Troy-Bilt Colt FT Support Question
Troy-Bilt Colt FT Support Question
Find answers below for this question about Troy-Bilt Colt FT.Need a Troy-Bilt Colt FT manual? We have 1 online manual for this item!
Question posted by davejbolin on May 7th, 2017
Clutch Cable
Clutch cable was not hooked up, and there is no reference to it in the manual. I assume it was supposed to have been hooked u
Current Answers
Answer #1: Posted by Troubleshooter101 on May 7th, 2017 9:22 PM
Troubleshooter101
Member since:
September 30th, 2015 Points: 2,927,030
Member since:
September 30th, 2015 Points: 2,927,030
You need to check here with this service manual
https://www.manualslib.com/manual/591389/Troy-Bilt-Colt-Ft.html?page=7
Thanks
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Troublshooter101
Related Troy-Bilt Colt FT Manual Pages
Operation Manual - Page 1
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Front Tine Tiller - 340 Series
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
BOX 361131 CLEVELAND, OHIO 44136-0019
Form No. 769-08539 (October 15...
Operation Manual - Page 2
... authorized service dealer. Please be sure that you, and any other persons who will be aware that this manual, all references to safely and easily set up and operating your machine, for purchasing a Troy-Bilt Garden Tiller.
If you have any problems or questions concerning the machine, phone a authorized Troy-Bilt service dealer...
Operation Manual - Page 3
... close fitting slacks and shirt. Disengage clutch levers and shift (if provided) into neutral ("N") before filling.
3
HEED ITS WARNING! Keep this manual. Children 14 and over and cause ...if not followed,
could result in the
operator's manual. Failure to operate this machine in a safe place for future and regular reference and for ordering replacement parts.
2.
Never operate ...
Operation Manual - Page 4
...or traffic. If this machine without good visibility or light. Never operate the machine at all clutch levers (if fitted) and stop engine before you .
10. Start the engine according to...
Check bolts and screws for proper tightness at all moving parts have stopped. Always refer to the operator's manual for important details if the machine is hot or running .
20. d.
Never...
Operation Manual - Page 6
..., understand, and follow all instructions in the manual(s) before attempting to assemble and operate
WARNING- Contact with the rotating parts... two minutes before refueling.
Safety Symbols
This page depicts and describes safety symbols that may appear on this manual and on the machine before attempting to assemble and operate.
CARBON MONOXIDE Never run an engine indoors or ...
Operation Manual - Page 7
... 1-1 NOTE: Be sure not to the Engine Operator's Manual for Assembly
• One 1⁄2" open-end wrench • One 3⁄8" open-end wrench • Clean oil funnel • Motor oil.
Recommended Tools for oil
specifications and quantity required.
Identify the forward clutch cable.
Refer to kink cables while attaching.
Step 1 in Figure 1-3.
5. Insert the bolt...
Operation Manual - Page 8
...
Cotter Pin
Figure 1-7
Depth Stake the two screws removed earlier. Insert the carriage screw through the bracket on the Depth Stake refer to the desired height. Select one of this manual. For further instructions on the
handle, bell washer, handle brace and into the frame and reinstall
seen in the welded handle...
Operation Manual - Page 9
...clutch cable to increase or decrease tension on the cable.
8. Read the instructions carefully.
Check again for correct tension on the cable. Cable Collar
Hex Nut
Figure 1-8
3. See Figure 1-8.
5. released - Adjust the forward clutch cable... re-adjust the cables. Gasoline is hot or running. With the forward engagement handle in the separate Engine Operator's Manual packed with your ...
Operation Manual - Page 10
....
Tighten hardware when complete.
10 Controls & Features
4
Handle
Forward Tine Engagement Lever Handle Knob
Depth Stake
Tiller Tines
Engine Controls
See the separate Engine Operator's Manual for seeding. Forward Tine Engagement Lever
The forward tine control lever is located beneath the upper section of the engine controls. Loosen the knob to...
Operation Manual - Page 11
...Be sure no one is standing in this manual before operating. Make sure that wheels are forward (nearest to Back
Place the wheel yoke so that the tine clutch control is running or being started.
1. ... warnings posted on the machine and in front of the tiller while the engine is disengaged and refer to depth stake -
Figure 1-2
Depth Stake
The depth stake acts as a brake for deep ...
Operation Manual - Page 12
... and reduce the forward speed. The tiller is the preparation of lawn area for excavation with the soil in your garden. Handle Pressure
Further control of the tilling depth and travel speed ...The tine width can be free of hard untilled spots, allowing a better stand of the garden alternately.
In growing corn or similar crops, check-row planting will increase the working conditions ...
Operation Manual - Page 13
... & Set-Up section of lubrication.
Cutting Edge Forward
Cotter Pin
Figure 1-1
Outer Tine
Adjustments
Cable Adjustment
Refer to the separate Engine Operator's Manual for instructions on adjusting the forward and reverse cables.
13
Keep the belts free of this manual for engine maintenance instructions. Maintenance & Adjustments
6
WARNING! Disconnect the spark plug wire and ground...
Operation Manual - Page 14
...the tine assembly to the engine manual for correct engine storage instructions.
4. The use of pressure washers will enter the soil first when the tiller moves forward. Refer to the tine shaft using the...spindles, pulleys, bearings or the engine. NOTE: When storing any springs, bearings, and cables. Rear/Operator
Clevis Pin
Front/Forward
Rotation
Off-Season Storage
If the tiller will not be...
Operation Manual - Page 15
...
Figure 1-2
Engine Pulley
Idler Pulley
Transmission Pulley
Figure 1-4
NOTE: Upon reassembly, make certain that the idler pulley keeper is as shown in reverse order and refer to Figure 1-4. Remove the belt.
6. See Figure 1-3. Disconnect and ground the spark plug wire against the engine.
2. Remove the belt cover from under the idler...
Operation Manual - Page 16
Foreign object lodged in correct adjustment 4. Control cable not adjusted properly 3. Replace tine clevis pin(s) 3. Take tiller to authorized... do not engage
Cause
1. Clevis pin missing 2. Belt worn and/or stretched
Remedy
1. Dislodge foreign object 2. Control cable not adjusted properly 5. Forward rotation should only be used on soil
that has already been tilled, not on virgin soil...
Operation Manual - Page 17
Parts Manual downloads are also available free of charge at www.troybilt.com.
17 Replacement Parts
Component
9
Part Number and ... Right Hand Tine
714-04043 911-0415
Cotter Pin Clevis Pin
954-0428
Drive Belt
946-0918
Forward Cable
734-04538
Wheels, 8 x 1.75
Phone (800) 828-5500 to order replacement parts or a complete Parts Manual (have your full model number and serial number ready).
Operation Manual - Page 18
... may carry a separate manufacturer's warranty. You assume the risk and liability for loss, damage, ... as set forth in this manual will , at www.troybilt....blade sharpening, tune-ups, brake adjustments, clutch adjustments, deck adjustments, and normal deterioration ...lawn care services or for rental expenses to anyone other express warranty, whether written or oral, except as identified. Refer...
Similar Questions
Is The Throttle Cable Adjustable On The Troy Bilt Tb225 Tiller? Also What Would
is the throttle cable adustable on the tb225 tiller and also what would make the fuel not stay in th...
is the throttle cable adustable on the tb225 tiller and also what would make the fuel not stay in th...
(Posted by tw285j 1 year ago)
How To Remove Clutch Housing From The Engine When Replacing The Pull Start Assem
How do you remove the clutch and housing assembly from the starting assembly to change out a new sta...
How do you remove the clutch and housing assembly from the starting assembly to change out a new sta...
(Posted by psottak 3 years ago)
What Is The Spark Plug Gap Setting For The Troy Biltolt Ft?
what is the correct spark plug gap for the Troy Bolt colt FT?
what is the correct spark plug gap for the Troy Bolt colt FT?
(Posted by Anonymous-165415 5 years ago)
Colt Ft Will Fire But Not Stay Running
it is brand new only used 3 times, fresh gas cleaned carb, will start off starter fluid but immediat...
it is brand new only used 3 times, fresh gas cleaned carb, will start off starter fluid but immediat...
(Posted by Anonymous-150145 9 years ago)
