SHOE F. AUXILARY HANDLE
situation which , if not avoided, may result
in death or serious injury. English
DC390 18.0 Volt Cordless Circular Saw...
Instruction Manual - Page 5
... kerf and check that do not match the mounting hardware of the blade can dig into the material. It is restarted.
3 Blades that saw teeth are holding the saw from the workpiece as given below the workpiece. h) Never use a rip fence or straight edge guide. The blade washers and bolt were specially designed for optimum performance and safety...
Instruction Manual - Page 6
... it may be serviced before each use . Serious personal injury may lead to loss of blade pinching and kickback. Inspect for the blade to stop after turn off. f) Blade depth and bevel adjusting locking levers must be retracted manually only for proper closing before use . Raise the lower guard with the saw to damaged parts, gummy deposits...
Instruction Manual - Page 7
... of work with soap and water. watts
min .........minutes
......... safety alert symbol
BPM ......beats per minute IPM........ Before using the battery pack and charger, read the safety instructions below. Allowing dust to include catalog number and voltage. Always use , place circular saw on a stable surface, shoe side down, where it will stand upright on the...
Instruction Manual - Page 8
... hazard. If battery pack case is out of liquid from the battery pack cells may occur under extreme usage or temperature conditions. WARNING: Fire hazard. However, if the outer seal is completely worn out. English
Consult the chart at the end of this manual for compatibility of batteries and chargers.
• Charge the battery packs only in DEWALT chargers.
•...
Instruction Manual - Page 9
... THESE INSTRUCTIONS: This manual contains important safety and operating instructions for outdoor use an extension cord suitable for battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery pack, and product using battery pack.
Electric shock may result.
CAUTION: Burn hazard. CAUTION: Under certain conditions, with DEWALT and...
Instruction Manual - Page 10
... attempt to operate on standard 120V
household electrical power. Chargers
Your tool uses a DEWALT 18 volt charger. the red indicator will not reduce this manual for at least the minimum wire size. Removing the battery pack will remain lit. The battery pack is designed to connect 2 chargers together. • The charger is ready for safety. Once the Automatic Tune-Up™...
Instruction Manual - Page 11
.... The red light flashes long, then short while in the charger. If the problem persists, try a different battery pack to determine if the charger is defective and should be left in the Hot Pack Delay mode. If the new battery pack elicits the same trouble indication as generators or sources that is out of charge will...
Instruction Manual - Page 15
... 2 through material supported at the back edge of eye injury, always use the saw serviced before using , and always use blades that may have the saw if the lower guard is pinched or bound tightly by an authorized service center or other qualified service organization, always using identical replacement parts. To assure product safety and reliability, repair, maintenance and adjustment...
Instruction Manual - Page 16
...blade can cause kickback.
The saw in a vertical direction can cause the blade to do so can cause stalling and kickback. IMPROPER DEPTH OF CUT SETTING ON SAW
To make the most efficient cut or not kiln dried)
C. BLADE.... LIFTING THE SAW WHEN MAKING BEVEL CUT
Bevel cuts require special operator attention to support the blade and minimizes twisting and pinching in blade twist. Failure ...
Instruction Manual - Page 17
... FIG. 8 illustrates proper hand support of 1˚. ALWAYS TURN OFF TOOL AND REMOVE BATTERY BEFORE MAKING ANY ADJUSTMENTS! Note ...saw is important to support the work properly and to hold the saw firmly to guide the saw and position your body and arm to allow only one-half of the blade will stop at a minimum, removes sawdust from cutting area. For the most efficient cutting action, set...
Instruction Manual - Page 18
... forward into kerf can withdraw the saw with its "good" side - Never reach under the blade. English
panel NEAR the cut . DON'T support board or panel away from below. The saw shoe on that is made.
SUPPORT FIG. 10 DON'T support board or panel AWAY from the work face that part of a board.
Cutting
Place the wider...
Instruction Manual - Page 19
... or removing/installing attachments or accessories. Tilt the saw shoe so the blade cuts at least once a week. never immerse any cleaning solutions.
17 Hand guiding is not in Figure 12. Release trigger and allow you start the cut is recommended.
CHARGER CLEANING INSTRUCTIONS WARNING: Shock hazard. MAINTENANCE
WARNING: To reduce the risk of a rip fence is completed...
Instruction Manual - Page 20
..., Laser, or Nailer for any defects due to a certified service center for use identical replacement parts.
Repairs
The charger is recommended that, once a year, you can return it is not serviceable. To reduce the risk of warranty coverage and warranty repair information, visit www.dewalt.com or call 1-800-4-DEWALT for a full refund - LATIN AMERICA: This warranty does not...
Instruction Manual - Page 68
...Indicates that the battery pack is not compatible with that specific charger. Lea el manual de instrucciones para obtener información más precisa. DEWALT Battery and Charger Systems
Battery
Output
Chargers/Charge Time - Cargadores de baterías no es compatible con ese determinado cargador. Read the instruction manual for one or more specific information. Actual charge...
Dewalt DC390B Reviews
We have not received any reviews for Dewalt yet.