AEG LF7E7431BI Support and Manuals
Get Help and Manuals for this AEG item
View All Support Options Below
Free AEG LF7E7431BI manuals!
Problems with AEG LF7E7431BI?
Ask a Question
Free AEG LF7E7431BI manuals!
Problems with AEG LF7E7431BI?
Ask a Question
Popular AEG LF7E7431BI Manual Pages
User Manual - Page 2
... the very best from it to :
Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support
Register your product for better service: www.registeraeg.com
Buy Accessories, Consumables and Original spare parts for your appliance: www.aeg.com/shop
CUSTOMER CARE AND SERVICE
Always use original spare parts. SETTINGS...30 10. When contacting our Authorised...
User Manual - Page 4
...does not exceed (average) domestic usage levels.
• Do not change the specification of each programme (refer to the "Programmes" chapter). • The operating water...Service Centre. • Old hose sets must not be reused. • If the mains power supply cable is 7.0 kg. Do not exceed
the maximum load of this appliance. • The appliance maximum load is damaged, it must be replaced...
User Manual - Page 6
...replacement of the inlet hose.
• When unpacking the appliance, It is due to the appliance.
• Follow the safety instructions on the detergent packaging.
• Do not put flammable products or items that there is too short. Risk of the washing machine. Use original spare parts only.
• Please note that self-repair...Service Centre for 10 years after the installation... model
...
User Manual - Page 7
...000V ~ 00Hz 0000 W
D
00A
00000000
The rating plate reports the model name (A), product number (B), electrical ratings (C) and serial number (D).
4.... 50 Hz PRODUCT DESCRIPTION
3.1 Appliance overview
12
3
ENGLISH 7
10 11 12
4
5 6 7 8
9
13
1 Hinge supports 2 Detergent dispenser 3 Control panel 4 Magnetic plate 5 Door handle 6 Rating plate 7 Plate with rubber beater
8 Drain pump filter...
User Manual - Page 13
... to maximum 400 cm.
To a sink spigot Put the drain hose in the room
L
wall and tighten it with the supplied cable tie
L. Contact the service centre for the other drain hose and the extension.
5.7 Building in the drawings.
max.600 mm
To a wall-pipe
Directly to be built into the...
User Manual - Page 15
... the upper hole of the top plate and the lower hinge to right, invert the position of the hinge
supports M with magnet is on the upper position. The best solution would be opened from right to left to ...door reversibility before the appliance is built in completely. ENGLISH 15
Factory pre setting The appliance is originally pre set for the assembly of a cupboard door opening from
N
left .
User Manual - Page 16
Set the position of the hole to countersink the upper hinge. Countersink the holes.
449 mm
12,5 - 14 mm
22±1,5 mm
595-598 mm...it is necessary to drill two holes (dia. 35 mm, depth 12.5 - 14 mm depending on the depth of cupboard door) on the hinge support. Align the cupboard door to the furniture correctly. The centre of the hole Y should be fixed to the door by means of cupboard door is...
User Manual - Page 17
... must be only installed when the appliance installation is pre set for possible uneven thickness... of the appliance door and the 'Technical Data' chapter indicate the necessary electrical ratings. Make sure that your domestic electrical installation...by means of installation you can be easily accessible after installing the appliance. ...
User Manual - Page 18
CONTROL PANEL
6.1 Control panel description
1
through failure to install this appliance, contact our Authorised Service Centre. touch button 11 On/Off push button The ...800
30°
20°
Cold
Night
Time Save
Delay Start
11
10 9
8
76
The permanent options are set by holding pressed the relative button for damage or injury
6. 18 www.aeg.com
For any responsibility for at least...
User Manual - Page 19
... of the appliance.
g. ).
• Cycle end (
).
• Warning code (e.g.
).
• Error indicator (
).
• Indication of total operating hours of the washing phase, when ...it is a recommendation to the
'Operating hours counter' section in the 'Settings' paragraph for
...
User Manual - Page 20
... on or off. You must drain the water to prevent the fabrics from creasing. Set this button for a few seconds to Stand-by function automatically deactivates the appliance after ...washing programme.
The door stays locked and the drum turns regularly to reduce creasing. Set this button, you set incompatible options/ functions.
7.2 On/Off
Press this option for use at night time...
User Manual - Page 36
...appliance as it is corrosive to the plastic parts.
12.3 Detergent type and quantity
The choice ...together.
• Some coloured items can cause balance problems with the spin phase leading to excessive vibration. Remove ...8226; A very small load can discolour with cuts. manually redistribute the load so that the items are available....instructions that you pre-treat these generic rules: -
User Manual - Page 44
... of the drain hose is correct. • Set the drain programme if you set a programme without drain
phase. • Set the drain programme if you set an option which ends with water prop‐ erly.... Clean the filter, if
necessary. 44 www.aeg.com
With some problems, the display shows an alarm code and the Start/Pause button may flash continuously:
If the appliance is properly closed...
User Manual - Page 45
...Installation instruc‐
mediately. ENGLISH 45
• The programme was not finished properly or the appliance
Internal fail.
Contact the Authorised Service Centre.
Refer to "Care and cleaning". • Adjust manually...is set, cancel the setting or wait for possible solutions. The programme does not start the spin phase
again. This problem may be caused by balance problems.
...
User Manual - Page 46
...the detergent dispenser according the indications given in this user manual. If you need to "Installation instruction".
• Make sure that the flap is restored....set the correct temperature. • Decrease the laundry load.
Refer to open the door, please read carefully "Emergen‐ cy door opening the door:
CAUTION!
If the problem occurs again, contact the Authorised Service...
AEG LF7E7431BI Reviews
We have not received any reviews for AEG yet.