Whirlpool WET3300SQ Support Question
Whirlpool WET3300SQ Support Question
Find answers below for this question about Whirlpool WET3300SQ - 27" Stack Washer.Need a Whirlpool WET3300SQ manual? We have 2 online manuals for this item!
Question posted by amirsabiel on April 20th, 2013
What Are The Dimensions Of Whirlpool Wet3300sq2?
What are the dimensions of whirlpool wet3300sq2 ?
Current Answers
Answer #1: Posted by SoCalWoman on April 20th, 2013 11:50 AM
SoCalWoman
Member since:
December 16th, 2012 Points: 2,938,577
Member since:
December 16th, 2012 Points: 2,938,577
Here are the dimensions on a Whirlpool Wet3300sq2:
27" x 32" x 71"
This information is located on Page 3 in the User's Manuel found here: http://www.manualowl.com/m/Whirlpool/WET3300SQ/Manual/260116
Much appreciation to those who acknowledge our members for their contribution toward finding a solution.
~It always seems impossible until it is done~
Nelson Mandela
Related Whirlpool WET3300SQ Manual Pages
User Instructions - Page 1
...Índice / Table des matières
ASSISTANCE OR SERVICE 1 WASHER/DRYER SAFETY 2 WASHER USE 4 DRYER USE 5 WASHER/DRYER CARE 6 TROUBLESHOOTING WASHER 8 TROUBLESHOOTING DRYER 10 WARRANTY 12
AYUDA O SERVICIO TÉCNICO 13...date
Please include a daytime phone number in the U.S.A., or write:
Whirlpool Corporation Customer eXperience Center
553 Benson Road Benton Harbor, MI 49022-2692...
User Instructions - Page 2
.... • Clear the room, building, or area of all safety messages. WARNING
You can be performed by a qualified installer, service agency, or the gas supplier.
2 WASHER/DRYER SAFETY
Your safety and the safety of others .
User Instructions - Page 3
... for 2 weeks or more information. Failure to play on all instructions before using the washer/dryer.
■ Do not place items exposed to dry articles containing foam rubber or ...to the wash water. This will be properly installed and vented to persons when using the washer/dryer, follow these instructions can result in the Installation Instructions. It must be paid installation...
User Instructions - Page 4
...Installation Instructions supplied with gasoline or other fastening devices that are dampened with your washer. LARGE CAPACITY WASHERS
Heavy Work Clothes
2 pair of pants 3 shirts 3 jeans 1 coverall
... 2 slips 4 undergarments 1 set the LOAD SIZE selector to seal all joints. No washer can cause poor cleaning.
2. (OPTIONAL) Add liquid chlorine bleach.
Mix large and small...
User Instructions - Page 5
... ) and pull out the Cycle Control knob. To stop or restart your washer:
■ To stop the washer at any fabric softener onto the clothes.
Failure to the correct setting for ... your model allows fabric softener dispenser usage and for information on ordering, refer to remove. Washer will sound only if the selector is selectable. Softener is added automatically during the rinse portion...
User Instructions - Page 6
...removal, check the exhaust hood and remove the lint.
Cleaning the interior Clean your washer interior by grasping top with both hands and
squeezing, while pushing upward with your ...Cleaning
Style 1: 1. Pull the lint screen straight up on some models): 1. As Needed Cleaning
Laundry detergent and fabric softener residue can increase drying time. Wipe drum thoroughly with hot water. 5. ...
User Instructions - Page 7
...■ Plug in the basket. 4. Failure to mix the antifreeze and water. 4. Unplug washer/dryer or disconnect power. Make sure leveling legs are away. Cleaning should be moved during freezing.... Flush water pipes and hoses. 2. Use masking tape to locate, level and
connect the washer/dryer. 2. Non-use an extension cord. Shut off both water faucets. 2.
WARNING
In ...
User Instructions - Page 8
... humming? Turn the Cycle Control knob to the right slightly and pull to the drainpipe or laundry tub. This is normal.
■ The washer basket moves while washing.
A ³⁄₄" (1.9 cm) piece of each hose. The washer/dryer must be secured to start.
Some cycles feature periods of a service call an electrician...
User Instructions - Page 9
... should move freely during operation. See "Connect Inlet Hoses."
■ Are you unload the washer promptly?
Clothes should be correct for washing heavy soils in the pockets?
■ Is your...drain hose fit too tightly in suspension. Do not seal the drain hose with the lid open ? Washer won't drain or spin; See the Installation Instructions.
■ Is the lid open .
■...
User Instructions - Page 10
... clip caught between the drum and front or rear of the bleach dispenser when loading and unloading the washer (on the supply line? Wipe up ? Do not use 2 fuses or circuit breakers. Dryer Operation...may be balanced and not overloaded. The wash load must be turning, but you overload the washer? There may not have not tripped.
See the Installation Instructions.
■ Is the clothing ...
User Instructions - Page 12
... they are excluded from warranty coverage.
3. This limited warranty applies only when the major appliance is used for units operated outside the United States or Canada.
7. This major appliance is used to build every new WHIRLPOOL® appliance. LIMITATION OF REMEDIES
CUSTOMER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT...
User Instructions - Page 1
...27" (69 CM) ELECTRIC WASHER/DRYER INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACIÓN DE LA LAVADORA/ SECADORA ELÉCTRICA DE 27" (69 CM)
INSTRUCTIONS D'INSTALLATION LAVEUSE/SÉCHEUSE ÉLECTRIQUE DE 27...reduce the chance of Contents / Índice / Table des matières
WASHER/DRYER SAFETY 1
INSTALLATION INSTRUCTIONS 2 Tools and Parts 2 Alternate Parts 2 Location ...
User Instructions - Page 2
... User Instructions.
For information on ordering, please refer to the toll free phone numbers on the front page of the Washer/Dryer User Instructions.
2 If You Have
You Will Need to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
1" (2.5 cm) diameter standpipe
2" (5 cm) diameter to...
User Instructions - Page 3
...Standard for winterizing information. The washer/dryer must conform to support the washer/dryer weight (washer/ dryer, water and load) of an automatic cycle. See "Washer/Dryer Care" in .2 (155 cm2)
1" 27"
1"
1"* 32"
5"**
...3 Failure to water and/or weather.
WARNING
Location Requirements
Washer/Dryer Dimensions
Explosion Hazard
Keep flammable materials and vapors, such as gasoline...
User Instructions - Page 4
... 96" (2.4 m) from the bottom of the standpipe must be no higher than 17 gal. (64 L) per minute. The top of the washer.
39" (99 cm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity.
Connect to the dryer must end in conformance with clothes dryers. If the dryer...
User Instructions - Page 5
...-grounding conductor and a grounding plug. grounding conductor can result in a risk of least resistance for electric current. GROUNDING INSTRUCTIONS
■ For a grounded, cord-connected washer/dryer: This washer/dryer must have a proper outlet installed by direct wire: Power supply cable must be either green or bare.
SAVE THESE INSTRUCTIONS
5 Canada
WARNING
Electrical...
User Instructions - Page 11
...vent system
■ Clean lint from your dealer or by calling Whirlpool Parts and Accessories. If this washer/dryer
MUST BE EXHAUSTED OUTDOORS. For more information, see the "...existing vent system if necessary to follow these instructions can be purchased from the entire length of the Washer/Dryer User Instructions. Elbows 45° elbows provide better airflow than 90° elbows. Do ...
User Instructions - Page 13
... to the water faucets using the new hoses. A. Hose should
be connected to the valves can result. You may need additional parts. Insert a new flat washer into laundry tub or standpipe. A
In Canada
B
A. Hot water inlet valve (bottom)
A
B
A. Complete hookup of the inlet hoses. Replace access panel upon completion of the access...
User Instructions - Page 14
...29" (73.66 cm) mismatch
Part Number 4396014 - 29" (73.66 cm) to the laundry tub leg or standpipe with standard elbows B. See "Remove Shipping Strap." Wrap the drain hose to... rear offset exhaust installation B.
Rigid metal or flexible metal vent C. Elbow F. Move the washer/dryer to its final location and remove any cardboard used to the manufacturer's instructions provided with...
User Instructions - Page 15
...using elbows or making turns, allow as much room as necessary. Tilt the washer/dryer forward until the washer/dryer is in its final location. Connect Vent
1.
Vent system chart
NOTE... 35 ft (10.7 m)
Flexible metal 25 ft (7.6 m) 20 ft (6.1 m)
1
Rigid metal
32 ft (9.7 m) 27 ft (8.2 m)
Flexible metal 21 ft (6.4 m) 16 ft (4.9 m)
2
Rigid metal
24 ft (7.3 m) 19 ft (5.8 m)
Flexible metal...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Vibration - Front-load washer
.../service/modelnumber.jsp','modelnumber',500,480);return false;" href="#"> Lookup Model # FAQs Knowledgebase search tips Sounds during shipping. Front-load washer Sounds during drain - Vibration - Do you operate the washer. Each unit is secured to 3 minutes. During the final spin, higher spin speeds create sounds that are normal for flooring requirements... -
How to remove odors from front-load washer (for washers with stored program for cleaning washer)
... detergent compartment. How to remove odors from front-load washer (for washers with stored program for a moment, then the door will unlock, lock again, and then the cycle will continue. Repeat the cleaning procedure monthly. No laundry products will not completely dissolve in the unit will cause product damage over time. The water in... -
Washer will not start - Duet® Steam washer
... noise, vibration, error codes and possible machine damage. Is the washer door firmly shut? Your washer will start a new cycle. If the door is on . Front-load Duet washer Display shows F22 or FdL - Front-load washer Are you operate the washer. Each unit is started? If the problem continues to continue. Turn off...
Similar Questions
Stackable Washer Dryer 27'
Does the dryer vent from the back or the top?
Does the dryer vent from the back or the top?
(Posted by ChrisMRadke 8 years ago)
How To Replace Lid Switch On Whirlpool Stacked Washer Dryer, Wet3300sq1
(Posted by highgary 9 years ago)
Age Of This Stack Washer Is???
(Posted by PHILJBRO 11 years ago)
Whirlpool Wet3300sq1 Washer/dryer Combo
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
(Posted by emmersonalleyne 12 years ago)
Whirlpool Wet3300sq1 Washer/dryer
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
(Posted by emmersonalleyne 12 years ago)