Yamaha ATS-1010 Support Question
Yamaha ATS-1010 Support Question
Find answers below for this question about Yamaha ATS-1010.Need a Yamaha ATS-1010 manual? We have 1 online manual for this item!
Question posted by bmoore3206 on April 24th, 2013
Connection Question
Do I connect the Yamaha ATS-1010 sound bar to my Direct TV DVR receiver or to my TV?
Current Answers
Related Yamaha ATS-1010 Manual Pages
Owners Manual - Page 1
U
Front Surround System
ATS-1010
OWNER'S MANUAL
Owners Manual - Page 3
... the product.
2 IMPORTANT: When connecting this manual, meets FCC requirements.
and, most out of your equipment by Yamaha Corporation of radio or TV interference, relocate/ reorient the antenna....uses radio frequencies and, if not installed and used . Since hearing damage from loud sounds is often undetectable until it at a safe level. Follow all installations. Compliance with...
Owners Manual - Page 4
... it in a well ventilated, cool, dry, clean place - a room with chemical solvents; Yamaha will form when the surrounding temperature changes suddenly. In this state, this unit is designed to...avoid humming sounds.
4 Do not expose this unit to sudden temperature changes from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. As long as this unit is connected to excessive ...
Owners Manual - Page 5
...Supplied items 2 Front panel 2 Placing 3 Connection 4 Operation 6
Enjoying sound with your preference ......... 7 Additional Information 8 ... buttons or the remote control are subject to direct sunlight or lighting such as a result of the...,
commercials. (UniVolume 7 • Operate the unit by the TV's remote control (TV remote control learning 9
About this manual
• In this manual...
Owners Manual - Page 6
Supplied items
Before assembly and connecting, make sure you have received all of the following items.
Main unit × 1
Remote control × 1 Mounting template × 1
Optical cable × 1 (1.5 m (4.9 ft))
Spacer × 2 (for attaching to a wall)
Front panel
Battery × 2 (AAA, R03, UM4)
1
4
5
6
1 Indicators Light up to show the system condition.(☞ P. 11)
y
The indicators...
Owners Manual - Page 7
... .
• When connecting the unit, fix the cables in place where they will not become loose. Yamaha will bear no responsibility for...mm (#8)
Minimum
2 to 4 mm
20 mm (3/4")
(1/16" to damage your TV with rear panel of the unit. Using clamps other components such as BD player in...supplied spacers at the marks. Doing so may cause system failure, etc. We recommend that can attach the ...
Owners Manual - Page 8
... operation. • Set the volume of the TV to off.
4 En
To AC wall outlet Doing so may damage the cable plug
and/or terminal. Check the direction of the plug
OPTICAL OUTPUT
Optical cable
TV
(supplied)
SYSTEM CONNECTOR
SUBWOOFER OUT
SYSTEM CONNECTOR
SUBWOOFER OUT
Setting your TV
As connections are completed. • Do not use excessive...
Owners Manual - Page 9
... components, such as a BD player, etc. English
yAlternative connections
Connection
Connect the input components (BD player, STB, etc) to the unit directly in the following cases. • When the unit does not play the sound output from the components connected to your TV (☞ P. 4). • When your TV does not have any audio input jacks to "Using an...
Owners Manual - Page 10
.... (☞ P. 8) 9 MUTE: Switches mute mode on the unit, or sets it to standby mode.
2 Input buttons: Select the input source you have finished all cable connections and remote control operation, follow the procedure below to .
3 UNIVOLUME: Turns UniVolume mode on and off. (☞ P. 7)
4 CLEAR VOICE: Turns Clear voice mode on and...
Owners Manual - Page 11
... player connected to the audio input jack of the unit.
1 Switch the video input of your TV to the
video source such as a BD player. y
For information on the selected input. (☞ P. 11)
3 Start playback.
Playback in surround sound: You can enjoy a realistic sound effect using Yamaha's exclusive AIR SURROUND XTREME. The unit plays the TV sound.
Owners Manual - Page 12
...You can use the built-in green (☞ P. 11)
2 Press SUBWOOFER +/- Excessive sound may damage your choice. to exit the
adjustment mode. to enter adjustment mode. Additional Information...depending on the adjustable range. to standby mode.
2 Press both the VOLUME - Refer to "Alternative connections" (☞ P. 5).
1 Set the unit to adjust the volume level.
Green indicates a minus ...
Owners Manual - Page 13
...
• The default setting is difficult (with the unit in all directions again if TV remote control
remains difficult. • The TV remote control relay function is enabled even if
the unit is in a... stands and screws in standby mode. You can use the TV remote control relay function, which relays the TV remote control signal received at the front of the main unit, release the button ...
Owners Manual - Page 14
... button. Volume up
VOLUME +
Power on for 5 minutes without any reason, this may disturb TV remote control learning.
Note that screen glare may be remedied by initiating the factory settings.
1 ...Flashes in the remote control learning mode is left turned on /standby mode
4 Point your TV turned off.
Resetting the unit
Should the unit freeze for more than 3 seconds to ...
Owners Manual - Page 15
...unit, the indicators show the setting mode as below. Setting mode
Audio delay control (☞ P. 8) TV remote control learning (☞ P. 9) * These indicators light up in orange : No light : ... red : Lights up according to the state.
Playback of the subwoofer (☞ P. 8)
TV remote control relay function (☞ P. 9)
Indicators
Built-in subwoofer
Off
External subwoofer
Off
Built...
Owners Manual - Page 16
...AC power supply cable, and contact the nearest authorized Yamaha dealer or service center. The volume may be connected improperly. Adjust the volume level.
Press SURROUND on the...Connect the unit and the external subwoofer by using a subwoofer pin cable.
seconds, connect the power cable, and then turn the unit on again. The remote control sensor of the unit and TV Your TV itself received...
Owners Manual - Page 17
... to direct sunlight or lighting.
Try to use TV remote control relay function.
You cannot use the TV remote control relay function again after pressing the power button of your TV itself and of the unit to set both your TV and the unit to hide the remote control sensor of your nearest authorized Yamaha dealer...
Owners Manual - Page 18
...Inc. "DTS" and "DTS Digital Surround" are trademarks of Yamaha Corporation.
14 En Specification
Amplifier section • Minimum RMS ... 2 (TV,BD/DVD) • Coaxial 1 (STB) Output Jacks • Subwoofer 1 • System Connector (...to achieve 7-channel surround sound with only front speakers, and without notice.
This system employs new technologies and algorithms that make ...
Owners Manual - Page 20
© 2011 Yamaha Corporation
Printed in Malaysia ZA81330
Similar Questions
How To Program Your Tv Remote With Yamaha Sats 1010 Sound Bar
(Posted by olbared 10 years ago)
What Is The Difference Between The Yamaha Yas-101 And The Ats-1010 Sound Bars
(Posted by liderCtellm 10 years ago)
I Recently Purchased A Home Theater System And I Am Unable To Install It
I need a representative of yamaha to come to my home and install my home theater system
I need a representative of yamaha to come to my home and install my home theater system
(Posted by malinakj 12 years ago)
Home Theater Speakers For Denon
What are the best reasonably priced in-wall and in-ceiling speakers for the Denon AVR-1708 Receiver?...
What are the best reasonably priced in-wall and in-ceiling speakers for the Denon AVR-1708 Receiver?...
(Posted by rrourke 12 years ago)