Maytag MED9700SQ Support Question
Maytag MED9700SQ Support Question
Find answers below for this question about Maytag MED9700SQ - 27" Front-Load Electric Dryer.Need a Maytag MED9700SQ manual? We have 1 online manual for this item!
Question posted by dchurchilld on August 15th, 2016
What Is The Replacement Model For The Maytag Med9700sq0 Dryer?
It is discontinued and need to purchase a new unit that will sit on top of the washer
Current Answers
Answer #1: Posted by Odin on August 15th, 2016 11:18 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
If there is one, you'll need to find out from Maytag. See the contact information here: https://www.contacthelp.com/maytag/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MED9700SQ Manual Pages
Use and Care Guide - Page 3
...tamper with controls.
■ Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this manual...they give off vapors that could cause a load to cooking oils in the dryer. All safety messages will tell you what the...how to reduce the chance of fire, electric shock, or injury to persons when using the dryer.
■ Do not place items ...
Use and Care Guide - Page 4
Optional Pedestal
Are you purchased your washer and dryer? Parts needed Check local codes.
If using a power supply cord: Use a UL listed power supply cord kit marked for use leveling legs if installing the dryer on a pedestal? The wires that connect to the dryer must end in several colors. Ask for this dryer.
Check existing electrical supply and venting...
Use and Care Guide - Page 5
...reasons: ■ Additional spacing should be considered for ease of the dryer.
If using a power supply cord, a grounded electrical outlet located within 2 ft
(61 cm) of either side of ...where it will need 18" (46 cm) to place the dryer at the end of the dryer in death, explosion, or fire.
Dryer only
0" (0 cm)
38" min. (96.52 cm)
*Required spacing
1"* (2.5 cm)
27" (68.6 ...
Use and Care Guide - Page 6
Closet door with stacked washer and dryer
The dimensions shown are required.
7"* (17.8 cm) 7"* (17.8 cm)
9"* (22.9 cm)
5"** 31¹ ₂" 1"*
1" 27" 1"
(12.7 cm) (80.0 cm) (2.5 cm) (2.5 cm)(68.6 cm) (2.5 cm)
*Required spacing **For side or bottom venting, 0" (0 cm) spacing is allowed. Side view - Side view - Closet installation -
Dryer only
14" max.* (35.6 cm)
18...
Use and Care Guide - Page 7
...)
*Required spacing
5"* (12.7 cm)
1" (2.5 cm)
27" (68.6 cm)
1" (2.5 cm)
Mobile home - The opening . The National Electric Code requires a 4-wire power supply connection for purchase from the neutral conductor.
■ If local codes do not permit the connection of the terminal block. If the dryer is installed with a 4-wire electrical supply connection, the neutral ground conductor...
Use and Care Guide - Page 8
...service representative or personnel if you are in ring terminals or spade terminals with clothes dryers.
This dryer uses a cord having an equipment-grounding conductor and a grounding plug. The 4-wire...
■ At least 5 ft (1.52 m) long. WARNING: Improper connection of electric shock.
grounding conductor can result in accordance with flexible metallic conduit. The kit should...
Use and Care Guide - Page 9
... shock by a qualified electrician. Electrical Requirements - A time-delay fuse or circuit breaker is properly grounded. Connect to an individual branch circuit.
■ This dryer is equipped with a cord having an equipmentgrounding conductor and a grounding plug. SAVE THESE INSTRUCTIONS
4-wire receptacle 14-30R
■ Do not use Power Supply Cord Replacement Part Number 9831317.
Use and Care Guide - Page 11
...or circuit breaker box*
4-wire connection: Direct Wire
A UL listed, 120/240volt minimum, 30-amp, dryer power supply cord*
3-wire connection: Power supply cord
3-wire direct
3¹⁄₂" (8.9 cm)
...relief (UL marking on the power supply cord is not available)
Electrical Connection Options
If your type of electrical connection: 4-wire (recommended)
3-wire (if 4-wire is inside ...
Use and Care Guide - Page 12
... block screw E. Tighten screws. Dotted line shows position of dryer rear panel. Tighten strain relief screws. 6.
You have 5 ft (1.52 m) of extra length so dryer can be moved if needed.
12 4-wire connection: Power supply cord
IMPORTANT: A 4-...
A
CD
E
G
A. 4-wire receptacle (NEMA type 14-30R) B. 4-prong plug C. Direct wire cable must have completed your electrical connection.
Use and Care Guide - Page 16
...vent and clamps must not be purchased from the entire length of the system and make sure exhaust hood is a new vent system
Vent material ■...Replace any gas vent, chimney, wall, ceiling or a concealed space of a building. The dryer exhaust must be fully extended and supported when the dryer...the duct.
If this dryer MUST BE EXHAUSTED OUTDOORS. If using an existing vent system
■...
Use and Care Guide - Page 23
Fire Hazard
No washer can result in death or fire. Failure to follow these instructions can result in dryer and shut door.
3. Your dryer may not have all of the load and adjusts the time automatically for the selected Dryness Level.
23 Please refer to follow these basic steps to select either an Automatic or...
Use and Care Guide - Page 24
...desired level. ■ Press and hold HOLD TO START button until dryer starts. Select new cycle settings before activating
the Control Locked feature. If an Automatic Cycle is automatically ... DRY TIME (- Press and hold HOLD TO START button until dryer starts (about 1 second).
Cool Down tumbles the load without heat during dryer operation. NOTE: Time is desired. ■ Press the CYCLE...
Use and Care Guide - Page 26
...needed.
Type of drying time and a drying temperature. When a Manual Cycle is preset to "On." Timed Dry is also useful for items that coverings are unable to remove a load of clothes from being left in the dryer...Load Type
HEAVY DUTY Heavyweight mixed loads, towels, jeans
NORMAL Corduroys, work clothes
TOUCHUP
Medium
20
Helps to smooth out wrinkles
RAPID DRY Small loads
High
27...
Use and Care Guide - Page 27
... complete drying, if needed to tumble dry or that can reach all the surfaces.
Your dryer may vary from the model shown and may not have the same feature as needed .
To use automatic...Manual cycle, and choose a temperature or Air Only (see following table.
7. or +) buttons. Dryer back panel
27 Refer to adjust the sound level or turn off the signal. This chart shows examples of the ...
Use and Care Guide - Page 28
...laundry detergent and very warm water. 2.
To clean 1. Do not rinse or
wash screen to a soft cloth. Make a paste with a nylon brush every 6 months, or more frequently, if it becomes clogged due to your load is in dryer. IMPORTANT:
■ Do not run the dryer... buildup. As needed cleaning Laundry detergent and fabric... water. 5. Replace screen in the dryer. WARNING
Explosion...
Use and Care Guide - Page 29
... should be removed every 2 years, or more often, depending on dryer usage. See "Cleaning the Lint Screen." Use masking tape to secure dryer door. Replace the bulb with the screw.
4. Replace the cover and secure with a 10-watt appliance bulb only. For direct-wired dryers:
WARNING
Electrical Shock Hazard Disconnect power before operating. Disconnect power. 2. Changing...
Use and Care Guide - Page 30
...vent. In Canada www.maytag.ca
Dryer Operation
Dryer will bounce, causing the dryer to follow these instructions ...load will not run
■ Has a household fuse blown, or has a circuit breaker tripped?
Do not use ? No heat
■ Has a household fuse blown, or has a circuit breaker tripped? Electric dryers use a metal foil vent. Do not use 2 household fuses or circuit breakers. Replace...
Use and Care Guide - Page 31
... decreasing the dryness level will not transfer to tumble freely. Stains on load or drum
■ Was dryer fabric softener properly used for the first time? This will change the amount of the cycle. If so, ventilate the area. The new electric heating element may not be gone after the first cycle.
31
Separate...
Use and Care Guide - Page 32
...Canada. For further assistance If you need replacement parts If you use only factory specified parts.
If you need further assistance, you the cost of your dryer with any questions or concerns at www.maytag.com/accessories. For further assistance If you need to Maytag® appliances with these premium accessories. Maytag® appliances designated service technicians are...
Use and Care Guide - Page 33
... need it was purchased. Write down the following information about your major appliance to better help can find this information on the model and serial number label located on the product. ITEMS MAYTAG WILL NOT PAY FOR 1. Repairs when your major appliance is used for product service in accordance with published installation instructions. 11. Replacement...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Recall Information
... by Maytag® CPSC is $150 if the consumer purchases new dishwasher models MDB7759, MDB7609 or MDBH979; contributed significantly to sell or re-sell this press release and recall information at : Department and appliance stores and by Maytag Refrigerator Recall, 2009 Maytag Brand Front Loading Washer Recall, 2007 Maytag and Jenn-Air Brand Dishwasher Recall... -
My Bravos® washer is not rinsing loads well. What is causing this? Dispensers in Corners
... life. Laundry detergents are labeled 2x or higher. Was a low-speed wash cycle used for good cleaning. This means only a small amount is designed to clean well at temperatures above 60°F (15.6°C). Can I turn off the button tones on some models) option selected? The Bravos washer is needed due... -
Display shows F20 or FH - Front-load washer
... -square-inch (psi) value, contact your model number in the search tool below. Both hot...replacement set. Using non-HE detergent, or more than 10 psi? You will not be connected to prevent a possible leak or flood. the washer will begin to use in the back of detergent to drain. Turn off water to the washer to the washer and turned on the washer clogged? My front-load washer...
Similar Questions
Model # Mw1003453 Dryer Wont Spin Everything On Panel Works Fine
(Posted by paintorlando 9 years ago)
Where To Find The Thermal Fuse In A Maytag Dryer Model Med9700sq0
(Posted by Okordu 10 years ago)
Maytag Dryer Model Med9700sq0 Wont Start
(Posted by gmakr 10 years ago)
I Have A Model Medb850wq0 Dryer
Model MEDB850WQ0 Dryer Does not seem to be blowing air with any velocity/volume. Not much at all...
Model MEDB850WQ0 Dryer Does not seem to be blowing air with any velocity/volume. Not much at all...
(Posted by pumperpomeroy 12 years ago)
Maytag Epic Electric Dryer Med9700sq Makes Squeaking Noise
I pulled the bottom of the dryer off and found a large roller that turns the drum. That is where the...
I pulled the bottom of the dryer off and found a large roller that turns the drum. That is where the...
(Posted by classactcowgirl 12 years ago)