AEG SCT71900S0 Support and Manuals
Get Help and Manuals for this AEG item
View All Support Options Below
Free AEG SCT71900S0 manuals!
Problems with AEG SCT71900S0?
Ask a Question
Free AEG SCT71900S0 manuals!
Problems with AEG SCT71900S0?
Ask a Question
Most Recent AEG SCT71900S0 Questions
Popular AEG SCT71900S0 Manual Pages
Product Manual - Page 3
... 6 Control panel 9 First use 10 Daily use 12 Helpful hints and tips 14 Care and cleaning 15 What to do if... 17 Technical data 18 Installation 25 Environmental concerns
The following symbols are used in this user manual:
Important information concerning your personal safety and information on how to change without notice
Product Manual - Page 4
... INFORMATION
In the interest of these instructions and make that spring lock unusable before installing and first using the appliance, read this user manual carefully, including its hints and warnings...properly informed on the door or lid, be sure to replace an older appliance having a spring lock (latch) on appliance use by omission. Save these user's instructions as you are discarding ...
Product Manual - Page 5
...) must not be strictly adhered to relevant instructions. • Do not place carbonated or fizzy drinks in the freezer compartment as this product in the bottom of the appli- ance.
If the power plug socket is a risk of the appliance. 4. Refer
to .
If the drain is Frost Free.
Daily Use
• Do not put...
Product Manual - Page 6
... packing.
• It is accessible after the installation of the appliance. • Connect to potable water supply only. 4)
Service
• Any electrical work required to obtain from your local authorities. Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in specific paragraphs.
• Unpack the appliance and check...
Product Manual - Page 7
... regulator, -
The Pilot light switches off . When "1"
appears the appliance is turned off . The temperature indicators switch off the fridge
1. The alarm indicator light goes out and at the same time the freezer temperature indicator show for more than 5 seconds. 2. The alarm indicator light flashes since the temperature is turned off . Switching...
Product Manual - Page 8
Temperature indicators
The temperature indicators show the changed , the compressor does not start immediately if automatic defrosting is being adjusted a flashing display indicates the fridge/freezer
temperature currently set for quick cooling of large quantities of the two buttons is pressed again the temperature is adjusted by 1°C.
DYNAMICAIR function
To switch on .
...
Product Manual - Page 9
...button) until the word "SC" appears in the energy-saving mode. set the required temperature by pressing the fridge temperature regulator. To activate the function, do these steps: 1. The FROSTMATIC... the Fridge Temperature -
To activate the function: 1. FIRST USE
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with ...
Product Manual - Page 10
...When first starting-up or after cooling).
Thawing
Deep-frozen or frozen food, prior to being used, can be frozen in the freezer compartment. Place the fresh food to obtain the best performance. 10 Daily use , before putting the products in the refrigerator compartment ... longer that can be thawed in the compartment let the appliance run at least 2 hours on the higher settings.
Product Manual - Page 12
... the door is open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set the Temperature Regulator toward warmer settings to "DYNAMICAIR Function"). If this happens, set to separate the fruit and vegetables from any humidity that may run continuously, causing frost or ice on the device manually when...
Product Manual - Page 15
...accessories • leave the door/doors ajar to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan.
Only a qualified electrician or competent person must do if... 15
Defrosting of the freezer
The freezer compartment of this manual. This means that is not in this model...the troubleshooting that there is no frost" type. Use the ...
Product Manual - Page 16
...plate. The lamp is in the freezer is normal, no voltage in the mains pliance to the mains socket.
The product temperature is not set cor-
This is Refer to room...not supported properly
The appliance is not closed correctly.
process, frost defrosts on the appliance.
The lamp is correct. Alarm". The door has been opened too Do not keep the door open the door. Let...
Product Manual - Page 17
... temperature regulator is allowed to replace the lighting device. The temperature in the energy label.
Contact your Service Center
Closing the door
1.
appliance is too low/high. time.
TECHNICAL DATA
Dimension of the appliance and in the freezer is too high.
Switch off FROSTMATIC or COOLMATIC manually, or wait to each other. set correctly.
Products are too...
Product Manual - Page 22
Attach the appliance to remove the part DX, in the case of right hinge, SX in opposite case.
6. Make sure to the niche with 4 screws.
Attach the covers (C, D) to the hinge. Remove the correct part from the hinge cover (E). Attach the hinge covers (E) to the lugs and the hinge holes.
I
I
5. C D
E
E
B Install the vent grille (B).
22 Installation 4.
Product Manual - Page 23
If the appliance must connect laterally to the kitchen furniture door: a) Slacken the screws in fixing brackets (H). 7. c) Retighten the screws.
8. ca. 50 mm 90°
21 mm 90°
ca. 50 mm
21 mm Disconnect the parts (Ha), (Hb), (Hc) and (Hd)
Installation 23
H
H
9.
b) Move the brackets (H). Install the part (Ha) on the inner side of the kitchen furniture.
Product Manual - Page 24
... square (Hb) into guide (Ha). Hc
8 mm
Ha Hb 8 mm
K Ha 24 Installation 10. Open the appliance door and the kitchen furniture door at an angle of the door where the nail must be fitted (K). Remove the brackets and mark a distance of 8 mm from the outer edge of 90°. Push the part (Hc) on the...
AEG SCT71900S0 Reviews
We have not received any reviews for AEG yet.