Behringer CABLE TESTER CT100 Support and Manuals
Get Help and Manuals for this Behringer item
View All Support Options Below
Free Behringer CABLE TESTER CT100 manuals!
Problems with Behringer CABLE TESTER CT100?
Ask a Question
Free Behringer CABLE TESTER CT100 manuals!
Problems with Behringer CABLE TESTER CT100?
Ask a Question
Behringer CABLE TESTER CT100 Videos
Behringer Cable Tester CT100 - DJkit.com
Duration: :29
Total Views: 108
Duration: :29
Total Views: 108
Popular Behringer CABLE TESTER CT100 Manual Pages
Specifications Sheet - Page 1
CT100
ENGLISH
Technical Specifications
Version 1.0 March 2003
CABLE TESTER
Specifications Sheet - Page 2
CT100
CABLE TESTER CT100
Microprocessor Controlled 6 in 1 Cable Tester
s Accepts XLR, mono and TRS phone (1/4", 1/8", TT), RCA and MIDI connectors
s Sports three different testing modes: cable test mode, installed cable test mode and test tone mode
s Detects phantom power, intermittent connections and indicates the cable...
s Manufactured under BEHRINGER’s stringent quality control system
2
Specifications Sheet - Page 3
...06-30 3
No part of this publication is a registered trademark. BEHRINGER is subject to change without the express written permission of any kind, for any means, electronic or mechanical, including photocopying and recording of BEHRINGER Spezielle Studiotechnik GmbH. ALL RIGHTS RESERVED. © 2003 BEHRINGER Spezielle Studiotechnik GmbH. CABLE TESTER CT100
The information contained in...
Manual - Page 2
... check the most common cables used by wire breaks or faulty solder points. Move the cable vigorously in the signal flow. The LED will stay lit until RESET is pressed again, assuring detection of failure in CABLE TESTER MODE, press RESET to store the current cable-wiring display and to ensure fast, reliable problem location. Additionally, the...
Manual - Page 3
... MODE
+ Move the ON switch to the position TEST TONE.
+ Do not use the TEST TONE MODE for short circuits, connect one another) to the other . INSTALLED CABLE TESTER MODE
This mode enables you to connect both ends of the cable to the CT100.
+ Hold down the RESET button while moving the ON
switch to the...
Manual - Page 4
... above approx. 9 V is not intended to the “+ pin” (pin 2/tip) of all OUT jacks. CABLE TESTER CT100
TEST TONE MODE may be used to check signal flow and to choose between 1 kHz and 440 Hz. Use the TEST TONE LEVEL switch to facilitate level adjustments. PHANTOM POWER DETECT
In TEST TONE MODE, pins...
Manual - Page 5
... a request via e-mail at support@behringer.de, fax at +49 2154 920 665, or telephone at http://www.behringer.com: German, French, Spanish, Italian, Dutch, Finnish, Swedish, Danish, Portuguese and Greek.
5 CABLE TESTER CT100
XLR connectors (pin numbers visible on connectors)
RCA connector
7. MULTILINGUAL DOCUMENTATION + The following versions of this user’s manual can
be downloaded free...
Manual - Page 6
... 54 / 92 06-30 6 CABLE TESTER CT100
The information contained in any form or by any purpose, without notice. BEHRINGER is subject to change without the express written permission of any kind, for any means, electronic or mechanical, including photocopying and recording of BEHRINGER Spezielle Studiotechnik GmbH. No part of this manual may be reproduced or transmitted...
Manual - Page 7
...
CABLE TESTER CT100
complies with the FCC rules as mentioned in the following paragraph:
This equipment has been tested and found to comply with the limits for help.
This device complies with the instructions, may cause undesired operation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with Part...
Behringer CABLE TESTER CT100 Reviews
We have not received any reviews for Behringer yet.