Sony MP-CL1A Support Question
Find answers below for this question about Sony MP-CL1A.Need a Sony MP-CL1A manual? We have 2 online manuals for this item!
Question posted by Allensalazar122117 on July 17th, 2023
Keep Blinking And Stock With The Sony Logo When I Start
Current Answers
Answer #1: Posted by SonuKumar on July 17th, 2023 9:14 AM
If you have recently reset your projector, it is possible that the firmware update was not completed properly. In this case, you can try to reset the projector again. To do this, follow these steps:
- Turn off the projector.
- Press and hold the power button for about 10 seconds.
- The projector will turn on and then off again.
- The projector will then start up in recovery mode.
- Follow the on-screen instructions to reset the projector.
If resetting the projector does not fix the problem, then you may need to take it to a repair shop. A qualified technician will be able to diagnose the problem and repair the projector.
Here are some additional troubleshooting tips:
- Make sure that the projector is properly plugged in and that the power cord is not damaged.
- Try a different power outlet.
- Clear the projector's cache and data.
- Perform a factory reset.
If you have tried all of these troubleshooting tips and the projector is still not working, then you will need to take it to a repair shop.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by HelpHero on July 17th, 2023 8:31 AM
1. Power off your Sony mobile projector completely and unplug it from any power source.
2. Hold down the power button for about 30 seconds to drain any residual power.
3. Plug the device back in and try turning it on again. If it's still stuck at the logo screen, move on to the next step.
4. Locate the reset hole/button on your device. It's usually a small hole that requires a pin or needle to press it. Refer to the user manual to find its exact location.
5. Use a pin or needle to press and hold the reset button for around 10-15 seconds.
6. After releasing the reset button, plug the device back in and attempt to power it on again. If these steps don't resolve the issue, you may need to consider bringing it to a repair shop. They have the expertise to diagnose and fix hardware issues, which could be causing the problem.
Remember, it's always a good idea to back up any important data on your device before taking it for repair, just to be safe.
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers.
Helphero
Related Sony MP-CL1A Manual Pages
Similar Questions
Sony VPL-DX100 projector red light blinking first focus coming after 20 second focus off than red li...
When I switch on the Sony Model Number: VPL-ES7 DATA PROJECTOR, it starts well, but it immediately s...
would this have anything to do with the lamp or is it likely to be something else
My Sony VPL-ES7 Projector starts nomally. Then after about 1 minute it just goes off without any sig...