Whirlpool WFW9150WW Support Question
Whirlpool WFW9150WW Support Question
Find answers below for this question about Whirlpool WFW9150WW.Need a Whirlpool WFW9150WW manual? We have 4 online manuals for this item!
Question posted by ppassalugo on March 8th, 2014
My Washer Does Not Cycle Properly. How Do I Fix The Problem?
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Odin on March 8th, 2014 1:44 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,740
Member since:
April 10th, 2010 Points: 41,236,740
See the solution at http://www.fixya.com/search.aspx?ref=ser&s=Whirlpool%20WFW9150WW%20cycle&.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFW9150WW Manual Pages
Owners Manual - Page 4
... hose G. Optional pedestal
Pedestal Height
Approximate Height with a maximum slope of the washer.
Proper installation is not recommended.
■ A sturdy and solid floor to stack your washer in low temperatures.
4 Inlet hose (2) C. If You Have
You Will Need to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available...
Owners Manual - Page 6
... may require additional spacing. See "Tools and Parts." Standpipe drain system - The top of the washer. Recommended installation spacing for cabinet installation
The dimensions shown are required.
7" (178 mm) 7"
(178 mm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. Additional hoses might be at least 30" (762...
Owners Manual - Page 7
... ground to a gas pipe.
■ Check with a qualified electrician if you are not sure the washer is equipped with local codes and ordinances.
A time-delay fuse or circuit breaker is required. If a... To minimize possible shock hazard, the cord must be provided.
■ This washer is properly grounded.
7
Failure to have a fuse in the neutral or ground circuit. Electrical Requirements
WARNING
■ ...
Owners Manual - Page 8
... sure washer drum is to the cold water faucet.
3. Using pliers, tighten the couplings with the attached cap.
4.
Then pull the power cord through both faucets and inlet hoses, into a laundry tub,...also retain the power cord inside the washer until it to do so can result. Attach a hose to move it is connected to be properly set up for the washer to the coupling or water faucet can...
Owners Manual - Page 9
.... Using pliers, tighten the couplings with an additional two-thirds turn. NOTE: Replace inlet hoses after 5 years of the laundry tub. Connect the Drain Hose
Remove drain hose from going back into the washer: ■ Use the drain hose form, and do not force excess drain hose
into place. A
B
A. Secure the Drain...
Owners Manual - Page 10
...detergent into a grounded 3 prong outlet. 8. Repeat to complete one whole cycle. After the washer is level, and all of /recycle all four feet are in the...electrical shock.
7. Check that all four feet are in the laundry tub or standpipe as necessary. Do not use an extension cord.... that all packaging materials. 5.
Level the Washer
Proper foot to side, or diagonally when pushed ...
Owners Manual - Page 11
... added to a load.
Smart Dispensers
The three compartments in all laundry products before the washer is easily removed for highperformance cleaning. Use only HE High Efficiency detergent... there is available at the beginning of all wash cycles except Rinse/Drain & Spin, and Clean Washer with traditional top load machines. This washer offers up to highspeed spin. The fabric softener is...
Owners Manual - Page 12
... close easily.
■ Mix large and small items. Avoid washing a single item. See "Cycles."
5.
First Wash Cycle Without Laundry
Before washing clothes for more than one of the cycles by pushing it stops. Do not overload washer. NOTE: After any wash cycle is completed, the door must be marked "HE" or "High Efficiency." When selecting a Wash...
Owners Manual - Page 13
...wash cycle is complete. IMPORTANT: When delaying a cycle, use . Choosing the Right Detergent
Use only High Efficiency detergents. The package for proper use the proper dispensers when adding laundry products...fabric softener to remain in washer errors, longer cycle times, and reduced rinsing performance.
Fabric softener will be removed from the washer. Laundry products are made to use...
Owners Manual - Page 14
...
1.
When Control Lock is operating.
Deselect EXTRA RINSE Option. 4.
Press START/PAUSE. Items can be
removed from the washer. Cycles and Options can be changed anytime before the door unlocks. Press and hold START/PAUSE (for 3 seconds until the CONTROL LOCK Status light turns off. ...
Owners Manual - Page 15
... wash small loads of your washing machine. Use this cycle to avoid chlorine residues on your laundry. Cycle
Estimated Temp Time* (hr:min)
Spin Speed
Whitest Whites Heavy Duty Eco Heavy Duty Normal Small Load (2 -3 items) Delicate Silk Rinse/Drain & Spin Soak Clean Washer with warm or cold water followed by selecting the speed...
Owners Manual - Page 16
...cycle later. ■ Press DELAY START until the desired setting is illuminated. Follow garment label instructions. Soils may select or deselect by pressing EXTRA RINSE. Controlled Temperature
Warm and cold wash temperatures are part of normal washer...The water temperature for all cycles.
■ See the "Laundry Guide" section for the Whitest Whites cycle. You may hear various sounds...
Owners Manual - Page 17
...Listed to the right are the options available to this chart for suggested load types and their corresponding cycles. CYCLE
SUGGESTED LOAD TYPE
AVAILABLE OPTIONS
Delay Extra Start Rinse
Signal TumbleFresh™ On/Off
Whitest Whites Soiled..., shirts, overalls, etc., made of these washer cycles.
Laundry Guide
Refer to each of cotton, linen, polyester, or nylon
✔
✔
Clean...
Owners Manual - Page 18
... inside out.
■ Separate dark colors from light colors, colorfast items from washer after the cycle is recommended that more than one mesh garment bag be used , and that each..., and other hard objects to avoid scratching the washer interior. Remove non-washable trim and ornaments.
■ Empty pockets. LAUNDRY TIPS
Preparing clothes for washing Follow these recommendations to...
Owners Manual - Page 20
... air dry with the dilute solution, using the procedure that uses higher water volumes in the washer. ■ Press POWER to check for proper use abrasive products.
■ If necessary, the cleaning cycle may be interrupted by pressing the Release Lever. a) Mix a dilute solution, using liquid chlorine bleach:
3. IMPORTANT: ■ Wear rubber gloves...
Owners Manual - Page 21
... instructions can damage your washer only when you are found. To winterize washer:
1. Flush water pipes. 2.
Shut off both water faucets. Run the washer through the Normal cycle with ½ the ...to provide ventilation. If washer will be transported in the drum. 2. When replacing your machine must be moved during freezing weather, winterize it will be properly set up for an ...
Owners Manual - Page 22
...; Is the sink or drain clogged? If the sink or drain is opened during the wash and rinse cycles. Check household plumbing (laundry tubs, faucets, drainpipe, water pipes) for service. ■ "F--E--" Variables (Washer Problem) Press POWER to the drainpipe or laundry tub. In U.S.A. Once you may extend underneath both ends of water per minute. Unplug...
Owners Manual - Page 23
...; Are the laundry products in death, fire, or electrical shock.
■ Is the power cord plugged into a working
■ Does the washer shut down the same time in washer or reconnect power.
Do not remove ground prong. Slowly pour into the liquid chlorine bleach dispenser (on some models)? If the problem continues, call electrician...
Owners Manual - Page 24
... 2 minutes during certain cycles. This washer uses very little water to the washer. You will be loose yet fit securely. This is normal. Washer won 't dispense
■ Is the washer level? The washer pauses for plugged screen.
■ Are the water inlet valve screens clogged? Allow the cycle to extend the drain hose the proper length into the...
Owners Manual - Page 25
...wet laundry in a low-speed cycle? If the laundry is wrinkled, twisted, tangled
■ Did you are connected to the washer drum.
■ Did you wash a large load in a small load or delicate cycle?...tumble freely during rinse and spin cycles can be balanced. Add items or try again.
■ Did you use HE detergent? ■ Did you sort properly? When using liquid detergent.
■...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Display shows F20 or FH - Front-load washer
...hoses from the inlet valves in the search tool below. Turn off water to the washer to the store for proper fill. See also: Why HE High Efficiency detergent is not loose, try taking the... water supply problem. Both hot and cold water must be able to pause or cancel the cycle for the first time after this will close the valve inside that can prevent the washer from the ... -
Washer will not start - Duet® Steam washer
...the washer is shipped from the washer. The washer will not properly operate with four bolts, which are with them, can result in the cycle? ...washer pauses for 3 seconds. Some cycles feature periods of water. Press and hold Start for leaks. Was the door left closed for 1 second? If the problem continues to start a new cycle. If the door is started? Allow the cycle... -
Display shows LF - Top-load washer with Dispensers in Corners
...shows uL - If the water pressure is a water supply problem. Is the drain hose extending more about proper drain systems for Cabrio washers. The example shown is at least 39" (99 cm)...height of the washer. Remove any accumulated film or particles from the inlet valves in the drainpipe or laundry tub. Re-select the cycle and press Start. Top-load washer with tape. ...
Similar Questions
Whirlpool Duet Washer Wfw9150ww Wont Start Beeps 3 Times
(Posted by chinspa 10 years ago)
Whirlpool Front Load Washer Wfw9150ww Will Not Spin
(Posted by rgalnaria 10 years ago)
Why Is My Wtw57esvw Not Run Through Wash Cycle Properly?
When starting a washload, my machine begins agitating the clothes as soon as the cycle starts and se...
When starting a washload, my machine begins agitating the clothes as soon as the cycle starts and se...
(Posted by trizzbizzle 13 years ago)