Whirlpool WFW9150WW Support Question
Whirlpool WFW9150WW Support Question
Find answers below for this question about Whirlpool WFW9150WW.Need a Whirlpool WFW9150WW manual? We have 4 online manuals for this item!
Question posted by chapmanpamela on December 25th, 2012
Does It Have A Reset Button?
My electric went out. Once back on my washer will not wash clothes. I can 't get it to turn on. Is there a reset button?
Current Answers
Related Whirlpool WFW9150WW Manual Pages
Energy Guide - Page 1
Clothes Washer Capacity: Standard
Whirlpool Corporation Models: WFW9150W*, WFW9250W*
Cat.
Government
Federal law prohibits removal of $1.218 per kWh and natural gas cost of this label before consumer purchase. H9WB6A2B(3B)
Estimated Yearly Operating Cost
(when used with an electric...cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per...
Owners Manual - Page 4
...set to deliver 120°F (49°C) water to the washer.
■ A grounded electrical outlet located within 4 ft (1.2 m) of the hot and cold...laundry room, closet, or recessed area. Ask for this washer. If you purchased your washer and dryer?
To order, call the toll-free number on soft floor surfaces, such as carpets or surfaces with a maximum slope of the washer. See "Electrical...
Owners Manual - Page 6
... molding may be at least 30" (762 mm) high and no less than 96" (2.4 m) from the bottom of the laundry tub must be purchased separately. Standpipe drain system - The top of the washer. Recommended installation spacing for recessed or closet installation, with a door, the minimum ventilation openings in .2* (155 cm2)
3" (76 mm...
Owners Manual - Page 7
... pipe.
■ Check with a power supply cord having a 3 prong grounding plug.
■ To minimize possible shock hazard, the cord must be provided.
■ This washer is required. Electrical Requirements
WARNING
■ Do not have the properly grounded outlet installed by a qualified electrician.
■ If codes permit and a separate ground wire is used...
Owners Manual - Page 8
... faucet.
3. Using pliers, tighten the couplings with the 4 transport bolt hole plugs. NOTE: Do not overtighten. Cover the bolt holes with an additional two-thirds turn.
1. Connect the Inlet Hoses
Insert new flat washers (supplied) into a laundry tub, drainpipe or bucket, to get rid of particles in the rear panel of the...
Owners Manual - Page 9
... replace hoses if bulges, kinks, cuts, wear, or leaks are found. Laundry tub drain or standpipe drain
Connect the drain hose form to the washer's cold (C) water faucet. Move the washer to the washer's hot (H) water inlet valve.
Hot water inlet C. Turn on the washer.
2. Drape the power cord over the end of hose failure.
Once...
Owners Manual - Page 10
...not tight against the washer cabinet. See illustrations A and B.
Check the electrical requirements. Check that you have all packaging materials. 5. To test and to turn the locknuts on ...washer, measure ½ the detergent
manufacturer's recommended amount of the drain hose in the laundry tub or standpipe as shown. Allow the washer to adjust back feet.
4. Slide the washer...
Owners Manual - Page 11
... and enables higher spin speeds for the first 7 minutes. The motor can wash larger, bulkier items such as an average size sleeping bag. The washer is designed to clean and rinse the clothes.
Add a Garment
This option is available in all laundry products before the washer is included in the Extra Rinse, if selected. This...
Owners Manual - Page 12
... clothes. For All Wash Cycles
1. Open the dispenser drawer and add laundry products to using your washer. See "Options."
6. It is completed, the door must be removed from the washer as soon as infant socks in noise or plugging the pump.
■ The washer can cause poor cleaning.
■ Always empty pockets. Close the washer door by turning...
Owners Manual - Page 13
...
To fill dispenser compartments
1. Pull out the dispenser drawer. 2. Add the desired laundry products to avoid a spill). NOTE: Overfilling could cause garment damage. This compartment cannot... wash cycle begins. The washer powers down the washer manually after the wash cycle. Using the Dispenser
Your new washer has a dispenser drawer with a pour spout; Always use . Main Wash...
Owners Manual - Page 14
... and Clean Washer with all buttons are disabled except for different types of the washer. NOTE: To add garments after the wash cycle has... (for 3 seconds until the CONTROL LOCK Status light turns off. Items can be changed anytime before the door unlocks...while the washer is complete. To cancel a cycle
1. Press POWER. 2. The washer powers down, the door unlocks, and clothes can add ...
Owners Manual - Page 15
...a short tumbling phase for equal distribution of the laundry, and a soaking time without spin assures gentle treatment...wash undergarments such as
underwire bras, items with AFFRESH™ cycle once a month to wash loads of your water pressure, water temperature, detergent, and clothes...wash time, and high-speed spin to help remove set -in the washer during the Clean Washer with an empty wash...
Owners Manual - Page 16
... light will be the same as your laundry.
See "Troubleshooting." Use the warmest wash water safe for Singal On or Signal Off.
16 Signal On/Off
This signal is automatic for an overview of detergent residue from your clothes, soon after the wash cycle ends. Between changes in wash actions, there will be released after...
Owners Manual - Page 17
Delicate
Curtains and delicate clothing, dresses, skirts, shirts, and
✔
✔
✔
✔
blouses. Laundry Guide
Refer to each of these washer cycles.
Listed to the right are the options available to this chart for suggested load types and their corresponding cycles. CYCLE
SUGGESTED LOAD TYPE
AVAILABLE ...
Owners Manual - Page 18
...can be filled with equal amounts of suds for the best performance.
When possible, turn lint-givers inside out to avoid pilling.
■ Tie strings and sashes so they...help you are made to avoid scratching the washer interior. Remove non-washable trim and ornaments.
■ Empty pockets. LAUNDRY TIPS
Preparing clothes for washing Follow these recommendations to use. Follow the ...
Owners Manual - Page 20
... parts under the seal/bellow and to thoroughly clean the inside of the seal/ bellow, using a damp cloth. NOTE: Do not wash components in combination with AFFRESH® washer cleaner or liquid chlorine bleach to check for better ventilation and drying of your installation and usage conditions for easy cleaning. 1. If stained areas...
Owners Manual - Page 21
... the drain hose from the drain system and attach to the washer. IMPORTANT: Call service. Put 1 qt (1 L) of R.V.-type antifreeze in the upright position. Turn on vacation or not using your washer. To transport the washer:
1. If washer will be transported in the drum. 2.
Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground...
Owners Manual - Page 22
... a pause of 2 seconds, then start of a cycle.
■ Is HE detergent being pulled through the sequence, you washing items with the floor.
■ Did you are still experiencing problems, please call for service. Unplug washer or disconnect power.
The four feet should be properly installed, and the nuts should be momentary pauses...
Owners Manual - Page 23
... time in the same wash cycle repeatedly? Washer stops working outlet, and check for 1 second? See "Washer Care" for color-safe bleach.
■ Is the fabric softener dispenser clogged?
Do not use the chlorine bleach dispenser for details.
■ Are the laundry products in the dispenser compartment. Replace the fuse, or reset the circuit breaker...
Dimension Guide - Page 1
....
Ref. Dimensions are required. W10252714A 10/2009 Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS WFW9150W
Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is recommended. wall or floor (views A & B) The standpipe drain requires a minimum diameter standpipe of the laundry tub must be no higher than 17 gal. (64...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I clean my Cabrio® top-loading washer?
... liquid fabric softener dispenser: To remove the fabric softener dispenser from my Top-loading HE washer? IMPORTANT: Be sure the inner cone-shaped cup is not cleaning laundry - To avoid damage to the washer or clothing, do not wash clothes with the liquid fabric softener dispenser removed or add detergent or bleach to this mixture into... -
The water temperature is not correct - Top-load washer
...time may notice lower hot or warm water temperatures. Washing many loads in a short amount of laundry. In order to the washer can produce it. This lower energy is not ...Turn the water back on some models) A warm/warm temperature selection provides a warm-water wash, a cold-water rinse and warm final sprays. If so, turn off the water lines at dissolving detergent and washing clothes... -
How do I clean my top-loading washer?
... softener dispenser. Do not add detergent or bleach to keep it is not cleaning laundry - How do not wash clothes with thumbs. This information is on some models): Cleaning the exterior Add 1 cup (250 mL) of your washer to this process if necessary. Cleaning the interior To clean the liquid fabric softener...
Similar Questions
My Washers Sensors, When I Turn It On Is Jumping Around Without Me Touching Them
(Posted by pink13cortez 3 years ago)
F8e1
I have a Wfw9150ww01 front load washers that gives f8e1 error code. Already replaced pressure switch...
I have a Wfw9150ww01 front load washers that gives f8e1 error code. Already replaced pressure switch...
(Posted by Anonymous-161257 7 years ago)
Whirlpool Front Load Washer Model Wfw9150ww Does It Have A Reset Button?
(Posted by wiclu 9 years ago)
Washer Sprays Clothes With Water At The End Of The Final Spin Cycle. Why?
(Posted by Alanpinnow 11 years ago)