Maytag MIM1555ZRS Support Question
Maytag MIM1555ZRS Support Question
Find answers below for this question about Maytag MIM1555ZRS.Need a Maytag MIM1555ZRS manual? We have 3 online manuals for this item!
Question posted by toniballesteros on April 28th, 2014
Help With Cleaning Cycle
I have followed the directions on the manual and removed the necessary parts, cleaned them, and replaced them. I now wish to run a cleaning cycle. As instructed, I emptied the bottle of cleaning solution into the water pan and added 2 bottles of water. I pressed clean. The ice maker is now telling me to add cleaner, which I have done, and I cannot get the cleaning cycle to continue. I cannot find any further information--I am stuck with the machine blinking "add cleaner". Please assist--thanks.
Current Answers
Answer #1: Posted by Odin on April 28th, 2014 8:08 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
You need to power off the ice machine, empty the ice machine, and use an ice machine cleaning solution to scrub the bin liner. Rinse and dry thoroughly before restoring power to the machine. If you need further guidance, phone Maytag at 800-462-9824.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MIM1555ZRS Manual Pages
Installation Guide - Page 1
... you what can happen if the instructions are very important. All safety messages will follow these basic
precautions:
■ Plug into a grounded 3 prong outlet. ■ Do not remove ground prong. ■ Do not use an adapter. ■ Do not use an extension cord.
■ Disconnect power before manually cleaning the inside components. ■ Disconnect power...
Installation Guide - Page 2
... to remove tape or glue.
Wipe with temperatures above 55°F (13°C) and below 110°F (43°C).
Place electrical and plumbing fixtures in the "Ice Maker Care" section.
See the cleaning instructions in the recommended location as wind, rain, water spray, or drip.
■ When installing the ice maker under a counter, follow the...
Installation Guide - Page 3
...
Connecting the Water Line
1.
Use a receptacle which reduces water flow and clogs more easily. IMPORTANT: If this product is connected to refill
after heavy usage. Replace the filter if necessary. ■... follow these instructions can result in the supply lines can increase water pressure and damage your ice maker or home. Tools Needed Gather the required tools and parts ...
Installation Guide - Page 7
... drain reducer installed directly below the outlet of door, with a 1¹⁄₂" (3.81 cm) to follow these instructions can settle. ■ The floor drains must not have a 1" drop per 48" (2.54 cm drop per
122 cm) of run 100 ft (30.5 m)
NOTES:
■ If the drain hose becomes twisted and water cannot drain, your...
Installation Guide - Page 8
...power. 2. Do not use an extension cord.
Remove the 2 hex-head screws located under the ...follow these instructions can result in death, fire, or electrical shock.
1. Hex-head screws
1. Pull up .
See "Gravity Drain System." See "Drain Pump System."
3. Ice Maker Door Reversal-Side Swing Only
Tools Needed Gather the required tools and parts before servicing. Replace all water...
Installation Guide - Page 10
... the required tools and parts before starting installation. ■ 9" level ■ Adjustable wrench NOTE: It is loose, water will empty from front to back and side to remove. Unplug ice maker or...of the ice maker.
6. Replace the drain cap securely on the bottom rear of the ice maker. 4.
Screw (on top of the legs as possible to follow these instructions can result in the
bin...
Installation Guide - Page 11
... interior components using the following instructions.
■ Replace the ice scoop holder by
removing the 2 screws. Ice scoop holder
11. 6. Unplug the ice level sensor from the water pan is securely in 1 gal. (3.8 L) warm water.
A.
Then clean the same parts with mild soap or detergent and warm water. Ice scoop holder
11 Remove, clean and replace the ice scoop...
Warranty Information - Page 1
...replace appliance light bulbs, air filters or water filters. This major appliance is designed to be repaired in the home and only in-home service is not installed in materials or workmanship. The removal and reinstallation of your major appliance for factory specified parts... instructions attached to or furnished with published installation instructions.
11. Service calls to refrigerator ...
Use & Care Guide - Page 1
...safety messages will tell you what can be killed or seriously injured if you don't immediately follow instructions. You will follow the safety alert symbol and either the word "DANGER" or "WARNING." Always read and... our website at www.maytag.ca or call us at www.maytag.com for purchasing this manual and on your model and serial number, located on the inside wall of others .
This...
Use & Care Guide - Page 2
...maker, follow the recommended opening dimensions shown.
See the cleaning instructions in ...Part Number 8212547RB, and a Whirlpool approved drain pump, Part Number 1901A, only to carry the water to move and install ice maker. Cleaning Before Use
After you remove all of the packaging materials, clean the inside components. ■ Disconnect power before servicing. ■ Replace all parts...
Use & Care Guide - Page 3
.... If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):
■ Check to see whether the sediment filter in death, fire, or electrical shock. Replace the filter if necessary.
■ Allow the storage tank on the reverse osmosis system to follow these instructions can adjust...
Use & Care Guide - Page 7
Attach ¹⁄₂" ID x 10 ft (3 m) drain tube to follow these instructions can settle.
■ The floor drains must maintain a 1" (2.54 cm) air gap between the cabinet and the ice maker. See "Parts Locations" illustration.
16. Do not remove ground prong. Do not use an extension cord. Plug in accordance with all state and...
Use & Care Guide - Page 11
...If the filter is not correctly locked into the housing, the ice maker will cycle at least every 9 months. A
A. Replace the Water Filter
To purchase a replacement water filter, see "Accessories." Install the replacement water filter by following steps 2 through 5 in the "Install Water Filter" section. 2. The rinsing process takes about 5 minutes.
2. Under normal operating conditions, the...
Use & Care Guide - Page 12
... pulsating or high pitched sound.
■ Water running over the condenser by the condenser fan.
■ During the harvest cycle, you may hear a "thud" when...empty. Fast Ice Mode Select the Fast Ice feature when you may make ice.
■ If the ice maker is recommended that higher operating temperatures result in the "Cleaning" section. The amount of ice and the ice bin is not refrigerated...
Use & Care Guide - Page 13
.... Ice Maker System
Minerals that the cleaning cycle is complete, remove the drain cap from the water pan and you should run the clean cycle again. To order, see "Accessories." 1. Be sure to replace the drain cap securely on the cleaner bottle before cleaning. If the drain cap is loose, water will empty from the water pan and you may need to fall...
Use & Care Guide - Page 14
... down and forward away from the water pan, and you will empty from the cutter grid.
7. Ice level sensor harness E. Water pan B. Remove, clean and replace the ice scoop and ice scoop ...screws. 6. Remove dirt and lint from the right-hand side of the cutter grid.
Replace the lower access panel using the following instructions.
■ Replace the ice scoop holder by removing the 2 ...
Use & Care Guide - Page 15
... secure it by replacing the mounting screw.
13.
Remove the 2 screws in 1 gal. (3.8 L) warm water. Rinse again thoroughly in ice maker or reconnect power.
18.
This will remove the remaining water from the drain line. Plug into position. Plug in clean water. Check the following:
■ Drain cap from the water pan is loose, water will empty from the water pan, and...
Use & Care Guide - Page 16
... not full of water through the inlet valve. Check the following things: ■ Check that the water supply is securely attached to the water
pan. Call a licensed, qualified plumber to determine the best method to see whether the drain hose is level, and the problem persists, run a cleaning cycle. Do not use an adapter.
Replace the fuse or...
Use & Care Guide - Page 17
... to do so can result in the "Cleaning" section.
If ice is properly installed. Replace all packaging materials were removed at the time of Ice
Is there unusually high mineral content in the bin?
Clean your ice maker. Check that the water supply is loose, water will empty from the water pan, and you will have either thin...
Use & Care Guide - Page 20
... modifications made to refrigerator or freezer product ... altered or removed from accident,...replace appliance light bulbs, air filters or water...Instructions and model number information for factory specified parts and repair labor to correct defects in materials or workmanship and is not installed in accordance with published installation instructions.
11. Proof of repair or replacement...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Water supply hookup - Bottom freezer/French door refrigerators
... valve (requires a ¼" hole to your refrigerator has a water filter, it is connected to be required in place. Read and follow the instructions provided with a reverse-osmosis system. Tools needed to a water supply: Read all directions before the water line is low, check for water filter removal instructions. Water pressure A cold water supply with a pipe clamp. Make sure... -
Water supply hookup - French door with exterior dispenser
... it for cleaning. Use ¼" (6.35 mm) O.D. (outside diameter) copper tubing. Using a cordless drill, drill a ¼" hole in the cold water pipe you have selected. 6. Turn OFF the shutoff valve on , 5 seconds off the ice maker. Remove plastic cap from the connection on copper tubing as shown. Check connection by side refrigerator As air... -
Water supply hookup - Bottom freezer/French door refrigerator
... water dispenser and ice maker. Do not kink; Correct leaks if necessary. Use a sturdy container to the refrigerator cabinet with water pressure of the refrigerator needs to refill after heavy use a piercing-type or 3/16" (4.76 mm) saddle valve which reduces water flow and clogs more easily. Tighten the compression nut. Secure copper tubing to press and hold the water...
Similar Questions
Water Filter For Ice Maker
Is there a water filter for the ice maker?
Is there a water filter for the ice maker?
(Posted by doreenmccarthy 5 years ago)
Ice Maker Will Not Stay In The 'on' Position.
Ice maker stops making ice after one cycle and will not resume unless the lever is moved to the on p...
Ice maker stops making ice after one cycle and will not resume unless the lever is moved to the on p...
(Posted by acpwoods 9 years ago)
Water Not Going In Ice Maker
we had to take the ice maker out to clean out the drain and get the ice out of the bottom and now th...
we had to take the ice maker out to clean out the drain and get the ice out of the bottom and now th...
(Posted by timb0 11 years ago)
Water Not Flowing To Water On Door Or Ice Maker
Water is flowing into the water filter but not flowing out from filter to water dispenser on door or...
Water is flowing into the water filter but not flowing out from filter to water dispenser on door or...
(Posted by doctmc20 12 years ago)