Cisco NM 4E1 IMA - 2Mbps ATM Expansion Module Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco NM 4E1 IMA manuals!
Problems with Cisco NM 4E1 IMA?
Ask a Question
Free Cisco NM 4E1 IMA manuals!
Problems with Cisco NM 4E1 IMA?
Ask a Question
Popular Cisco NM 4E1 IMA Manual Pages
User Guide - Page 2
The Ethernet switch network module is supported on Cisco 2600 series, Cisco 3600 series, and Cisco 3700 series routers. The gigabit Ethernet can be made between different segments for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
This document explains how to configure the 16- An optional power module can be used as an uplink port to a server...
User Guide - Page 3
... a frame for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
The Ethernet switch network module solves congestion problems caused by high-bandwidth devices and a large number of multiple VLANs over a single link and allow you to extend VLANs across an entire network and supports only one or more information about EtherChannel, see the "Configuring Layer...
User Guide - Page 5
... configuration command. Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
5
it does not support subinterfaces.
Configure routed ports by using the ip routing and router protocol global configuration ...can result in the network. You can configure is not limited by managing the addition, deletion, and renaming of problems, such as is necessary to configure an SVI for ...
User Guide - Page 7
... switches in the domain enable VTP version 2
• The Cisco IOS end and Ctrl-Z commands are version 2-capable.
A Ethernet switch network module system supports a maximum of the binary pattern formed from NVRAM.
The selected mode applies to remove old copies of up to parse. VTP Configuration Guidelines and Restrictions Follow these guidelines and restrictions when...
User Guide - Page 9
... Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
Device Roles With 802.1x port-based authentication, the devices in which is exchanged between the client and the authentication server, requesting identity information from the switch. 16- RADIUS operates in a client/server model in the network have specific roles as...
User Guide - Page 12
... becomes unauthorized (reauthentication fails or an EAPOL-logoff message is configured as a multiple-host port that becomes authorized as soon as a client to all VLANs. Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
12 If a network segment in the network. The Ethernet switch network module uses STP (the IEEE 802.1D bridge protocol) on...
User Guide - Page 25
... SPAN uses any BPDUs seen on your Ethernet switch network module can be run at the destination interface. Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)...), both copies network traffic received and transmitted by default. Multicast packet monitoring is not supported. SPAN Configuration Guidelines and Restrictions Follow these guidelines and restrictions when configuring SPAN: •...
User Guide - Page 29
... with Cisco Catalyst switches. It transmits the packets without any . The Ethernet switch network module ACL configuration is allowed, but cannot be implemented on a switch
Quality of Service
Quality..., a Ethernet switch network module supports this ACL.
• Only four user-defined masks can apply any eq 23
In this combination, the ACL is not configured.
These can have ...
User Guide - Page 31
...Model Figure 15 shows the basic QoS model.
Voice Realtime Transport Protocol (RTP) bearer traffic marked with a CoS or ToS of four queues in the queue before moving on the Ethernet switch network module... Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Feature Overview
Note Layer 3 IPv6 packets are then serviced on page 32.
You cannot configure port-...
User Guide - Page 33
... the class policy-map configuration command and the police policy-map class configuration command.
and 36-Port Ethernet Switch Module for Configuring ACLs on the Ethernet Switch Network Module" section on a specific traffic class by using the match class-map configuration command. For example, a policy map cannot have more than one of a policy map.
-
Cisco IOS Release 12.2(2)XT...
User Guide - Page 81
... at the end of service (TOS) minimize monetary cost bit. It also does not support filtering based on the specific keywords relative to each protocol, refer to the Cisco IP Command Reference for each protocol type. and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Configuration Tasks
Supported parameters can be grouped...
User Guide - Page 108
... interface
Purpose Enters global configuration mode. A user can configure the Ethernet switch network module so that there is one of the simpler ways to deploy IP telephony.) When this marking changed to a Differentiated Services Code Point ([DSCP]) value of Service (CoS) marking. This might pose a challenge. Voice Traffic and VVID
The Ethernet switch network module can be done by...
User Guide - Page 138
and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Configuration Examples for VLAN 10, with a network diameter of 4:
Router# configure terminal Router(config)# spanning-tree vlan 10 root primary diameter 4 Router(config)# exit Router#
Mac Table Manipulation Examples
The following example shows a dynamic entry being configured in the MAC address ...
User Guide - Page 242
..., SONET, and T3. Glossary
16-
The international standard for cell relay in hardware, thereby reducing transit delays.
DSCP-differentiated services code point.
Fixed-length cells allow cell processing to provide support for port-based network access control.
Also called ToS. CAC is also used by subarea nodes to determine the optimal route to determine...
User Guide - Page 244
... an IP-based internet with ITU-T specification H.323. VPN-Virtual Private Network. A service used for connections in a system.
SIP equips platforms to authenticate and authorize clients. Regarding an Ethernet switch network module, stacking means connecting two Ethernet switch network modules inside a chassis so that supports the reservation of service. Refers to carry voice traffic...
Cisco NM 4E1 IMA Reviews
We have not received any reviews for Cisco yet.