Acer XV240Y Support and Manuals
Acer XV240Y Videos
Popular Acer XV240Y Manual Pages
User Manual - Page 2
... obligation to the contents hereof and specifically disclaims the implied warranties of this publication may be incorporated in the space provided below. All correspondence concerning your computer.
All Rights Reserved. The serial number and model number are registered trademarks of Acer Incorporated. No part of this manual or supplementary documents and publications. This...
User Manual - Page 3
English
Information for your monitor
Please carefully follow these instructions carefully.
Turn
off the power switch for hours. Special notes on LCD monitors
The following are normal with the LCD monitor and do not indicate a problem. • Due to make sure the flicker disappears.
• You may flicker during initial use .
• The...
User Manual - Page 5
.... Using a power outlet that the total rating of all servicing to replace the power cord set . If you to service this product.
• Use the product only with the supplied power supply cord set , make sure that the new power cord meets the following the operating instructions Note: The grounding pin also provides good protection from...
User Manual - Page 9
... Lepetit, 40, 20020 Lainate (MI) Italy Tel: +39-02-939-921 ,Fax: +39-02 9399-2913 www.acer.it
Product: Trade Name: Model Number: SKU Number:
LCD Monitor Acer XXVF24720Y XXVF24720Y xxxxxxxxxxx;x;
("x" = 0~9, a ~ z, A ~ Z, or blank)
We, Acer Incorporated, hereby declare under our sole responsibility that the product described above is in
conformity with the relevant...
User Manual - Page 10
..., including interference that may cause undesired operation. S. Tel : 254-298-4000 Fax : 254-298-4147
www.acer.com
Federal Communications Commission Supplier's Declaration of Conformity
This device complies with Part 15 of Responsible Party:
Contact Person: Phone No.: Fax No.:
LCD Monitor
XV240Y
XV240Y xxxxxx ("x" = 0~9, a ~ z, or A ~ Z)
Acer America Corporation
333 West San Carlos St. S.
User Manual - Page 17
Description 1 Lane0(p) 3 Lane0(n) 5 GND 7 Lane2(p) 9 Lane3(n 11 GND 13 Config1 15 AUX_CH (n) 17 AUX_CH (p) 19 DP Power_Return
* only for certain models
PIN No. Description 2 GND 4 Lane1(p) 6 Lane1(n) 8 GND 10 Lane3(p) 12 Lane3(n) 14 Config2 16 GND 18 Hot Plug Detect 20 DP Power 20-pin color display signal cable*
English
PIN No.
User Manual - Page 19
... electrical outlet.
FreeSync: It can allow a FreeSync supported graphics source to the HDMI (optional) and /or...update. English
Installation
1. Connect the signal cable to dynamically adjust display refresh rate based on the computer. 3. Plug the power cords of the graphics card on typical content frame rates for audio output model. Please check user manual for more instruction...
User Manual - Page 20
.... When the Function Menu is active, press this key to view the basic
information for your monitor and current input or reset the custom color settings to enter hotkey1 function. b.
The single toggle button on . a. Press again to the factory defaults.
b.
When the Function Menu is active, this button to enter...
User Manual - Page 21
...:
Main page
Mode Standard
Brightness 80
Input HDMI(2.0)
1.
Menu OSD
2. For advanced settings, please refer to quit current page and store. Brightness
80
Adjust
OK Hot Key2 (Modes, Volume, Brightness,Gamma, Contrast, Blue Light, Over Drive)
4. Actual product specifications may vary. Press the MENU key to adjust the picture quality and general...
User Manual - Page 22
... 100 Note: Adjusts the balance between light and dark areas.
7. Toggle the joystick to the up or down to select Picture from 0 to 100 Note: Sets the degree of difference between light and dark shades.
6.
Move
Mode - Selecting the input
Open the Input control and select HDMI 1, HDMI 2, DP or Auto...
User Manual - Page 24
... Light ACM HDR Super Sharpness
80
50 9
Off
Off
Auto
X
Off
Main Source DP
Resolution 1920x1080
H/V Frequency H:66KHz V:60Hz
Mode HDR
Information
S/N: MN53035032682018TPV888
Reset ALL Settings Exit
Move
Enter
Move
HDR = (Auto or HDR-400)
• HDR function and Effect:
Optional Auto
Off (Default)
Behavior Auto checked input source status
No...
User Manual - Page 26
... Audio Gaming OSD System
Mode - Move
Enter
1. Press the MENU key to "Normal" automatically.
2. VRB: To choose whether to support dynamic picture more clean control, default is "OFF", then the user can set to open the OSD.
2. Mute:To choose mute on/off . English
Audio
Picture Color Audio Gaming OSD System
Mode...
User Manual - Page 27
VRB set "On", when to turn on FreeSync, will auto set VRB is "Off".
4. VRB set "On", when to adjustment (Brightness, Blue Light, ACM), will auto set VRB is "Off".
3. VRB function does not affect the (Logo, Aim Point, Message and Input Icon) brightness.
5. VRB setting "On", when detection of Input Timing English
Note: 1. HDR setting: "Auto" is not support VRB.
2.
User Manual - Page 29
... software.
10. Auto Source:The default is DP1.2, can selection support DP1.1, or DP1.2 format.
7. Save Setting to ...(User mode only)
Mode - The options are three user-defined profiles available. Quick start mode: Select Off or On.
HDMI Black level setting.
11. Save Setting to some mode: There are Full, Aspect .
8. English
right to...
User Manual - Page 30
... Mode (Optional)
Problem No picture visible
LED status Blue
Off
Remedy
Using the OSD menu, adjust brightness and contrast to maximum or reset to the monitor.
Amber
Check if the AC power cord is properly connected to their default setting. English
Troubleshooting
Before sending your LCD monitor for servicing, please check the troubleshooting list below...
Acer XV240Y Reviews
Do you have an experience with the Acer XV240Y that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Acer yet.
Earn 750 points for your review!