Panasonic EP1060 Support Question
Panasonic EP1060 Support Question
Find answers below for this question about Panasonic EP1060 - MASSAGE LOUNGER.Need a Panasonic EP1060 manual? We have 1 online manual for this item!
Question posted by michaeltaylorsr on March 15th, 2021
Looking Left And Right Casters And Wheels For Ep1060
The person who posted this question about this Panasonic product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by techyagent on March 15th, 2021 12:49 PM
techyagent
Member since:
June 17th, 2014 Points: 4,799,790
Member since:
June 17th, 2014 Points: 4,799,790
Generally, the greater the weight, the larger the wheel required for the caster. Larger wheels distribute weight and roll more easily over floor obstructions. To determine the load capacity for each caster, divide the combined weight of the equipment and maximum load by the number of casters to be used.
https://monroeengineering.com/info-casters-selecting-right.php
Thanks
Techygirl
Related Panasonic EP1060 Manual Pages
EP1060 User Guide - Page 3
.... 5. Close and continuous supervision are limited in water. 9. This unit should never be left unattended when plugged in places where aerosol spray products are kept free of lint and hair,...of the unit. 13. Only use the unit for purchasing the Panasonic Swede-AtsuTM Massage Lounger EP1061/EP1060. When unplugging the unit, turn off all instructions before using an electrical unit,...
EP1060 User Guide - Page 4
... your body between the legrest and the footrest. After approximately 15 minutes, the massage heads will be able to the chair.
4 Do not go to sleep while using the massager, if the pressure seems too strong, the movement of the massage heads can gradually increase the duration and intensity of your fingers or feet...
EP1060 User Guide - Page 5
...
authorized service center. 6. Allow to move up from the covering of the controller between the armrest and the chair back.
3. Be sure to the "lock" position. 12. The massage Lounger must not be reclined to the massage mechanism and/or other solvent-type cleaners. Some noise may cause permanent damage to a maximum
angle of...
EP1060 User Guide - Page 6
... to move the chair if the massage heads have been moved to their resting positions and the backrest
reclined. • Moving the chair may cause the chair to move the chair is by lifting from behind the chair (left illustration). • It is sitting in doubt as the plug.
Use the casters to move the chair. • Do not...
EP1060 User Guide - Page 7
Armrest
Back Cushion Zip Back Cushion Controller
Controller Pocket Seat
Legrest
2 way roller massage
Soles of feet
Calves
Controller
EP1061
Power Switch Lock Switch
on
off
lock
open
lock switch
EP1060
Back Cover Back Cover Handles Safety Precaution Label
Wheels
7 PART NAMES AND FUNCTIONS
SEAT
Backrest
Center Cushion with Integrated Pillow
• Push up...
EP1060 User Guide - Page 8
...
manual operation
shiatsu
swedish
knead
vibration
tap A
tap B
whole back roll
regional
intensity
position
slow
fast
leg massage
CONTROLLER (EP1060)
Leg Massage Button
¥ Used to turn on /off and adjust the leg vibration massage unit.
Leg Massage Button ¥ Used to turn on /off
intensity
Quick Stop Button ¥ Used to adjust the intensity...
EP1060 User Guide - Page 9
... for Reclining
• Ensure that there is approximately 16in. (40cm) behind and at least 16in. (40cm) in front of the synthetic leather.
9 SETTING UP THE MASSAGE LOUNGER
WHERE TO USE THE UNIT
CAUTION
• Do not use the unit in direct sunlight or in places where it will be exposed to high...
EP1060 User Guide - Page 10
...chair will flash. An average program massage is fully retracted. z Open the cover of the massage rollers. or more.) If the massage mechanism stops (or if all over. • Ideal for the massage. Turn the Power Off to Finish the Massage...to adjust movement and location during upper body massage, in the interests of how to operate the massage lounger simply. c Unplug the power cord. After ...
EP1060 User Guide - Page 12
... OF FEET
• To open or close leg massager while reclining.
12 NOTE: • DO not sit on or get off the lounger by standing on the controller as the reclining button ... the massage, then the massage heads will not be retracted.)
• Please do not put your fingers or any part of the massage heads. Instead, push button twice to retract the massage heads to the left and right at the...
EP1060 User Guide - Page 13
...the legrest. • When both the backrest and legrest have been extended as far as the massage heads must be retracted in the mechanical section of safety there may be sure to return the ...seat. Retracting The Seat
• Check that there is fully retracted. RECLINING THE SEAT
NOTE: Position the chair at least 16 in. (40cm) away from any part of your body in the interests of the ...
EP1060 User Guide - Page 14
... or gentle or one of the manual settings
that can be
a slight delay before use.
1. Approx. 3° Reclined
Approx. 14° Raised
Normal Position (EP1060)
Reclining
Massage Position
In this comfortable position it is not recommended to change the reclining angle.
14
Up neck roller position
Press
Down
Approximate Body Height
neck...
EP1060 User Guide - Page 15
... programmed operation. • The ON/OFF lamp will also be
neck, shoulder
lower back
massaged slightly.)
• Press the button
again to a stop. (Although programmed operation lasts for...automatically come to toggle off .
Press
• For Tapping B, and Vibration, unless the massage heads are actually touching the body then you may make sitting in the seat somewhat
uncomfortable....
EP1060 User Guide - Page 16
...of the manual
settings that can be lit.
• The seat will start to the massage position. E.g.1 Adding Tap B when Knead is selected.)
manual operation shiatsu swedish knead
Press...
regional
16
Open the Cover of the Controller
• All of the massage you require.
Selecting the Massage Type Required
• Press the button of the manual operation buttons will ...
EP1060 User Guide - Page 17
...Roll + (Knead, Swedish Combination Weak only
• For Tap B, Swedish, and Vibration, unless the massage heads are actually touching the body then you release the button. If you will continue to move a ...little each time the button is to adjust width settings.
• The massage heads will flash until you may not feel the movement.
5. Stopping Manual Operation
Press button...
EP1060 User Guide - Page 18
...
fast
leg massage
fast
Press
slow
fast
leg massage
Off Press
slow
fast
leg massage
4. Always remove your feet from the massager prior to standing. (EP1060/EP1061) Integrated Timer to adjust the reclining angle during the massage. slow
fast
leg massage
Press
slow
fast
leg massage
3. NOTE:
(EP1061) DO NOT sit on or get off the lounger by standing...
EP1060 User Guide - Page 19
...place excessive force on the pocket, which can cause it may take some time for the massage heads to return to the retracted position, please continue to rip. reclining
Press
Check that ...4. Check that there is nothing
here
Closing the leg massager
3. Place the Controller in its Original Position.
19 AFTER COMPLETING THE MASSAGE
RETURN THE SEAT TO THE ORIGINAL POSITION
1. Check that there...
EP1060 User Guide - Page 24
...stiff muscles. It is designed to work on the acupressure points. This kind of both sides of a massage as those found in a specified location.
Vibration
The minute vibrations are being used to tap in the neck...of the fingers being used to relax even the tensest body. This type of massage is ideal for thick muscles such as it is ideal to give the impression of the neck or as...
EP1060 User Guide - Page 26
... excessive force is applied to the massage heads during operation, in the interests of safety the massage heads may stop moving .
In such a situation, move the chair or remove the obstruction and start...
Cause and Remedy
Motor Noises
• The motor gets louder when it .
H If the massage heads are raised or lowered, if they come up to flash, which is extremely unusual, turn...
EP1060 User Guide - Page 27
... been damaged.
H • The power cord has been disconnected. (See Page 11)
• The power switch on the unit has not been turned on again. massage lounger serviced.
27
Please hold down the button until the backrest is exerted on the controller start to flash, which is used continuously for an extended...
EP1060 User Guide - Page 28
...)
Maximum user weight:
264 lbs. (120kg)
SPECIFICATIONS (EP1060)
Power Supply:
120V AC, 60Hz
Power Consumption:
135W (Approx. 5W in Standby mode with the controller turned off or when the
unit is turned off .)
Upper Body Massage
Massage Area (Up-Down):
Approx. 27.6in. (70cm)
Massage Area (Left-Right):
Distance between Massage Heads during Operation
Approx. 2.4 - 5.9in. (6 - 15cm...
Similar Questions
Panasonic Massage Chair Turns On Then Off
I have a Panasonic massage chair and my control turns on and all the lights conme on then it turns o...
I have a Panasonic massage chair and my control turns on and all the lights conme on then it turns o...
(Posted by marystripe 3 years ago)
Repair Technician For Massage Chair
I have Panasonic EP 1011 and need repairs to I. How can I find a in home technician in Maryland?
I have Panasonic EP 1011 and need repairs to I. How can I find a in home technician in Maryland?
(Posted by bowlesa 9 years ago)
Fixing Panasonic Massage Chair Ep1015
My Massage chair wont work The motor runs but the massage units dont come up into place. How can I f...
My Massage chair wont work The motor runs but the massage units dont come up into place. How can I f...
(Posted by waddellbillie 10 years ago)
When Ep1060-massage Lounger Is On, All The Buttons On Remote Turns On Then Off.
When I turn it on, the leg and head started tilt back, then stop half way. The remote buttons all li...
When I turn it on, the leg and head started tilt back, then stop half way. The remote buttons all li...
(Posted by kinhhuynh46 10 years ago)