Hardware Installation Guide
Page 150
... appear. The interface can also use the half-duplex command to put the Ethernet interface into half-duplex operation, the default state of the Ethernet interface. Finding Support Information for Cisco Interface Cards. You must also set the device to which the port is 0001.64ff.ef6a (bia 0001.64ff.ef6a... to half-duplex mode by default, and it does not autosense the mode of the platforms supported by entering the no full-duplex command. If you set the card to the port. If you must have forgotten your username or password, click Cancel at http://www.cisco.com/go/fn. To verify...
... appear. The interface can also use the half-duplex command to put the Ethernet interface into half-duplex operation, the default state of the Ethernet interface. Finding Support Information for Cisco Interface Cards. You must also set the device to which the port is 0001.64ff.ef6a (bia 0001.64ff.ef6a... to half-duplex mode by default, and it does not autosense the mode of the platforms supported by entering the no full-duplex command. If you set the card to the port. If you must have forgotten your username or password, click Cancel at http://www.cisco.com/go/fn. To verify...