1997 Toyota Corolla Support Question
1997 Toyota Corolla Support Question
Find answers below for this question about 1997 Toyota Corolla.Need a 1997 Toyota Corolla manual? We have 2 online manuals for this item!
Current Answers
Answer #1: Posted by Nmdreamwriter on June 4th, 2022 8:05 AM
Nmdreamwriter
Member since:
May 29th, 2022 Points: 3,980
Member since:
May 29th, 2022 Points: 3,980
The most common cause of faulty temperature readings is a broken coolant temperature sensor (CTS). The part, which is normally located near a vehicle's thermostat near the base of the radiator (consult your owner's manual or repair guide) can get gunked up and fail.
If the amp in question is a car amp, the most likely cause is a faulty remote turn-on wire. If there's a problem with this wire or if it's hooked up incorrectly, you're not going to get any power to your amplifier. Other causes include: A broken or loose power wire.
How fix it?
Continue Troubleshooting
- Turn the ignition switch Off.
- Unplug the sending unit electrical connector and turn the ignition switch On. Whether the engine is warmed up or cool, the gauge should read cold.
- Ground the sending unit (signal) wire using a jumper wire. Turn the ignition switch On.
- How do I know if my temperature sensor is working?
- How to test a faulty thermocouple or resistance thermometer?
- Check if the -ve and +ve leads swapped.
- Check for any thermocouple cable wiring issues.
- Check for local heat source issues.
- Check Temperature Transmitter Settings.
- Check temperature controller settings.
- Troubleshooting temperature sensors with a multimeter.
Madushan
Related Manual Pages
Owners Manual - Page 7
... Side doors Power windows Trunk lid Back door Hood Theft deterrent system Fuel tank cap Electric sun roof
Keys
The master key works in the trunk. The subkey will not work in every lock. Keep the key number plate in a safe place such as your wallet, not in the trunk when you...
Owners Manual - Page 16
... indications. You need the key to wait until the indicator light starts flashing. 3. Be sure to open flames when refuelling. If the system does not work properly, have it checked by spraying out of the filler neck if the cap is set when the time comes. FLASHING-The system is suddenly...
Owners Manual - Page 29
... preventing or reduce injury by the seat belts. The passenger airbag is activated even with the seat belts to a severe frontal impact, the SRS airbags work together with no passenger in order to the "ACC" or "ON" position.
Owners Manual - Page 34
... System) airbag is turned to inform the driver of operating problems. If either of the airbags.
In response to a severe frontal impact, the SRS airbag works together with the seat belt to help preventing or reduce injury by the seat belt.
S The light comes on when the ignition key is designed...
Owners Manual - Page 57
... seat, press the buckle−release button and allow the belt to the child.
56 The belt will move freely again and be ready to work for installing of the passenger airbag can cause death or serious injury to retract completely. CAUTION
S Vehicles with a passenger airbag: Never put a rear−facing...
Owners Manual - Page 60
... pulling it in forward−facing position only.
59 To remove the convertible seat, press the buckle−release button and allow the belt to work for an adult or older child passenger.
(C)BOOSTER SEAT INSTALLATION A booster seat is used in different directions. Also make sure the child restraint system is...
Owners Manual - Page 68
...it there. The turn , but after a lane change by hand. The headlight flasher works even when the headlight switch is self−cancelling after a turn signal light switch ... the emergency flashers to cancel it indicates that the front or rear turn signal lights will not work when the emergency flashers are operating.
66
For signaling turns, move the lever up or down in...
Owners Manual - Page 70
... weather, warm the windshield with the defroster before using the washer. To turn it off, push the switch once again. If the washer does not work, check to see 'Adding washer fluid" in the "INT" position.
The wipers will help prevent icing, which could block your vision.
68 The key must...
Owners Manual - Page 71
...position. Also, the wipers will operate at intervals of the lever. If the washer does not work , check to the "MIST" position and release it. This will help prevent icing, which...vision. Windshield wipers and washer (intermittent type with interval adjuster)
If the washer does not work , check to 10 seconds depending on the interval adjuster setting between "S" and "F". NOTICE Do...
Owners Manual - Page 73
... in the tank. The indicator lamp goes off , contact your Toyota dealer as soon as possible. The gauge works when the ignition switch is completely empty, the malfunction indicator lamp comes on.
This fuel gauge has a non−return type needle which remains at the last indicated position when the ignition switch is...
Owners Manual - Page 74
Engine coolant temperature gauge
Tachometer
The gauge indicates the engine coolant temperature when the ignition switch is on a hot day. Your vehicle may overheat during severe operating conditions, such as this may ...
Owners Manual - Page 76
... if the engine drive belt is broken or loose. (d) Low Oil Pressure Warning Light This light warns that the brakes still work adequately, drive cautiously to your Toyota dealer. (b) Seat Belt Reminder Light and Buzzer Once the ignition key is turned to "... functions: Parking brake reminder If this light comes on and stays on while you are not working, have the vehicle towed in for one block.
Owners Manual - Page 77
... off ), the brake system operates conventionally but anti−lock brake system is not assisting brake performance so that there is completely empty. (See "Fuel gauge" in the following conditions occurs, this indicates a malfunction somewhere in the parts monitored by the warning light system. If the light comes on while you...
Owners Manual - Page 132
... when parking. Therefore, compensate for being passed by making a turn off the road and stop in first or reverse (manual). If the engine coolant termperatue gauge indicates overheating, immediately turn . Refer to sway. With the transmission in Part 4 of control.
130 Apply the parking brake firmly. Apply the parking brake frimly...
Owners Manual - Page 139
... . 3. Put the transmission in "P" (automatic) or neutral (manual) and apply the parking brake. If it checked as soon as possible at your engine coolant temperature gauge indicates overheating, if you experience a loss of very high pressure.
137 If necessary, bring it about half full.
! CAUTION
When the engine is O.K. If the...
Owners Manual - Page 158
...under warranty, your Toyota dealer will promptly take your vehicle to your vehicle, rather than while they work on your Toyota dealer or a qualified service shop immediately. See Chapter 7−2 for the details.... maintenance can be performed from time to work on Toyotas before they are working on it . Listed below should arise with a gauge every two weeks, or at least once a month.
Owners Manual - Page 175
... also given in Part 8. If a tire frequently needs refilling, have new ones put on the tire pressure label inside the glovebox. S Always use a tire pressure gauge. The smaller tire size can be checked only when the tires are even just a few pounds off can cause poor sealing of the tread bead...
Owners Manual - Page 197
...0.014) Spark plug type: NIPPONDENSO K16R−U NGK BBKR5EYA Spark plug gap, mm (in.): 1.8 (0.031) Drive belt tension measured with Borroughs drive belt tension gauge No. Recommended oil viscosity (SAE):
COOLING SYSTEM Total capacity, L (qt., Imp. qt.): Manual Transmission 6.0 (6.3, 5.3) Automatic transmission 5.9 (6.2, 5.2)
194
Owners Manual - Page 200
....ALT−S 7.5 A: Charging system 21.EFI, F−HTR 15 A: Multiport fuel injection system/sequential multiport fuel injection system, electronically controlled automatic transmission system
197 GAUGE 10 A: Gauges and meters, service reminder indicators (except discharge and open door warning light, radio, cassette tape player, anti−lock brake system, theft deterrent system, electric...
Owners Manual - Page 201
AM1 40 A: "CIG & RADIO", "GAUGE", "TURN", "ECU−IG", "WIP", "DEF" and "OBD" fuses 36. HEAD (RH−LWR) 10 A: Right−hand headlight (low beam) 27. OBD 7.5 A: On−...
Similar Questions
My Wipers Is Not Working Automatically With Washing Front Glass Option
My wipers is not working automatically with washing front glass option
My wipers is not working automatically with washing front glass option
(Posted by hazemgncrb2000 9 years ago)
Where Is Temperature And Gas Gauge Is Located In Fuse Box In 98 Corolla
(Posted by lizatal 9 years ago)
2009 Corolla Le, Dash, Radio And Shift Lights Won't Work- Fuses Not Blown.
None of the fuses are blown but the dash, radio, shift lights aren't working. Any suggestions?
None of the fuses are blown but the dash, radio, shift lights aren't working. Any suggestions?
(Posted by Tannielve 10 years ago)
Buzzer For Lights Not Working When Door Is Opened
(Posted by patfinglas 11 years ago)
What Does This Blinking Sign Mean (!) On The Dash Next To To The Gas Gauge
tth
tth
(Posted by playboikeaz 11 years ago)