Toro 20351 Support Question
Toro 20351 Support Question
Find answers below for this question about Toro 20351 - High Wheel CARB Walk Power Mower.Need a Toro 20351 manual? We have 3 online manuals for this item!
Current Answers
Answer #1: Posted by TommyKervz on September 13th, 2014 2:16 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,843
Member since:
January 10th, 2013 Points: 17,776,843
download manual below for free and read page 9
Related Toro 20351 Manual Pages
Operation Manual - Page 1
....com. This spark ignition system complies with a spark arrester muffler. 22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up Model No. 20334-Serial No. 312000001... precautions. Figure 1 1.
This rotary-blade, walk-behind lawn mower is not designed for cutting brush or for cutting grass on well-maintained lawns on residential properties. You are available from this...
Operation Manual - Page 2
... or while wearing sandals. Safety
This lawn mower meets or exceeds the CPSC blade safety requirements for proper operation and installation of accessories. Always look down . walk; Vibration is generally a warning of ... models with SAE J1940.
Read and understand the contents of this class of lawn mower will be sure of your footing or balance.
2
Exercise extreme caution when ...
Operation Manual - Page 9
...mower comes from the lawn.
If it (refer to be thrown in the operator's or bystander's direction and result in serious personal injury.
Figure 13
WARNING
A worn grass bag could allow the mower to disengage the wheel... bar, both the engine and blade should stop walking, hold up the rear deflector (Figure 14).
9 Note: If the mower does not freely roll backward after several attempts, ...
Operation Manual - Page 12
...deliberately mow over any object.
• If the mower strikes an object or starts to Adjusting the Cutting Height.
• When cutting grass ...mower free of leaves on the front wheels one or two notches higher than the rear wheels. Walk at the highest cutting height setting and walk...cutting height on the lawn, set the front wheels at 2-1/8-inch (54 mm) and the rear wheels at a time....
Operation Manual - Page 20
... blade sharpening or worn blades, cable/linkage adjustments, or brake and clutch adjustments
• Any product or part which vary... Items and Conditions Not Covered
There is covered under "Lawn Mowers") or access our web site at Toro Warranty Company.... Use)
22 in Recycler® 20 in Mulcher/Bagger
Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate...
Quality Guide - Page 3
... 4-2 Measuring Blade Level 4-3 Checking and Adjusting Blade Tracking 4-4 Walk Behind Mowers 4-4 Riding Mowers 4-4 Adjusting Blade Level 4-4 Walk Behind Mowers 4-4
Specifications and Tolerances 4-4 Adjusting Height of Cut 4-5
Models with Height of Cut Lever on Each Wheel 4-5 Mechanism Descriptions 4-5 Slipping Height of Cut Adjuster 4-5 Wheel Does Not Touch Ground 4-6
Service Dealer...
Quality Guide - Page 9
...RPM during engine break-in . Set the engine RPM so that all mowers, proper mower setup consists of doing the following and make sure they happen. Blade is checked, sometimes no -load RPM.
It also describes the elements mower preparation, lawn... cycle).
3. Make sure the wheels roll true and the control cables...use the mower safely to Great Quality of cut (HOC) adjusting mechanism moves...
Quality Guide - Page 10
... affect the quality of cut by the blade. Remind the operator that tipping a walk behind mower the wrong way to dry the grass.
• Clear the area of the ... Instruction
Even experienced operators should review before operating the mower. Explain that the operator's manual contains safety information about the mower, lawn preparation, operator dress and condition, and mowing procedures....
Quality Guide - Page 13
...
3 - 1 An adjustable wrench can easily open and slip.
5. Blade bolt 2. Spindle shaft
1.
Note: For best performance, install a new blade before the cutting season begins. Loosen the blade fastener(s).
Always use the proper size wrench to remove, inspect, sharpen, balance, and install a blade. Grasp the end of blade. Accelerator
Figure 4
4. Walk behind mowers, while...
Quality Guide - Page 15
... Bolt (Nut) Torque Guide for damage and replace if warranted. Some common Toro, Toro Wheel Horse, and Lawn-Boy torque values are shown in 2002
Model
Lawn-Boy 21-inch walk behind
mowers
Toro 21-inch and 22-inch walk behind mowers with use. The patch will wear out with domed or flat washer on blade bolt...
Quality Guide - Page 17
...: Riding Mowers and subsections specific to adjusting your model
Walk Behind Mower Overview
The method for checking and adjusting blade tracking is the same for checking and adjusting blade level are three height of Cut
4 - 1
There are common to all walk behind mowers and riding mowers. If you have a walk behind mowers.
Cast deck models (Toro Super Recycler and Lawn-Boy Gold...
Quality Guide - Page 20
... of Cut Make a mark in everything including wheels and pivot arms make the blade pitch specification approximate. engine or spindle and the housing. Check for common measurements. Figure 17
MVC-729X.JPG
6. The difference between the
Adjusting Blade Level
Walk Behind Mowers
Specifications and Tolerances
On walk behind mowers the blade should not be level front...
Quality Guide - Page 21
...Each Wheel
Mechanism Descriptions
Toro and Lawn-Boy have similar systems for individual wheel adjusters.
...Note: These kits do not fit any Vacu-Power, Commercial (Pro Line), or Landscaper models.
...adjusters on a given mower determine the procedures to engage a notch is molded in adjusting the height of Cut Lever on these models. However, there are the same for all walk behind mowers...
Quality Guide - Page 22
.... Use a round file to elongate the pivot bolt hole excessively.
When you can correct the problem by lowering one of the wheels does not touch the ground on a walk behind mower is on the low side of Cut Adjuster" on cast decks files away quickly. Re-measure the blade. Figure 22
2001-065.TIF...
Quality Guide - Page 37
... left-hand and right-hand cams down to raise the front of the mower, or up to take pressure off the adjustment cams. Stop the engine and remove the key.
2. To raise the ...front of Tractor Shown
5XI_tran.TIF
1. Figure 68 Right Side of the mower, turn the adjusting nut on the gage wheels as necessary. Adjusting Transport Blade Pitch
Because the attachment lift is used when the PTO drive ...
Quality Guide - Page 42
...blade stiffener as clumping. The lawn may cause excessive turbulence.
3. Adjust anti-scalp devices.
5. On multi-blade mowers, verify all mowers require this manual for the ...high spots.
2. Try making them too short.
5 - 2
Service Dealer's Guide to Great Quality of cut.
4.
Remove the weeds from the lawn or improve the grass stand in direct relation to the speed. Adjust gage wheels...
Quality Guide - Page 45
... Improve Quality of Cut
This section describes special kits developed to help resolve various quality of cut issues. Note: These kits do not fit Vacu-Power, Landscaper, or commercial walk behind mowers.
Quality Guide - Page 47
...Anti-scalp wheel-a wheel that contacts the ground only momentarily to prevent scalping when a mower encounters a high spot or crest in a hopper or bag. Anti-scalp wheels cannot prevent all rotary mowers and ...some mulching mowers. Bagging mower-a type of mower that collects the grass clippings in the lawn.
This flow of the blade. Air is the movement of air created by the mower blade.
...
Quality Guide - Page 49
...adjusting the mowing deck so that mulch.
The gage wheel is cut, or from the mower.
This term may be the same).
Engine RPM...lawn.
This term is watered heavily. Floating deck-a mower that is used to describe mowers...mower, usually when a mower is running. gagewh.TIF
Ground speed-the rate at which the mower travels across the ground.
Lush grass-grass with a high...
Quality Guide - Page 55
... walk behind mowers approximately 3/8 inch low in working order? Service/Check/Adjust-in balance? C. D. PTO/belt drive/spindles in front.)
5. I. Mowing speed suits conditions? On riding mowers ... not aligned with adjustable pitch, raise the front to rear? (Most tractors 1/8 inch low in working order? B. E. Engine maximum RPM to side with 1/8 inch? Mower level side to ...
Similar Questions
Lawn Mower Wont Start After Three Cuts
(Posted by luvde 9 years ago)
Lawn Mower Does Not Work
(Posted by thdraco0 9 years ago)
Carb Clean On Toro Lawn Mower But Still Wont Stay Running
(Posted by cwerSpark 10 years ago)
I Have New Toro 22' High Wheel Recycler Mower Mdl 20331. I Ned Instruction Manua
I bought this Toro 20331 "as is"put together & brand new from Home Depot. They said they did not...
I bought this Toro 20331 "as is"put together & brand new from Home Depot. They said they did not...
(Posted by 0431mam 11 years ago)
How Do I Replace The Grass Bad On A Toro 20023 Recyclerpower Mower?
(Posted by tadillon 11 years ago)