Poulan C20H42YT Support Question
Poulan C20H42YT Support Question
Find answers below for this question about Poulan C20H42YT.Need a Poulan C20H42YT manual? We have 1 online manual for this item!
Question posted by femamax on July 19th, 2015
How Do I Place Freewheel Control In â??engagedâ?? Position
Was mowing and it just stopped while backing up, won't go forward or backward at this time
Current Answers
Answer #1: Posted by TommyKervz on July 20th, 2015 6:33 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Either the drive belt or the tension spring is broken/loose. Have the drive belt checked' it will not move if it came off one of the pulleys.
Related Poulan C20H42YT Manual Pages
User Manual - Page 2
...mow...mow ...control of riding mower-related injuries. Avoid
on all instructions on wet grass. Ma-
• Do not mow...devices in place and ...place wire where it . Tires may ricochet back toward anyone enters the area. • Never carry passengers. • Do not mow in the manual before and while backing.
• Avoid starting, stopping...slope. Stop the... stop ...not mowing. .... Stop machine...
User Manual - Page 3
...times until fueling is complete.
GENERAL SERVICE • Never operate machine in the mowing area for another ride and be run over or backed over by the machine. • Never allow children to stop...cigarettes, cigars, pipes, and other sources of control.
• Travel slowly and allow children or ...to the machine and the mowing activity. Always place containers on the ground away ...
User Manual - Page 5
... all accessible loose parts and parts cartons
from the skid. eration section for location and function of
controls)
• Raise attachment lift lever to its highest position.
• Release parking brake by depressing brake pedal.
•
5
Place freewheel control in the Operation section of other people and objects.
03037
FIG. 1
TO ROLL TRACTOR OFF SKID...
User Manual - Page 6
... (slow) position. • Release parking brake. • Slowly depress forward drive pedal ...front-to "STOP" position.
Continue with gasoline. • Place freewheel control in "transmission engaged"
position (see "...position, depress brake pedal and set parking brake. • Turn ignition key to -rear for best cutting results. (Tires must be properly inflated for the first time...
User Manual - Page 7
... OFF REVERSE OPERATION
SYSTEM (ROS)
ENGINE ON
ENGINE START
PARKING BRAKE
MOWER HEIGHT
MOWER LIFT
LIGHTS ON FUEL BATTERY
REVERSE
FORWARD
CRUISE CONTROL
CLUTCH/BRAKE PEDAL
15
15
ATTACHMENT
ATTACHMENT
CLUTCH DISENGAGED CLUTCH ENGAGED
DANGER, KEEP HANDS AND FEET AWAY
KEEP AREA CLEAR
SLOPE HAZARDS
(SEE SAFETY RULES SECTION)
FREE WHEEL (Automatic Models...
User Manual - Page 8
... this manual for starting and stopping
gine.
Turns the headlights on and off .
Used to engage
(M) FREEWHEEL CONTROL - service is required for
the mower blades, or other attachments mounted to your
pushing or slowly towing the tractor with the locations of mower or other attachments mounted to set forward movement of the American National Standards...
User Manual - Page 9
...; Turn ignition key (F) to disengage. IMPORTANT: Leaving the ignition switch in severe eye damage.
FIG. 5
( ) Attachment
Clutch Engage Position
( ) Disengaged
Position
GROUND DRIVE • To stop engine when stopping tractor on grass areas.
Slowly push
knob in brake position. TO MOVE FORWARD AND BACKWARD (See Fig. 7)
The direction and speed of movement is depressed.
9
User Manual - Page 10
... gauge wheel in place.
the second to help prevent scalping in proper position to desired height. JUST MOWER CUTTING HEIGHT" in this section of manual). • With mower in desired height of grass being mowed. • The average lawn should be used while mowing or transporting on forward drive pedal.
To disengage the cruise control, depress the brake...
User Manual - Page 11
... in freewheeling position. WARNING: Backing up with the attachment clutch engaged while mowing is not running , turn the ignition key clockwise to engine "ON" position.
Use...engaged. NOTE: To protect hood from the factory, already filled with summer weight oil. • Check engine oil with the ground and cause you are recommended by placing freewheel control in the "STOP" position...
User Manual - Page 12
...to run roughly, pull the choke control out slightly for the first time or if the engine has run ...If the engine starts to push the control in the transmission engaged
position.
• Sit on the temperature..., depending on seat in operating position, depress brake pedal and set .
• Disengage transmission by placing freewheel control in freewheeling position (See "TO TRANSPORT" in...
User Manual - Page 13
.... off engine and set parking brake.
• Engage transmission by placing freewheel control in engaged position (See "TO TRANSPORT" in this manual.
• The left hand turns until finished (See Fig. 12).
This will result in the tractor seat, start by selecting a low enough gear to assure better mowing performance and proper discharge of clippings and...
User Manual - Page 15
... surface, then brake must align with the ignition switch in
the engine "ON" position and the attachment clutch engaged, any attempt by the operator to leave the seat should shut off the engine.... and the attachment clutch control is in the Service and Adjustments section of your warranty. BRAKE OPERATION
If tractor requires more than five (5) feet to stop at highest speed in highest...
User Manual - Page 16
... high pressure sprayer to slip from overheating.
OIL DRAIN VALVE
CLOSED AND LOCKED POSITION
YELLOW CAP
02463
DRAIN TUBE
TRANSAXLE PUMP FLUID
The transaxle was sealed at least...kept clean to remove dirt and stubborn dried gum fibers. Change the oil after each time you check the oil level.
SAE VISCOSITY GRADES
5W-30
SAE 30
F
-20
0
30...;rmly into place before oil change.
User Manual - Page 17
...automotive type wax. tions. • Place new fuel filter in position in "PRODUCT SPECIFICATIONS" section of your tractor. We do not recommend using a garden hose or pressure washer to carburetor, ...-LINE FUEL FILTER (See Fig. 16)
The fuel filter should be replaced once each mowing season or after every 100 hours of all foreign matter.
• Keep finished surfaces ...
User Manual - Page 18
... - Have a tight grip on lift lever, lower it slowly and engage in "DISENGAGED" position. • Lower attachment lift lever to its lowest position. • Roll belt off engine pulley (M). • Remove retainer ...pedal fully and set parking brake. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key to "STOP" and remove key. • Make sure the blades and...
User Manual - Page 20
...; Recheck measurements, adjust if necessary until front
tip of blade is pointing straight forward.
To obtain the best cutting results, the mower blades should be the same on both...BACK ADJUSTMENT (See Figs. 24 and 25) IMPORTANT: Deck must be adjusted so the front tip is 1/8" to the ground.
Engage parking
brake. • Lower attachment lift lever to highest position. • Position...
User Manual - Page 21
...You may also check brake by placing freewheel control in or camber, contact a qualified service center. Engage parking brake. BELT REMOVAL •...more than five (5) feet to manually push the tractor forward.
TO REPLACE MOTION DRIVE BELT (See Fig. 27)
Park ...you try to stop at highest speed in and camber is set front wheel toe-in "transmission disengaged" position. The rear...
User Manual - Page 24
...this manual). • After cleaning, leave cables disconnected and place cables where they cannot come in storage, battery may require... the battery for storage. • After a period of time in contact with battery terminals. • If battery is removed...(s) into
cylinder(s). • Turn ignition key to "START" position for a few seconds
to cool before painting. Allow the engine...
User Manual - Page 25
... Dirty air filter. 5. Water in "CHOKE" position. 3. Carburetor out of adjustment.
1. Clean/replace air &#...15. Brake pedal not depressed. 2. Attachment clutch is engaged. 3. Recharge or replace battery. 4. Check all wiring... battery terminals. 3. Check all wiring. 10. Adjust throttle control. 3.
Loose/damaged part(s).
1. Wait several minutes before attempting...
User Manual - Page 26
... leaves seat with blades listed in "engaged" position. 2. Tighten blade bolt. 7. Replace with attachment clutch engaged
1. Faulty light switch. 4. Replace fuse. Loss of grass, leaves, and trash under mower. 8. Place freewheel control in this manual. 11. Engine throttle control not set between half and full speed (fast) position before stopping engine.
26 Engine continues to...
Similar Questions
Transmission Will Not Engage
mower will not go forward or backward just makes squalling noise. can't freewheel mower by pulling r...
mower will not go forward or backward just makes squalling noise. can't freewheel mower by pulling r...
(Posted by cpatterson53 2 years ago)
Cord To Engage Blades
What is the part name and replacement number for the cord that runs from the handle to engage or une...
What is the part name and replacement number for the cord that runs from the handle to engage or une...
(Posted by stephaniewoolfolk 8 years ago)
Operator Presence Control Malfunction
The operator control presence cable connects to an assembly at the rear of the engine which has an i...
The operator control presence cable connects to an assembly at the rear of the engine which has an i...
(Posted by Hankh 9 years ago)