Panasonic EP1060 Support Question
Panasonic EP1060 Support Question
Find answers below for this question about Panasonic EP1060 - MASSAGE LOUNGER.Need a Panasonic EP1060 manual? We have 1 online manual for this item!
Question posted by marystripe on December 16th, 2020
Panasonic Massage Chair Turns On Then Off
I have a Panasonic massage chair and my control turns on and all the lights conme on then it turns off
Current Answers
Answer #1: Posted by INIMITABLE on December 16th, 2020 9:20 AM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,069,620
Member since:
April 3rd, 2020 Points: 2,069,620
"If the Rollers won't move when their suppose to followed by a force shut down, there's a jam somewhere in the rollers. The Main Logic Board contains a load protection circuit that triggers a shutdown when something jams to prevent a fire.
The jam can be anywhere so you'll need to examine everything very closely.
Hope this helps."
please refer to this link for more solution; https://www.justanswer.com/electronics/7xuke-panasonic-massage-lounger-ep571-shuts-off-within.html
The jam can be anywhere so you'll need to examine everything very closely.
Hope this helps."
please refer to this link for more solution; https://www.justanswer.com/electronics/7xuke-panasonic-massage-lounger-ep571-shuts-off-within.html
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related Panasonic EP1060 Manual Pages
EP1060 User Guide - Page 3
...to reduce the risk of lint and hair, etc. 12. onto the controller. 14. When unplugging the unit, turn off all instructions before removing the plug from the unit. SAVE THESE ... use the unit outdoors. 15. Do not use the unit for purchasing the Panasonic Swede-AtsuTM Massage Lounger EP1061/EP1060. To avoid electric shock or injury, do not attempt to open or disassemble any...
EP1060 User Guide - Page 4
...When the seat back is not correct, use the massager for more than 5 minutes when first using it . Do not unplug the unit or turn it . Sit down slowly after one point for more...allow children or pets to the chair.
4 If you start on or around the unit, especially during operation. Never put any part of 15 minutes each session. Do not massage any time by pressing the Stop...
EP1060 User Guide - Page 5
... obstacle. 10. The chair is normal. 9. Do not pull the controller cord or the power cord. Do not treat the chair roughly, such as turning the chair on it . If the back hits a wall or pillar, the chair may cause the switch to the massage mechanism and/or other solvent-type cleaners. The massage Lounger must not be heard...
EP1060 User Guide - Page 6
... the chair if the massage heads have been moved to their resting positions and the backrest
reclined. • Moving the chair may cause the chair to move the chair is by lifting from behind the chair (left... as to observe this product.
Use the casters to move the chair. • Do not attempt to move the chair while someone is connected to reduce the risk of electric shock. ...
EP1060 User Guide - Page 7
Armrest
Back Cushion Zip Back Cushion Controller
Controller Pocket Seat
Legrest
2 way roller massage
Soles of feet
Calves
Controller
EP1061
Power Switch Lock Switch
on
off
lock
open
lock switch
EP1060
Back Cover Back Cover Handles Safety Precaution Label
Wheels
7
PART NAMES AND FUNCTIONS
SEAT
Backrest
Center Cushion with Integrated Pillow
• Push up the center...
EP1060 User Guide - Page 8
...
vibration
tap A
tap B
whole back roll
regional
intensity
position
slow
fast
leg massage
CONTROLLER (EP1060)
Leg Massage Button
¥ Used to turn on /off and adjust the leg vibration massage unit. Leg Massage Button ¥ Used to turn on/off and adjust
the leg roller massage unit. Shoulder Position Indicator
Programmed Operation Buttons
Concentrated Area Buttons ¥ Used...
EP1060 User Guide - Page 9
... unit in areas with high humidity, such as this can cause discoloration or hardening of the synthetic leather.
9 as the bathroom, etc. SETTING UP THE MASSAGE LOUNGER
WHERE TO USE THE UNIT
CAUTION
• Do not use the unit in direct sunlight or in places where it will be exposed to high...
EP1060 User Guide - Page 10
.... If the cover of safety there may be retracted in the interests of the controller and select the massage required. c The chair will find an overview of 220 lbs. x The seat will flash. z Open the cover of safety the massage heads may happen more frequently for the following before the backrest actually starts to...
EP1060 User Guide - Page 11
... Lift up the pillow and the center cushion to recline the unit. • In the interests of the chair or any other objects. x Check that the power cord is in the power cord. (Take care to ... when it reclines.)
1
on 3
off ". • To prevent children from being turned on the back of the back cushion, etc. c Turn on the power switch on when switch is not caught by moving if it . BEFORE...
EP1060 User Guide - Page 12
...the massage again.
• To make the massage even stronger, the center cushion with your feet from you.
Sit Down Only When the Legrest is Lowered • If you sit on the controller as ...the lounger by standing on both sides and fold out and away from the massager prior to standing. • DO not open the leg massager for a soles feet massage, grab the top of part of the massage heads...
EP1060 User Guide - Page 13
...the legrest. • When both the backrest and legrest have been extended as far as the massage heads must be retracted in the interests of safety there may be sure to return the legrest ... risk of personal injury, do not fully recline the seat.
RECLINING THE SEAT
NOTE: Position the chair at least 16 in. (40cm) away from any part of your fingers or any wall or other obstacle to ensure...
EP1060 User Guide - Page 14
...Approx. 14° Raised
Normal Position (EP1060)
Reclining
Massage Position
In this comfortable position it is gentler than shiatsu massage - Approximate positions for
people with stiff ...60° Raised
3.
Press
vibration on/off
5
Gently Massage the Whole Back
• This type of the controller.
3
/ programmed manual
operation operation
programmed operation
storong
...
EP1060 User Guide - Page 15
... the program on or off, and the weight of the massage heads (upper roller) so that they lightly touch the shoulder.
• The shoulder position can be
neck, shoulder
lower back
massaged slightly.)
• Press the button
again to toggle off . Too low
Massaging the Neck and Shoulders
• Press this will vary according...
EP1060 User Guide - Page 16
... can now select either Strong or Gentle or one of the manual
settings that can be accessed by opening the cover of the controller.
E.g.
E.g.2 Adding Roll to the massage position. E.g.1 Adding Tap B when Knead is selected.)
manual operation shiatsu swedish knead
Press
manual operation shiatsu swedish knead
vibration tap A
tap B
vibration tap...
EP1060 User Guide - Page 17
..." sound.
• As Roll or combining Roll with Tap B, deselecting Knead will hear a "peep, peep, peep" sound. Raising the massage heads
position
Lowering the massage heads
position
Press
Press
Adjusting the Width between massages.
6. manual operation shiatsu swedish knead
vibration tap A
tap B
manual operation shiatsu swedish knead
vibration tap A
tap B
Press
manual operation...
EP1060 User Guide - Page 18
... Timer to Prevent Overuse • An integrated timer prevents overuse of at least 10 minutes between massages to stop the leg massage. Adjusting Massage Speed
• Leg massage intensity can be adjusted in 2-stages.
4. LEG MASSAGE IN MANUAL OPERATION (EP1060)
• If your calves are not in the correct position in 2-stages. STOPPING MANUAL OPERATION
Press...
EP1060 User Guide - Page 26
... body then you . If all markings and buttons on the controller start the massage again. H If the massage heads are in doubt about some of the check points, or if the remedies indicated in the interests of the shoulders is extremely unusual, turn off the power switch, wait for approximately 10 seconds and then...
EP1060 User Guide - Page 27
...)
• The power switch on the unit has not been turned on again.
If all . • Upper body (neck to the place that you bought it. The unit will naturally become warm.
If the controller becomes too hot, immediately stop using the massage lounger in the interests of safety the unit will come to...
EP1060 User Guide - Page 28
...)
Maximum user weight:
264 lbs. (120kg)
SPECIFICATIONS (EP1060)
Power Supply:
120V AC, 60Hz
Power Consumption:
135W (Approx. 5W in Standby mode with the controller turned off or when the
unit is turned off .)
Upper Body Massage
Massage Area (Up-Down):
Approx. 27.6in. (70cm)
Massage Area (Left-Right):
Distance between Massage Heads during Operation
Approx. 2.4 - 5.9in. (6 - 15cm...
EP1060 User Guide - Page 56
No.2 EN, SP
Panasonic Consumer Electronics Company
One Panasonic Way 3D-1 Secaucus, New Jersey 07094 1-800-338-0552 for questions and comments. www.panasonic.com/massage
P90101060231
Printed in Japan
Similar Questions
Looking Left And Right Casters And Wheels For Ep1060
(Posted by michaeltaylorsr 3 years ago)
The Back Rof Panasonic Massage Chair Ep1010 Would Not Stay Up When I Try To Recl
The back rof Panasonic massage chair EP1010 would not stay up when I try to recline backward. Perhap...
The back rof Panasonic massage chair EP1010 would not stay up when I try to recline backward. Perhap...
(Posted by drjyp 3 years ago)
I Have A Panasonic Ep1273 Massage Chair That Is Not Working
My Panasonic EP1273 has been a great massage chair until recently. It randomly stopped working, does...
My Panasonic EP1273 has been a great massage chair until recently. It randomly stopped working, does...
(Posted by Dylanoppel 6 years ago)
When Ep1060-massage Lounger Is On, All The Buttons On Remote Turns On Then Off.
When I turn it on, the leg and head started tilt back, then stop half way. The remote buttons all li...
When I turn it on, the leg and head started tilt back, then stop half way. The remote buttons all li...
(Posted by kinhhuynh46 10 years ago)