TP-Link TL-WR740N Support Question
TP-Link TL-WR740N Support Question
Find answers below for this question about TP-Link TL-WR740N - 150Mbps Wireless Lite N Router IEEE 802.11n 802.11g 802.11b Built-in.Need a TP-Link TL-WR740N manual? We have 1 online manual for this item!
Question posted by hashambinfarooq on February 24th, 2012
How Do I Apply A Password On My Tp Linknwireless Router Tl Wr740n
how do i apply a password on my TP Link wireless router TL WR740N, so that others cannot use it.
Current Answers
Related TP-Link TL-WR740N Manual Pages
User Guide - Page 4
...responsible for marking this declaration:
Yang Hongliang Product Manager of International Business
TP-LINK TECHNOLOGIES CO., LTD. China R. TP-LINK TECHNOLOGIES CO., LTD
DECLARATION OF CONFORMITY
For the following equipment: Product Description: 150Mbps Wireless N Router Model No.: TL-WR740N/TL-WR741ND Trademark: TP-LINK We declare under our own responsibility that the above products satisfy all...
User Guide - Page 9
... staff. PSK), as well as advanced Firewall protections, the TL-WR740N/TL-WR741ND 150Mbps Wireless N Router provides complete data privacy.
Introduction
Thank you for handling multiple data streams at the same time, which can manage and monitor the network in this guide to know all IEEE 802.11g and IEEE 802.11b products. The speed makes it is supported and detailed instructions...
User Guide - Page 10
...Wireless N Router
1.2 Conventions
The Router or TL-WR740N/TL-WR741ND mentioned in this guide stands for TL-WR740N/TL-WR741ND 150Mbps Wireless N Router without any explanation.
) Note:
The two devices of TL-WR740N and TL-WR741ND are : ¾ TL-WR740N Router with one fixed antennas. ¾ TL-WR741ND Router with one detachable antenna.
1.3 Main Features
¾ Make use of IEEE 802.11n wireless...Built...
User Guide - Page 12
...;
There are two ways to reset to the Router's factory defaults: 1) Use the Factory Defaults function on "System Tools → Factory Defaults" page in the
Router's Web-based Utility. 2) Use the Factory Default Reset button: With the Router powered on, use the
power adapter provided with this TL-WR740N/TL-WR741ND 150Mbps Wireless N Router. ¾ ON/OFF: The switch for the power...
User Guide - Page 13
... or heating vent ¾ Avoid direct irradiation of the antenna. Connect the power adapter to use the wireless function, you can skip this step.) 5. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Chapter 2. If there is
connected directly to the following steps. Connecting the Router
2.1 System Requirements
¾ Broadband Internet Access Service (DSL/Cable/Ethernet) ¾ One DSL/Cable Modem...
User Guide - Page 15
...2) Then the built-in Windows 2000 OS. Connect the local PC to 254), Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.1 (The Router's default IP ...TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Chapter 3. The IP address is 192.168.1.x ("x" is any number from 2 to the LAN ports of the TL-WR741ND 150Mbps Wireless N Router is in DHCP server will show you how to do this guide, we use...
User Guide - Page 17
...Quick Setup menu to a proxy.
Is the TCP/IP configuration for the User Name and Password, both in the address field of 192.168.1.2 ~ 192.168.1.254.
3.2 Quick ... must be used on any Windows, Macintosh or UNIX OS with a Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari. 1. Enter admin for your
- 10 - TL-WR740N/TL-WR741ND 150Mbps Wireless N Router 2.
User Guide - Page 18
... sure of what kind of the Auto-Detect function. The appropriate configuration page will appear as shown in Figure 3-6.
If you make use of connection type your ISP provides. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Figure 3-5 Quick Setup 3. Make sure the cable is PPPoE, the next screen will be displayed when an active Internet service is...
User Guide - Page 19
... the box if required. ¾ Primary DNS - Enter the User Name and Password provided by external users on with this field. 5. Enter the gateway IP address... is used for the WAN IP address, it into the field. ¾ Subnet Mask - If your ISP. 2) If the connection type detected is usually
255.255.255.0. ¾ Default Gateway - TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Figure ...
User Guide - Page 20
...If your country or region is automatic, which the Router works on. ¾ Channel Width - TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Figure 3-9 Quick Setup - It may be used . The default setting is not listed, please ...wireless mode which can be illegal to all wireless devices in a region other than one of SSID (Service Set
Identification) must be used . It is set to be TP...
User Guide - Page 21
... sensitive, this means that you chose this
field. ¾ Disable Security - z PSK Password - You can limit the maximum transmission rate of any numbers 0 to 9 and any numbers...related wireless security settings. ¾ No Change -
Finish If there are only for basic wireless parameters. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router ¾ Max Tx Rate - If
disabled, the wireless ...
User Guide - Page 25
... Setup) function.
Click this
button. The current value of the Router.
- 18 - For the configuration of the new device, here takes the Wireless Adapter of the
Router can get a new random value for example. The default PIN of our company for the Router's
PIN. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
4.4 QSS
This section will see the next screen (shown...
User Guide - Page 32
TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Figure 4-6 LAN ¾ MAC Address - Normally use the new IP Address to log in the Router. 2. You can see the page as the subnet mask.
) Note:
1. The physical address of your Router...: 192.168.1.1). ¾ Subnet Mask - If the new LAN IP Address you must use
255.255.255.0 as follows (Figure 4-7):
- 25 - If your ISP. The value can...
User Guide - Page 33
... is likely that you change the default MTU Size unless required by your ISP. ¾ Use These DNS Servers - You should contact your ISP gives you go to release the IP parameters...the Release button to a website after entering the DNS addresses, it is 1500 Bytes. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Figure 4-7 WAN - It is not recommended that your ISP. Dynamic IP This page ...
User Guide - Page 35
... case-sensitive. ¾ Secondary Connection - z Dynamic IP - TL-WR740N/TL-WR741ND 150Mbps Wireless N Router 3. In this secondary connection. PPPoE ¾ User Name/Password - z Disabled - z Static IP - And you want
-... Otherwise, enter the number of minutes you can check this radio button to use Static IP as Dynamic/Static IP to connect to a local area network, ...
User Guide - Page 37
...box and enter the IP address provided by your ISP does not automatically assign DNS addresses to the Router during login, please click "Use the following parameters (Figure 4-11):
- 30 - If your ISP. ¾ Service Name/... The default value is necessary for your ISP's primary DNS server. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Figure 4-10 PPPoE Advanced Settings ¾ MTU Size -
User Guide - Page 44
... button, then the Note Dialog appears. TL-WR740N/TL-WR741ND wireless network on this field. For example, TEST is case-sensitive. Click OK.
Considering your region from the pull-down list. When you select your network. The same name of up to all wireless devices in this page.
150Mbps Wireless N Router
Figure 4-16 Wireless Settings ¾ SSID - Enter a value...
User Guide - Page 91
...202.108.22.5) or Domain name (such as http://www.tp-link.com). ¾ Pings Count - The max number of ...used for Ping function. The size of diagnosis. If there is no reply in the specified time, the connection is fine.
) Note:
Figure 4-74 Diagnostic Results
Only one time. If the result is similar to check the connectivity of the Internet. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router...
User Guide - Page 92
... from the TP-LINK website
(http://www.tp-link.com). 2. Click the Upgrade button.
) Note:
1. TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Figure 4-75...Router rather than the configuration, you can be damaged.
4. To upgrade the Router's firmware, follow these instructions below: 1. When you upgrade the Router's firmware, you want to use. There is being upgraded, otherwise, the Router...
User Guide - Page 109
... assigning a fixed host and domain name to the Internet over an always-on the Internet.
¾ DSL (Digital Subscriber Line) - PPPoE is a protocol for security. 802.11b networks are connected to Point Protocol over existing traditional phone lines.
¾ ISP (Internet Service Provider) - TL-WR740N/TL-WR741ND 150Mbps Wireless N Router
Appendix D: Glossary
¾ 802.11b -
Similar Questions
Tp-link Modem Ruter Td-w8901 Instalations Bedienungsanleitung
bitte! kann Ich Instalations+bedienungsanleitung Für Modem-ruter "tp-link Td-w8901g"(im Deutsch...
bitte! kann Ich Instalations+bedienungsanleitung Für Modem-ruter "tp-link Td-w8901g"(im Deutsch...
(Posted by tomicslavko 10 years ago)
Driver Tp-link Tl-wn353bg Para So Linux Fedora
Necesito Urgente Driver Tp-link Tl-wn353bg Para So Linux Fedora
Necesito Urgente Driver Tp-link Tl-wn353bg Para So Linux Fedora
(Posted by miranda222 11 years ago)