Cub Cadet PRO Z 960 L EFI Support and Manuals
Get Help and Manuals for this Cub Cadet item
This item is in your list!
View All Support Options Below
Free Cub Cadet PRO Z 960 L EFI manuals!
Problems with Cub Cadet PRO Z 960 L EFI?
Ask a Question
Free Cub Cadet PRO Z 960 L EFI manuals!
Problems with Cub Cadet PRO Z 960 L EFI?
Ask a Question
Popular Cub Cadet PRO Z 960 L EFI Manual Pages
Operation Manual - Page 1
...'s Manual
Pro Z Series 500/700/900
Lapbar
Table of Contents
Safe Operation Practices 2 Assembly & Set-Up 8 Controls & Operation 12 Product Care 19
Replacement Parts 28 Attachments & Accessories 28 Warranties 31
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
NOTE: This Operator's Manual covers several models.
Operation Manual - Page 5
... deadly gas.
2. Adjust and service as necessary.
15. Also, visually inspect blade(s) for your model. Wrap the blade or wear gloves, and use a nozzle lock-open flame, spark, or pilot light as described later in a poorly ventilated area. Maintain or replace safety and instruction labels, as required.
7. The engine owner's manual is designed to prevent...
Operation Manual - Page 8
...time. It instructs you , and any , will be sure that will result from the operating position.
• Zero-Turn Tractor (1) • Battery Installation Hardware (1)
• Seat Tilt Knob Assembly & Hardware Pack (1) • Seat Mounting Hardware (1)
• Tractor Operator's Manual (1)
• Engine Operator's Manual (1)
Note: This Operator's Manual covers several models.
Please be...
Operation Manual - Page 11
... Note: If the positive cable grouping (c) is put into service after handling.
Press the lever to the left disconnected from ...to Step 6. Using the lever on the back of this manual to the Product Care section of the seat frame, lift... the tractor.
Remove the bolts and hex nuts from the manual bag. See Figure 2-20.
See Figure 2-20.
2. Locate the cables ...
Operation Manual - Page 12
... Set-Up section for three (3) seconds while in service alert mode or when in the STARTING POSITION, but mowing quality may vary by model.
When set in this Operator's Manual and the Engine Operator's Manual... Maximum Performance mode should always be specified. The levers must be used for instructions on each side of operation to the "ON" position.
The PTO knob must...
Operation Manual - Page 14
... the fuel valve(s). Be certain to the Electronic Throttle/EFI (Electronic Fuel Injection) Engines section. Make certain the PTO is in the Engine Operator's manual.
5. If the engine does not start -up , it as soon as instructed in the disengaged (down . Run engine for instructions on adjusting the seat. It has been prepared to...
Operation Manual - Page 20
... of pivot points.
Not all moving parts.
3. Disengage the PTO, set the parking brake and stop the engine... five minutes. Note: This Operator's Manual covers several models. Post-Operation Tractor Care
1. Use a hose to ...Cub Drive System Fluid Plus (Shell TT-SB) • Castrol™ (Syntec®) Edge™ 5W50
General Purpose Lubrication: Use any maintenance or repairs...
Operation Manual - Page 23
...in shortened life and reduce serviceability. Front-to Figure 4-11....8226; Read the product manufacturer's instructions and recommendations.
• Add to...
• Referring to the Engine Operator's Manual, drain the fuel from forming inside the engine...decks will cause serious starting problems.
b.
Fully charge the battery... 1-1/2".
3. Product Care
23 Replace the filter and drain plug ...
Operation Manual - Page 24
...service dealer. then connect the other electrical problems.
If you dismount from the ground below. Have the tractor's electrical system checked and repaired...instructions previously provided; See your authorized service dealer. 2. With the drive in the neutral position, the parking brake engaged and the PTO disengaged, sit in the desired height setting... trouble ...replaced. Service...
Operation Manual - Page 25
... belt around the PTO clutch. See Figure 4-18.
(c)
(a) (b)
(c)
(a) (b)
Figure 4-18 6. Replacing the PTO Belt
1. After routing the belt around the PTO pulley (b), use a 1/2" drive in the ...muffler and any surrounding parts at the rear of the deck. Turn front wheels as instructed in place, if not re-install as follows: 1. See Figure 4-19.
(a) (b) (d)
(c)
3. Set the parking brake. To...
Operation Manual - Page 26
...replaced.
26
Section 4-
Set the parking brake. 2. WARNING If a blade is bent or otherwise damaged, replace the blade with dull blades. Use only original equipment blades.
Grind metal from the blades. Remove the deck as instructed in that are bent should be removed unless all times. 3. Be sure to install...a part number...service by using a blade balancer. Note: The deck support...
Operation Manual - Page 27
Note: The deck support plate (i) does not need to have the transmission drive belt replaced.
Troubleshooting
Excessive vibration
1. Damaged or bent cutting blade. • Replace blade. Excessively high grass. • Mow once at a high cutting height, then mow again at desired height or make a narrower cutting swath.
4. Dull blade. • Sharpen or replace blade. PTO/Blade...
Operation Manual - Page 28
... Sealant Oil Filter Wrench Armortek Non-Stick Spray Carburetor & Choke Cleaner
28 Replacement Parts
5
Part Number 954-05127 954-04319
954-04327 954-05128 954-05129
954-05037
...-12 (554) Rear Wheel Assembly, 24 x 12-12 (560/760/772) Rear Wheel Assembly, 26 x 12-12 (960/972)
Front Wheel Assembly, 13 x 6.5-6 (500 Series) Front Wheel Assembly, 13 x 6.5-6 (700 Series) Front Wheel ... 700, 900 models.
Operation Manual - Page 31
... date of its option, either repair or replace any commercial, professional, agricultural, ...set forth herein is not a Federal Emission Control Warranty Statement, as any original part that the Product (except with respect to a new Cub Cadet...Cub Cadet LLC warrants that is determined to warranty with Operator's Manual. "Commercial Use" shall be free from an authorized Cub Cadet...
Operation Manual - Page 32
... (3) months for residential use of other rights, which vary from use of thirty (30) days from the authorized Cub Cadet service provider.
3.
DURING THE WARRANTY PERIOD, THE EXCLUSIVE REMEDY IS REPAIR OR REPLACEMENT OF THE DEFECTIVE PART, AS SET FORTH ABOVE. (SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE...
Cub Cadet PRO Z 960 L EFI Reviews
Do you have an experience with the Cub Cadet PRO Z 960 L EFI that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Cub Cadet yet.
Earn 750 points for your review!