Troy-Bilt TB625 Support Question
Troy-Bilt TB625 Support Question
Find answers below for this question about Troy-Bilt TB625.Need a Troy-Bilt TB625 manual? We have 1 online manual for this item!
Question posted by Johnterrazas96 on July 2nd, 2020
Replace A Remote Assembly Primer Bulb
The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by waelsaidani1 on July 2nd, 2020 1:33 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,787
Member since:
May 12th, 2013 Points: 19,501,787
Related Troy-Bilt TB625 Manual Pages
Operation Manual - Page 1
... Customer Support Department at the time of printing. When servicing, use only identical replacement parts.
769-08457 / 02
All information, illustrations, and specifications in Canada. Service.../13 Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB625 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 ...
Operation Manual - Page 2
...and proper use of the unit.
• Do not operate this manual. If it requires replacement, ask your careful attention and understanding. Wash hands after handling. Teens must be equipped with...serious injury or death to yourself or to install the Accessory Part #753-08052 Muffler Assembly. The safety symbols, and their explanations, deserve your LOCAL SERVICE DEALER to others.
...
Operation Manual - Page 3
...performed by a authorized service dealer.
• Before inspecting, servicing, cleaning, storing, transporting or replacing any parts on the unit: 1. Make sure all moving parts have stopped. 3. Disconnect the ... for maintenance or repair.
• Use only original equipment manufacturer (OEM) replacement parts and accessories for damage.
WHILE OPERATING
• Wear safety glasses or ...
Operation Manual - Page 4
...OFF or STOP
• PRIMER BULB Push primer bulb, fully and slowly, ...10 times.
• CHOKE CONTROL 1. • FULL choke position 2. • PARTIAL choke position 3. • RUN choke position
• THROWN OBJECTS AND ROTATING CUTTER CAN CAUSE SEVERE INJURY
WARNING: Small objects can be used in serious injury to operator's manual for complete safety, assembly...
Operation Manual - Page 5
... cm)
* All specifications are based on the latest product information available at any time without notice.
5 Shaft Grip
ASSEMBLY TOOLS REQUIRED: • 3/8" Socket
On/Off Switch
Muffler
Spark Plug
Starter Rope Grip
Primer Bulb
Fuel Cap
Handle Shaft Housing
Air Filter Cover
Throttle Control
Choke Lever
Cutting Head
Coupler
Cutting Head Shield
Oil...
Operation Manual - Page 6
... without the cutting head shield in place (Fig. 2). While holding the unit in the handle should be to the type of the shaft grip (Fig. 3).
4.
ASSEMBLY
INSTALLING THE CUTTING HEAD SHIELD
WARNING: To prevent serious personal injury, never
operate the unit without a hole) on the mount bracket into the slot on...
Operation Manual - Page 7
... not tighten the nut (Fig. 5). CAUTION: The release button should be snapped into the primary hole (Fig. 6). Removing the Attachment
1. Turn the knob counterclockwise to assembling the attachment.
1.
Operation Manual - Page 10
... start .
Pull the starter rope with a controlled and steady motion 3 to Position 2 (Fig. 11).
8. Move the choke lever to 8 times. Fig. 9
Throttle Control
Fig. 10
Primer Bulb
Position 3 Position 2 Position 1
Fig. 11
Choke Lever
STOPPING INSTRUCTIONS
1. STARTING AND STOPPING
WARNING: Operate this instruction. Crouch in the ON ( I ) / Start
STARTING INSTRUCTIONS
1. The On...
Operation Manual - Page 11
... the unit for 2-5 minutes, or as needed . Release the throttle control and allow the engine to squeeze the throttle control.
Slowly press and release the primer bulb 10 times (Fig. 10).
4. Insert the electric start accessory into the electric start accessory from the unit.
11. the engine does not start, begin the...
Operation Manual - Page 12
... head on bare ground or hard soil. NOTE: Always keep the trimming line fully extended. CAUTION: Do not remove or alter the line cutting blade
assembly. Line release
becomes more line, lightly tap the bump knob on the ground (Fig. 15) while operating the unit at a 30° angle to the...
Operation Manual - Page 13
...from the cutting head. DO NOT push the bump knob down while winding the line.
NOTE: Maintenance, replacement, or repair of the emission control devices and system may require special tools or skills. Refer to ...never perform
maintenance or repairs while the unit is running.
REPLACING THE TRIMMING LINE
Only use the trimming line described in the table. If necessary, remove any seasonal...
Operation Manual - Page 16
...engine. Grit in . (0.635 mm)
Fig. 26
16 If the spark plug is cracked, fouled or dirty, replace it to reduce the idle speed (Fig. 25). Do not over tighten.
6.
ADJUSTING THE IDLE SPEED
WARNING: ... spark plug with a 5/8-inch socket, turning it from the cylinder head with replacement part #753-05784, a Champion RDZ4H or an equivalent spark plug.
4. Reattach the spark plug boot.
Operation Manual - Page 17
... of any high quality motor oil into an approved container. Remove the spark plug and put 5 drops of the oil from the carburetor.
3. Repair or replace damaged parts and tighten loose screws, nuts or bolts. Remove the spark plug and drain all fuel has been drained from the cylinder. 2. Refer to...
Operation Manual - Page 18
... and clean the cutting head Clean or replace the air filter
Drain the fuel tank and add fresh fuel Clean or replace the air filter Replace the spark plug
Stop the engine and clean the cutting head Refill the cutting head with fresh fuel Press the primer bulb 10 times Drain the fuel tank and...
Operation Manual - Page 20
...improve the design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for products sold or exported... 44136-0019
20 To locate your area, visit our website at its option, repair or replace, free of charge, any kind be accepted unless prior written permission has been extended by ...
Similar Questions
How To Replace Primer Bulb Lines On Tb675ec With A Two Port Primer
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
(Posted by dsnyder488 9 months ago)
How Do I Replace The Primer Bulb On Tb625 Ec
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
(Posted by Myers8708 2 years ago)
Fuel Tank Replacement On A Tb625 Ec
How do I replace the fuel tank on this model
How do I replace the fuel tank on this model
(Posted by axisbuck8point 8 years ago)
Starter Rope Replacement
Can the starter rope be replaced by the owner? I own an older Troybilt trimmer. The starter rope can...
Can the starter rope be replaced by the owner? I own an older Troybilt trimmer. The starter rope can...
(Posted by bluesbox 10 years ago)