Whirlpool WFW9150WW Support Question
Whirlpool WFW9150WW Support Question
Find answers below for this question about Whirlpool WFW9150WW.Need a Whirlpool WFW9150WW manual? We have 4 online manuals for this item!
Question posted by Anonymous-161257 on December 23rd, 2016
F8e1
I have a Wfw9150ww01 front load washers that gives f8e1 error code. Already replaced pressure switch and hot and cold values still doesn't work. Sometimes fill sometimes not but will not spin if it fills. What do I do now?
Current Answers
Answer #1: Posted by Odin on December 23rd, 2016 6:36 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFW9150WW Manual Pages
Energy Guide - Page 1
...and use.
• Cost range based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per therm.
• For more information, visit...kWh and natural gas cost of this label before consumer purchase. Clothes Washer Capacity: Standard
Whirlpool Corporation Models: WFW9150W*, WFW9250W*
Cat.
Owners Manual - Page 3
... the instructions are very important.
All safety messages will follow instructions. We have provided many important safety messages in this manual and on your appliance. WASHER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol. Always read and obey all...
Owners Manual - Page 4
...ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
■ A level floor with a total weight (water and load) of the washer.
Location Requirements
Selecting the ... (180 kg). Transport bolt hole plug (4)
E. If You Have
You Will Need to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
Overhead...
Owners Manual - Page 6
... mm)
6 Recommended installation spacing for cabinet installation
The dimensions shown are required.
7" (178 mm) 7"
(178 mm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. For cabinet installation, with stacked washer and dryer
The dimensions shown are for the recommended spacing.
48 in.2* (310 cm2) 24 in the...
Owners Manual - Page 8
... of the water to make sure that the hot water hose is connected to the hot water faucet and that the cold water hose is connected to do so can ...washers have been placed into a laundry tub, drainpipe or bucket, to be used for the washer to the cold water faucet. Washer
8 Attach a hose to work properly.
Firmly seat the washers in back or other injury. IMPORTANT: Position the washer...
Owners Manual - Page 9
... been placed into the hose couplings. NOTE: Replace inlet hoses after 5 years of hose failure. Connect the Drain Hose
Remove drain hose from washer drum
1. Laundry tub drain or standpipe drain
Connect the drain hose form to the washer's cold (C) water faucet.
Slide drain hose onto washer connection.
3. Bend drain hose over drain hose form and...
Owners Manual - Page 10
... are in the laundry tub or standpipe as shown. The washer should not move the washer out slightly before tipping back. Confirm the levelness of the washer, first side to...load. Do not remove ground prong.
Make sure all four feet are recessed, put more than 4½" (114 mm) of High Efficiency (HE) detergent for leaks around faucets and inlet hoses.
NOTE: Installing washer...
Owners Manual - Page 11
... enzymes have less moisture than for small and large load sizes. Electronic Controls Flexible electronic controls are easy to a load.
For some cycles, the default spin speed can handle slow speeds needed for cleaning. The fabric softener is included in all laundry products before the washer is designed to wash more water extraction, reducing drying...
Owners Manual - Page 12
... softener compartments. Use only HE High Efficiency detergent. For All Wash Cycles
1. Overloading can be fully loaded, but not tightly packed. Open the dispenser drawer and add laundry products to use.
Place a load of sorted clothes in washer errors, longer cycle times, and reduced rinsing performance.
Select the desired Options. The following is clean before...
Owners Manual - Page 13
... the washer automatically shuts off until the desired delay time (in hours) is for you do not guess. To fill dispenser ...the Right Detergent
Use only High Efficiency detergents. Push in washer errors, longer cycle times, and reduced rinsing performance. The bleach ...until door is normal for your load. ■ Always measure liquid chlorine bleach. Laundry products are made to produce the...
Owners Manual - Page 15
..., colorfast fabrics and heavily soiled garments. See "Cleaning Your Washer."
Hot washing temperatures assure optimal bleach activity.
Normal
Use this cycle because of set -in combination with warm or cold water followed by drain. Rinse/Drain & Spin is especially designed for approximately 1 second) to wash loads of chlorine bleach. Deslect Extra Rinse option. Press and...
Owners Manual - Page 16
...the amount of detergent residue from the washer as soon as your clothes. ATC regulates incoming hot and cold water.
■ Cold rinse is
illuminated. ■ Press...laundry. Cold rinses save energy.
Press and hold SPIN SPEED button for 3 seconds for fabrics. Not all cycles.
■ See the "Laundry Guide" section for an overview of load you are not accustomed to light soils
COLD...
Owners Manual - Page 17
...;
✔
polyester, nylon, cotton, linen, or cotton blends
Small Load
Small loads of 2-3 lightly soiled cotton, polyester, nylon, and
✔
✔
✔
✔
cotton blends. Laundry Guide
Refer to each of cotton, linen, polyester, or nylon
✔
✔
Clean Washer
No clothes, use AFFRESH® washer cleaner tablet or chlorine
with AFFRESH™ bleach
17...
Owners Manual - Page 18
...washer errors.... LAUNDRY TIPS...Loading
Loading suggestions
Heavy Work Clothes
2 pair pants 3 shirts
3 pair jeans 1 coverall
Mixed Load...Load cycle (2-3 garments)
2 dress shirts 1 pair dress pants
18
Unloading
■ Remove clothes from lightly soiled ones, even if
they will be filled with equal amounts of material. Using regular detergent will create too much sudsing with the washer...
Owners Manual - Page 21
...of replacement. Unplug washer or disconnect power. 4. Flush water pipes. 2. Turn on a Rinse/Drain & Spin cycle. 3. Run washer on vacation or not using your washer only when you are found.
Do not use or vacation care: Operate your washer for a medium-size load,..., winterize it will be properly set up for a medium-size load, to a water pressure surge) while you are at home.
Owners Manual - Page 22
...? www.whirlpool.com/help In Canada www.whirlpool.ca
Error codes
If your second code (E code). Count the number of 2 seconds and repeat. Unplug washer or disconnect power. Do not remove ground prong. Failure to determine your Error Code. Re-select cycle and press START/PAUSE. Select RINSE/DRAIN & SPIN if there is normal.
■ Were the 4 shipping...
Owners Manual - Page 23
...closed again to the dispensers? Slowly pour into a working
■ Does the washer shut down the same time in the same wash cycle repeatedly? Replace the fuse, or reset the circuit breaker. Control won... the spin?
Wait 5 minutes. Check electrical source or call an electrician.
■ Is your voltage low? Press and hold START/PAUSE, for details.
■ Are the laundry products ...
Owners Manual - Page 24
... the valve is normal and will attempt to redistribute the load with detergent.
■ Are both the hot and cold water faucets turned on? The hose needs an air gap. Check for about 2 minutes during certain cycles. The washer pauses for clothing stuck between spin basket and outer tub. As your frequency of drain hose...
Owners Manual - Page 25
....
■ Are the hot and cold water hoses reversed? Do not overload the washer. Use hot or warm washes if safe for load, use a fabric softener dispensing ball? Dispensing balls will cause wrinkling. Suds during washing.
■ Was the wash water warm enough to the detergent compartment. Make sure your wet laundry in cold or hard water...
Dimension Guide - Page 1
... drain system - Louvered doors with a doBor, the minimum ventilation openings in .2 (310 cm2)
3" (76 mm)
12" (305 mm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS WFW9150W
Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The water temperature is not correct - Top-load washer
... time may notice lower hot or warm water temperatures. washer? Top-load washer Cold and Cool water wash differences - Is the washer new or just recently installed? The distance from the washer? Washing many loads in each of laundry. Top-load washer Cold temperature selections - This is not correct - Top-load washers Warm or hot wash temperatures are as effective... -
Cycle time is not correct - Duet® Steam washer
... selection, and household water temperature and pressure. If excessive suds or an unbalanced load occurs, then the Estimated Time Remaining may be fully removed. Always use only HE High Efficiency detergent. Front-load washer Washer will glow while the washer is required. Steam washer Why is displayed, the washer automatically extends the rinse time to... -
Display shows dU - Top-load washer with Dispensers in Corners
washer Display shows dU. Display shows Ld - To remove the error display, press Pause/Cancel once. Top-load washer with Dispensers in Corners This error code indicates that the lid cannot unlock. Is there excessive weight on the lid, such as a basket of laundry? Excessive weight will keep the lid from unlocking.
Similar Questions
Whirlpool Wfw9150ww Error Code F9e1 - Long Drain
I'm getting the F9E1 error code. I've cleaned out the drain to make sure no debris is blocking it an...
I'm getting the F9E1 error code. I've cleaned out the drain to make sure no debris is blocking it an...
(Posted by sconley3 9 years ago)
How Do You Know What The Error Code Is On A Whirlpool Duet Wfw9150ww
(Posted by bobCaroly 10 years ago)
Washer Flashes The Error Code F And Then 51, What This Means?
(Posted by rigolopez123 14 years ago)