Whirlpool WTW4950XW Support Question
Whirlpool WTW4950XW Support Question
Find answers below for this question about Whirlpool WTW4950XW.Need a Whirlpool WTW4950XW manual? We have 5 online manuals for this item!
Question posted by papadj1941 on April 21st, 2023
Error Codes Are They Availible
is there a list of error codes availible for the wtw4950xw2 washer
Current Answers
Answer #1: Posted by kcmjr on August 4th, 2023 10:29 PM
kcmjr
Member since:
May 5th, 2011 Points: 4,254,255
Member since:
May 5th, 2011 Points: 4,254,255
Error codes may be found at the Whirlpool web site.
Licenses & Certifications: Microsoft, Cisco, VMware, Novell, FCC RF & Amateur Radio licensed.
Related Whirlpool WTW4950XW Manual Pages
Dimension Guide - Page 1
... system
14" max. (356 mm)
5" (126 mm)
17" (432 mm)
48 in.2 (310 cm2)
24 in the top and bottom of laundry tub must install higher than 4.5" (113 mm) of washer.
Top of the door are required. install no higher than 96" (2.44 m) from bottom of drain hose should be provided. Dimensions...
Installation Instructions - Page 2
...page of the washer. If you have:
You will need:
Overhead sewer
Standard 20 gal. (76 L) 39" (990 mm) tall drain tub or utility sink, sump pump and connectors (available from local ...cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(648 mm) (686 mm)
42" (1067 mm)
2
Tools needed:
Parts needed: (Not supplied with washer)
Adjustable or open end wrench...
Installation Instructions - Page 3
... installation is not recommended. Top of standpipe must support washer's total weight (with spacing of 0" (0 mm) clearance on all sides of installation and servicing, and spacing for companion appliances and clearances for closet door ventilation openings which are required. Top of laundry tub must install higher than 96" (2.44 m) from bottom of...
Installation Instructions - Page 4
...If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that a separate circuit breaker serving only this time.
4 NOTE: To avoid floor damage, set washer ...INSTRUCTIONS
Before you are not sure the washer is properly grounded. A time-delay fuse or circuit breaker is required. If a mating outlet is not available, it and make sure lid is ...
Installation Instructions - Page 5
... and pull to remove all parts from tub. Place drain hose in case you need additional parts with clamp. For a laundry tub or standpipe drain, go to drain port
Remove tape from washer lid, open lid and remove cardboard packing tray from tray. Drain hose form must be inside standpipe; 3.
Gently place...
Installation Instructions - Page 6
... water for a few seconds through hoses into a laundry tub, drainpipe, or bucket to hot water faucet. Connect inlet hoses to washer
Attach hose to prevent clogs. Repeat this step with... every 5 years.
In most standard configurations, hoses will need additional parts with flat washers (not provided). Record hose installation or replacement dates for leaks.
Check for cold water...
Installation Instructions - Page 7
.... Adjust leveling feet
Jam nut
Secure drain hose to raise the washer. Then turn the leveling foot clockwise to lower the washer or counterclockwise to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with wooden block. Check levelness of washer.
15. HELPFUL TIP: You may want to reduce excess noise and...
Installation Instructions - Page 8
... an extra part, go back through steps to complete full cycle.
8
q Remove protective film from back of your tools. Close lid.
q Read "Washer Use" in your washer, measure 1/2 of normal
recommended amount of /recycle all parts are on some models). q Check that water faucets are now installed. q To test and clean your...
Owners Manual - Page 2
WASHER SAFETY
2
Owners Manual - Page 3
...energy compared to use. And sometimes, you may also result in an agitator-style washer, this washer delivers the detergent directly to determine the correct water level for the load. There ...detergent. As the washer dampens and moves the load, the level of humming and whirring sounds as the washplate moves the load. Low-water washing creates excessive sudsing with dirty laundry, fill it ...
Owners Manual - Page 4
...water safe for your fabric.
• W arm and hot water will be cooler than what your laundry load. See "Cycle Guide" for the load.
press again to "Yes" if using fabric softener...to soak in short pulses to select available cycles on during sensing. The sensing process will unlock briefly before water is restarted. Unlike traditional washers, the load is determined by regulating ...
Owners Manual - Page 5
...and the Lid Locked light will start over when the washer is restarted.
5 Avoid opening the lid during sensing. Fabric softener will unlock once the washer movement has stopped. If you need to resume the cycle...will use a spray rinse. Some cycles will hear sounds similar to the wash cycle as the washer rinses and moves the load. LID LOCKED To allow for best results. Press START/Pause/Unlock ...
Owners Manual - Page 6
...items in stains on all cycles and options are available on fabrics. No Spin High High High
Use this cycle to keep the inside of the washer fresh and clean. Use hot water for normally...stains and soils.
CYCLE GUIDE
For best fabric care, choose the cycle that are needed in washer
Clean Washer
with enough water to wash small, lightly soiled loads of 2-3 items that best fits the ...
Owners Manual - Page 7
...reduced rinsing performance. Always read and follow fabric care label instructions to avoid damage to your laundry
2. Using Oxi or color-safe bleach: If using the Bulky Items cycle.
•...information on using an Oxi or color-safe bleach laundry boost product, add to the bottom of detergent to determine the amount of the washer basket before adding clothes.
7
Separate lint-takers...
Owners Manual - Page 8
... cycle.
6. The Downy Ball® will automatically release the fabric softener during the rinse portion of Downy® liquid fabric softener into washer
5. Do not overfill or dilute. Load laundry into the Downy Ball®, pull the ring tightly to choose your load size.
Turn cycle knob to seal it, and place...
Owners Manual - Page 9
...wrinkling, and rusting of the spin prior to increase your energy savings on your previous washer provided. This is left open the lid to restart the cycle.
The EcoBOOST™ ...minutes to help dissolve detergents. When the cycle has finished, the DONE indicator will unlock once the washer movement has stopped.
Select cycle options, if desired
If you select a cycle, select the desire...
Owners Manual - Page 12
...
Avoid washing single items.
Use Bulky Items cycle for service to remove items.
Gurgling or humming
Washer may be unbalanced.
For normal operating sounds, go to www.whirlpool.com/help - It may...
Solution
Vibration or Off-Balance
Check the following for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Washer not loaded as final amounts of water are properly seated. ...
Owners Manual - Page 15
...washed. In Canada www.whirlpool.ca
If you experience
Possible Causes
Solution
Washer not performing as recommended.
Washer senses load size and adds correct amount of load.
Incorrect dispenser operation
... to the selected cycle.
http://www.whirlpool.com/help -
Added water lifts the laundry off the washplate, resulting in water. Use only liquid chlorine bleach in loose heaps...
Owners Manual - Page 17
... labor to correct defects in accordance with electrical or plumbing codes, or use or when it . WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of ...OR CONSEQUENTIAL DAMAGES. Expenses for travel and transportation for in an inaccessible location or is not available.
9. This warranty gives you specific legal rights, and you ever need repair service, ...
Warranty - Page 1
...Service" section or by an authorized Whirlpool servicer is not available.
9. Write down the following information about your major appliance...1301. You can be provided by Whirlpool.
5. WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of ...or repair labor on major appliances with electrical or plumbing codes, or use your major appliance, to instruct you also...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Why is HE High Efficiency detergent the only type of detergent to use in my washer?
...rinsing to excess suds. FAQs Knowledgebase search tips Washer not draining, not spinning out water; wet loads - Front-load washer Display shows an error code - HE High Efficiency detergent is specially formulated ...that we believe will be purchased at the end of this site is available in high-efficiency washers. HE detergent provides the right amount of HE detergent based on ... -
The water temperature is not correct - Cabrio® washer with Dispensers in Corners
...are reversed, the washer will display an "HC" error code at the end of time? If the hot and cold water inlet hoses are in a short amount of laundry. This is not...washer Check to you have an Energy Star® qualified washer? You may feel cooler to see if the hot and cold water inlet hoses were reversed during start-up the available hot water faster than your previous washer... -
Proposition 65 Warnings
Front-load washer Different types of California. Information about Proposition 65 and this California Act, even ...when a listed chemical is available on the website of the Office of Environmental Health Hazard Assessment (OEHHA) maintained by the Governor of the State of California as The Safe Drinking Water and Toxic Enforcement Act of 1986. Error code on the list of chemicals...
Similar Questions
Codes For Operation And Error Codes
we never got manuals with the washer, is there a error code list and operation page on setting to us...
we never got manuals with the washer, is there a error code list and operation page on setting to us...
(Posted by berniesue5 4 years ago)
My Wtw4950xw1 Lid Will Not Lock So The Machine Will Not Start.
I can trick it into starting one cycle at a time by clearing the error codes. Will a new latch kit s...
I can trick it into starting one cycle at a time by clearing the error codes. Will a new latch kit s...
(Posted by jerryhesby 9 years ago)
Where Do I Find Whirlpool Wtw4950xw Error Codes
(Posted by lewl1Maest 10 years ago)
Washer Won't Work
I had no issues the first few months of use. A few weeks ago, I noticed that it wasn't spinning the ...
I had no issues the first few months of use. A few weeks ago, I noticed that it wasn't spinning the ...
(Posted by workingk9 10 years ago)