AEG F55210VI0 Support and Manuals
Get Help and Manuals for this AEG item
View All Support Options Below
Free AEG F55210VI0 manuals!
Problems with AEG F55210VI0?
Ask a Question
Free AEG F55210VI0 manuals!
Problems with AEG F55210VI0?
Ask a Question
Popular AEG F55210VI0 Manual Pages
Product Manual - Page 2
......11 8. TROUBLESHOOTING 13 10. Warning / Caution-Safety information General information and tips Environmental information
Subject to give you impeccable performance for many years, with innovative technologies that you for your product for better service: www.registeraeg.com
Buy Accessories, Consumables and Original spare parts for choosing this AEG product. SAFETY INSTRUCTIONS...
Product Manual - Page 3
...Do not keep the instructions with the appliance for future reference. 1.1 General Safety • This appliance is not responsible if an incorrect installation and use of 6 place settings. • If ...not change the specification of this appliance. • The operating water pressure (minimum and maximum) must not be obstructed by the manufacturer, its Authorised Service Centre or similarly...
Product Manual - Page 4
...replaced, this must be carried out by our Authorised Service Centre.
• Connect the mains plug to the mains cable. SAFETY INSTRUCTIONS
2.1 Installation
...installation instruction supplied with the appliance. • Do not move the appliance without disconnecting it is clean.
• The first time you connect the appliance to new pipes or pipes not used for UK and Ireland. 4 www.aeg...
Product Manual - Page 5
...from the mains socket. Contact the Authorised Service Centre to get closed in , near .... • Remove the door catch to prevent children and pets to replace the water inlet hose.
2.4 Use
• Do not sit or ...2.5 Disposal
WARNING! • If the water inlet hose is completed. Obey the safety instructions on the detergent packaging. • Do not drink and play with flammable products in the...
Product Manual - Page 6
... 60
°C
• Rinse
• Rinse 70
°C
• Drying
Duration (min) 145
125
Energy (kWh) 0.94
0.70
Water Rinse aid (l)
11
YES
8.4
YES 6 www.aeg.com
9 Mains cable 10 Basket 11 Cutlery basket
4.
Product Manual - Page 7
...Energy (kWh) 0.61
0.48
0.30
0.30
Water Rinse aid (l)
7.0
YES
6.8
YES
7.0 6.0
5.2 Setting and starting a programme
Starting a programme
Open the water tap. 1. Starting a programme with Delay Start
1.... on . 3. Interrupting a programme
1. Press the on . 4. Press Start / Pause. To set a programme, press
Programmes until 0 comes on . 3.
Close the door. Press Delay Start to...
Product Manual - Page 8
... salt.
4. Set the correct programme for dishwashers.
2. CAUTION! Turn the cap of soil. 6.
Fill the rinse aid dispenser with rinse aid.
3. Only use salt specifically designed for about...Contact your local water authority for the first time).
3. Filling the salt container
1. 8 www.aeg.com
The appliance stops. 2. Cancelling a programme
Press and hold Programmes for dishwashers. Add the...
Product Manual - Page 9
...softener level appears. 3. To help the environment, do not use standard detergent, set a proper water hardness level to open the lid of detergent
Filling the detergent ...setting for 5 seconds to set the right level of the water in equivalent scales. Do not change the water softener setting: 1. Refill the detergent dispenser before each wash cycle.
2. The compartment has 2 parts...
Product Manual - Page 11
... 3.
7.
HINTS AND TIPS
7.1 Loading the basket
The rows of prongs in the basket can set the rinse aid dosage between position 1 (lowest dosage) and
position 4 (highest dosage). Mix spoons with other cutlery to increase or decrease the dosage. ENGLISH 11
C
...
Product Manual - Page 13
...pads or solvents (e.g. Problem and alarm code
Possible solution
The ...; The programme indicator ''Deli-
TROUBLESHOOTING
WARNING!
Drain water from the ...set, cancel the setting or
wait for approximately 30 seconds.
• Close the water tap and contact an Authorised Service Centre. The programme does not start or it stops during operation, before you can solve the problem...
Product Manual - Page 14
... freely before you have checked the appliance, set and start a programme.
can turn Make sure that the spray arm
freely because of soil.
amount of the water soft- gent was not loaded correctly, water did not reach all surfaces. 14 www.aeg.com
Problem and alarm code
Possible solution
The appliance does not drain...
Product Manual - Page 15
Set a programme with rinse aid.
9.3 Error codes
Code E1
E4
Meaning Longer inlet time
Overfilled
10. ing phase. ted. There are wet and dull.
Fill the rinse aid dispenser with a drying phase has been selec- The rinse aid dosage is empty. The dishes are two possibilities for the cabinet hole for the appliance. INSTALLATION
10.1 Assembly...
Product Manual - Page 16
...If you install aesthetic panel, adjust the door spring tension. B A A. A
B
C A. Handle B.
Bracket, screws 4*12 C. Screw 4*12 B. To strain or relax the steel cable, rotate the adjusting screws. 16 www.aeg.com
...min. 550)
Height Thickness
407 (min. 388) 16 - 22
Installation of the door spring
The door springs are set at the factory to the proper tension for the outer door. Hinge,...
Product Manual - Page 17
... the plastic membrane (A). WARNING! Remove the sink plug when the appliance drains water to prevent problems during the draining phases. The internal diameter must be smaller than 750 mm from the bottom of... to prevent that the water goes back into the appliance. Do not use the special plastic support. ENGLISH 17
10.5 Water drain connection
max. 750 mm
• Connect the water drain ...
Product Manual - Page 18
...
11.1 Technical table
Water pressure
0.04 - 1.0 MPa
Power supply
Refer to rating plate
Capacity
6 place settings
Type / Description
WQP6-3305E
Standard place settings
6
Energy efficiency class 1)
A+
Annual energy consumption 2)
174 kWh
Energy consumption of the standard cleaning cy...
Mounting
build under
Build-in possibility
Yes
Power consumption
1280 W 18 www.aeg.com
A
11.
AEG F55210VI0 Reviews
We have not received any reviews for AEG yet.