Configuration Guide
Page 32
... and connecting a permanent power supply. Install access point/access points - That solution also results in the loss of the possibility of remotely controlling the power supply in smaller rooms and cabinets where they are often placed. To provide PoE to switch the access point on or off.... 5 Physical installation of access points Where the access points are to install a Cisco AP1130/AP1140/3500i is with two pairs). Naturally, one will need either a PoE-compatible switch or a PoE injector. Follow the installation instructions...
... and connecting a permanent power supply. Install access point/access points - That solution also results in the loss of the possibility of remotely controlling the power supply in smaller rooms and cabinets where they are often placed. To provide PoE to switch the access point on or off.... 5 Physical installation of access points Where the access points are to install a Cisco AP1130/AP1140/3500i is with two pairs). Naturally, one will need either a PoE-compatible switch or a PoE injector. Follow the installation instructions...
Configuration Guide
Page 45
...user with access to different VLANs. Right-click on a Remote Access Policy: for example "10" • Click on "OK" twice to return and select additional attributes. • Select "Tunnel-Type" and click on "Add" • Click on "Add" again and select "Virtual LANs (VLAN)" • Click on "OK" twice, ...below. 45 • Click on "OK", then "Next" and "Apply" Do this for each Remote Access Policy that is needed to assign a user to a different VLAN from that supplied as standard by the access points or controller unit: • Click on "Add", select "Tunnel-Medium-Type" and click on "Add" ...
...user with access to different VLANs. Right-click on a Remote Access Policy: for example "10" • Click on "OK" twice to return and select additional attributes. • Select "Tunnel-Type" and click on "Add" • Click on "Add" again and select "Virtual LANs (VLAN)" • Click on "OK" twice, ...below. 45 • Click on "OK", then "Next" and "Apply" Do this for each Remote Access Policy that is needed to assign a user to a different VLAN from that supplied as standard by the access points or controller unit: • Click on "Add", select "Tunnel-Medium-Type" and click on "Add" ...