Boss Audio B12ES Support and Manuals
Get Help and Manuals for this Boss Audio item
This item is in your list!
View All Support Options Below
Free Boss Audio B12ES manuals!
Problems with Boss Audio B12ES?
Ask a Question
Free Boss Audio B12ES manuals!
Problems with Boss Audio B12ES?
Ask a Question
Popular Boss Audio B12ES Manual Pages
- Page 2
Please read the instructions carefully so you for future reference. Serial No. Thank you will know how to operate your product properly. If there are any technical questions, please contact: Customer care: (805) 751-4853 & Live chat Online support: www.bossaudio.com/support IMPORTANT Please enter below the Serial No. Retain this information for...
- Page 3
......4 Subwoofer Setup Procedure...5 Protection Mode...6 Placement...6 Wiring...6
Low-Level Input Wiring ...7 High-Level Input Wiring ...7 Power Connection ...8 Remote Subwoofer Control Connection...9 Troubleshooting...9 Specifications...11
Introduction
The B12ES is missing, contact the store where you two wiring alternatives for remote subwoofer control mounting) • User manual and warranty...
- Page 4
... which may result in permanent damage to the system.
• Servicing must be hazardous.
Environmental Care
Do not throw away the product with normal household waste at a low setting then gradually increase the volume until you . - Follow your dealer or our technical support. Using the product in this product yourself. Dangerous high voltages...
- Page 5
... than the other speakers in the audio system.
4. If the midrange is well covered by time alignment problem in protection mode and not operational. Panel Controls and Features
10 9 8 7 6 5 4 3 ...LED: the subwoofer is in the audio system. c. b. Low Pass Filter (LPF) Use this setting.
3. Tip: If the other speakers of distortion. Bass Boost Control Use this subwoofer, turn ...
- Page 6
...; Failure to notice these instructions will result in an input overload to obtain best results. REM: Connect to the remote output wire of the subwoofer.
9.
Set the source unit volume to...your head unit does not have RCA outputs, use a fuse with a wire or coin. Subwoofer Setup Procedure
1. For best audio performance, low-level input is recommended to input audio signal to the ...
- Page 7
... or power loss. En el maletero
Detrás del asiento
Wiring
See the section "Installation Precautions" on , take the following reasons can trigger protection mode: input overload, short circuit...bare wires are correctly and securely made.
- 6 -
Use rubber bushings for reliable installation to place the subwoofer. Reconnect the negative terminal of the following measures. • ...
- Page 10
... turning it off the subwoofer briefly, then power it will not distract the driver. If you have a problem, contact our technical support. If the red LED illuminates, this product, check the following points before you request service. Troubleshooting
If you still have problems using two supplied screws.
Check all fuses. Protection/Red LED lighting up
Turn...
- Page 11
...Check if noise originates in the vehicle. Check that there is correctly and securely made. Problem No sound Low output Distorted audio Audio noise
Subwoofer getting very hot
Solution Check that ...connection, check the RCA cables are correctly and securely plugged.
Check for the subwoofer is set the input gain level as low as possible.
Check that the minimum speaker impedance for...
- Page 12
... (W x D x H 24" x 15"x 7" (610 x 381 x 178 mm)
Specifications are subject to +12dB Phase control switchable between 0° and 180°
General
Power supply 12...Remote turn -off yes Input gain control yes, variable LED indicators green - Specifications
Audio
Output power up to 1200W Driver size 12" Speaker impedance 4Ω Total harmonic distortion (THD 0.1% Frequency response...
Boss Audio B12ES Reviews
Do you have an experience with the Boss Audio B12ES that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Boss Audio yet.
Earn 750 points for your review!