Panasonic MCV7312 Support Question
Panasonic MCV7312 Support Question
Find answers below for this question about Panasonic MCV7312 - UPRIGHT VACUUM.Need a Panasonic MCV7312 manual? We have 1 online manual for this item!
Current Answers
Related Panasonic MCV7312 Manual Pages
MCV7312 User Guide - Page 2
... statements are your responsibilities. not chairs, tables, steps, stairs, etc. Use machine and accessories only in a dry, indoor area.
WARNING
TO AVOID ELECTRICAL SHOCK
Never vacuum damp or wet surfaces or liquids. TO AVOID ACCIDENTS
Except for purchasing this product. The use of an extension cord is intended only for important...
MCV7312 User Guide - Page 5
...NOT allow to be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER
WARNING
To reduce the risk of body away from heated surfaces.
7. DO ... cleaning on cord, or pull cord around sharp edges or corners. IMPORTANT SAFETY INSTRUCTIONS
When using vacuum cleaner, basic precautions should , has been dropped, damaged, left outdoors, or dropped into openings....
MCV7312 User Guide - Page 8
... 26 Replacing HEPA Exhaust Filter 26 Changing Dust Bag 28 Removing and Installing Lower Plate 30 Replacing Headlight Bulb 32 Replacing Belt 34 Cleaning Agitator 36 Replacing Agitator 36 Agitator Assembly 36 Cleaning Exterior and Tools 38 Removing Clogs 40
BEFORE REQUESTING SERVICE 42 WARRANTY 45,46 WHAT TO DO WHEN SERVICE IS...
MCV7312 User Guide - Page 12
....
2)
Handle Screw
➢ Insert screw.
ASSEMBLY
Handle Manche Mango
Attaching Handle
1)
➢ DO NOT plug in back of cord reel until the end is reached.
➢ Do not use vacuum without cord pulled out all the way.
➢ Push power cord into a 120V outlet located near floor.
➢ To prevent injury or...
MCV7312 User Guide - Page 14
..., in rear slot of tool holder, twisting and pushing down over short hose to assure a good connection.
➢ Store other wand, with dusting brush on vacuum cleaner.
MCV7312 User Guide - Page 16
...Point Point d'articulation Botón de liberación
➢ The nozzle of your Panasonic upright vacuum cleaner automatically adjusts to any carpet pile height.
➢ Feature allows nozzle to the ...Motor Protector
➢ Automatically opens to provide cooling air to float evenly over end of carpets near walls and furniture. Edge Cleaning
➢ Edge cleaning feature provides for...
MCV7312 User Guide - Page 18
...so can cause belt to rub on carpeted floors.
➢ For longer belt life, turn vacuum off before moving selector. To Clean Carpet Position tapis Para aspirar sobre una alfombra
- 18 -...
Carpet-Bare Floor Selector
Sélecteur tapis/plancher Selector carpetbare floor
➢ The agitator does not rotate in the BARE FLOOR (TOOLS) position.
➢ Selector should be placed in ...
MCV7312 User Guide - Page 20
... Support de l'anneau du tuyau
Soporte para anillo para manguera
OFF ON
➢ Hose ring and hose ring mount are designed to prevent tipping of vacuum while using tools.
➢ Place hose ring in hose ring mount as shown in illustration. Hose Ring Anneau du tuyau Anillo para manguera
- 20...
MCV7312 User Guide - Page 22
... fit in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to upright position for storage and tool use.
Handle Adjustments
➢ Step on .
➢ OFF position turns vacuum off. Handle Release Pedal Pédale de réglage de l'inclinaison du manche Pedal de liberación del...
MCV7312 User Guide - Page 24
... tools can be attached to hose, wand(s) or crevice tool.
➢ DO NOT overextend your reach with hose as it could tip vacuum.
➢ To prevent tipping of vacuum, use hose ring mount when cleaning areas below upper cord hook with the tools.
➢ The Crevice Tool may be used on the...
MCV7312 User Guide - Page 26
... this manual for years to help solve various problems that may occur. ROUTINE CARE OF CLEANER
Performing the following tasks will keep your new Panasonic vacuum cleaner operating at peak performance levels and will ensure these tasks to come. Check the BEFORE REQUESTING SERVICE section in water.
➢ When dry, slide...
MCV7312 User Guide - Page 28
....
2) ➢ Remove dust bag by holding cardboard portion and pushing back.
5) ➢ Reinsert tabs on end of dust cover
into grooves on dust compartment to allow cover to tear bag.
Slots
Fentes Ranuras
Fold
Plier Doble... into place without pinching dust bag.
- 28 - Changing Dust Bag
Always operate vacuum with genuine Panasonic Type U3 Standard or U6 Electrostatic dust bags installed.
MCV7312 User Guide - Page 30
...floor.
➢ Place handle in belt area.
➢ Reinstall lower plate by hooking front end of lower plate into slots on front of nozzle housing.
➢ Make sure all wires are...Plaque inférieure Base inferior
➢ Before servicing any residue that may exist in upright position and turn vacuum over to expose lower plate.
➢ Release lower plate by pressing two (2) latches and...
MCV7312 User Guide - Page 34
... carpet-bare floor selector in CARPET position.
➢ Remove lower plate. ➢ Remove agitator by hand to make sure that belt is not twisted or pinched and that all rotating ...selector carpet-bare floor
➢ Clean agitator and reinstall the two (2) end caps.
➢ Loop new belt (Panasonic Type UB8 only) around motor shaft and brush pulley; End Cap Bouchon Tapa del extremo
- 34 -...
MCV7312 User Guide - Page 36
... on the new brush unit.
➢ Reinstall agitator and lower plate. Agitator Assembly
Washer
Brush Unit
Washer End Cap
End Cap Belt Pulley
- 36 - Card
Carte Tarjeta
Replacing Agitator
➢ When the bristles on the agitator are worn so that they do not touch a card held across the lower plate, the agitator should be replaced.
➢ Remove lower plate...
MCV7312 User Guide - Page 40
If the hose should become clogged:
➢ Unplug vacuum.
➢ Pull open suction inlet cover and check for clogs.
- 40 - Suction Inlet ...on the back of the vacuum cleaner carries the dirt from short hose and check the wand and hose.
➢ Plug in vacuum cleaner and turn vacuum cleaner OFF and UNPLUG POWER CORD.
➢ Turn vacuum over and inspect agitator area for clogging.
MCV7312 User Guide - Page 42
... problems. Any service needed, other than those described in electric shock or personal injury from cleaner suddenly starting.
Full or clogged dust bag. 2. Worn agitator. 6. Replace agitator. 6. Replace hose. 7. Bag improperly installed. 2.
ON-OFF switch not turned on. 3. Plug in hose. 7. Clogged hose or nozzle. 4. Change bag. 2. Unplugged at household service...
MCV7312 User Guide - Page 45
... and workmanship which require normal replacement: Disposable Dust Bag, Filters, Belts, Light Bulbs, Agitator Brushes and Batteries (if supplied). If a problem with new or refurbished parts free of...PURPOSE, ARE LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE. WARRANTY
Panasonic Vacuum Cleaner Limited Warranty
Panasonic Consumer Electronics Company (collectively referred to as hotel, ...
MCV7312 User Guide - Page 46
... before warranty service is performed. BE LIABLE FOR ANY SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES.
Vacuum Cleaner - A purchase receipt or other proof of date of original purchase.
- 46 ...disposable dust bags, filters, belts, light bulbs and agitator brushes are also excluded from coverage under this product to the original end user purchaser only. THIS EXPRESS, LIMITED WARRANTY IS...
Similar Questions
Agitator Brush Won't Engage
I took checked the belt on the agitator roll and it is new. There is suction and all works until you...
I took checked the belt on the agitator roll and it is new. There is suction and all works until you...
(Posted by littleweed1960 2 years ago)
Spare Part 'cap' For Agitator
where can I buy a new a new Cap for the agitator??????
where can I buy a new a new Cap for the agitator??????
(Posted by oboss 11 years ago)
Is This Vacuum Height Adjustable?
(Posted by nancyjl432 11 years ago)
How Do I Replace The Belt For My Panasonic Mcv-7571 Upright Vacuum?belt#
(Posted by profglover 12 years ago)
I Have Purchased A Panasonic Vacuum Cleaner Mc-ug471. This Is The 2nd One I Hav
(Posted by daisies1949 12 years ago)