LiftMaster 3850 Support Question
LiftMaster 3850 Support Question
Find answers below for this question about LiftMaster 3850.Need a LiftMaster 3850 manual? We have 1 online manual for this item!
Question posted by bonda on February 23rd, 2014
Can I Operate Garage Door Opener Liftmaster 3850p Without The Battery
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster 3850 Manual Pages
3850 Elite Series Manual - Page 1
...;
GARAGE DOOR OPENER Models 3850
3850-267
For Residential Use Only
Com Details
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196 www.liftmaster.com
patible with
See Page 29 for
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door...
3850 Elite Series Manual - Page 2
... Test the Protector System 25
Operation
26-33
Operation safety instructions 26
Using garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
Troubleshooting 28
The remote control battery 28
EverCharge® Standby Power System (optional 29
To open the door manually 30
Care of your garage door and/or the garage door opener if you do not...
3850 Elite Series Manual - Page 3
..., sticks, or is not sticking or binding:
1.
To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to make sure your garage door is balanced and is out of balance.
Preparing your garage door
Before you begin:
• Disable locks.
• Remove any binding or...
3850 Elite Series Manual - Page 5
...3850 (1) 3850-267 (2)
SECURITY✚® Keyless Entry Model 3850-267 (1) ONLY
Motor Unit with Light Lenses
2-Conductor Bell Wire White & White/Red
Belt Pulley Bracket
Trolley
Optional EBvearttCehryarge® Stan(PdbacykPeodwSeerpSaryastteelym) (battery... below .
Carton Inventory
Your garage door opener is packaged in the foam. Accessories will depend on the model purchased.
3850 Elite Series Manual - Page 6
...the rail into one of motor unit.
To avoid SERIOUS damage to opener, ONLY use any other bolts will cause serious damage to do so...open end wrench on the square end. Tighten bolts securely. This extends the spring for optimum belt tension. ASSEMBLY STEP 1 Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to door opener...
3850 Elite Series Manual - Page 7
... garage door opener. Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing opener to do so.
8. Install wall-mounted garage door control:
• within sight of the garage door.
• out of reach of children at minimum height of 5 feet (1.5 m).
• away from ALL moving garage door opener: • ALWAYS keep hand clear of belt pulley while operating
opener...
3850 Elite Series Manual - Page 11
... outer trolley toward the motor unit. INSTALLATION STEP 4
Position the Opener
Follow instructions which apply to determine
the correct mounting height
from ceiling. Rail
Door
2x4 is used to your door type as a support, raise the top of Door
2x4 is used to garage door, rest garage door opener rail on 2x4 placed on the trolley release arm to...
3850 Elite Series Manual - Page 12
... Measure the distance from a falling garage door opener, fasten it SECURELY to opener at this time. Fasten the opener to make sure the rail is centered over the door (or in the structural supports. ...
(Not Provided) Bolt 5/16"-18x7/8" Lock Washer 5/16" Nut 5/16"-18
12 Operate the door manually. Grease the top and underside of the motor unit to provide rigid support. Concrete...
3850 Elite Series Manual - Page 13
... provided. If installing into gang box) as in several places. NOTE: The functional temperature range of the door control is properly adjusted and there are desired to operate the same garage door opener, it is not connected BEFORE installing door
control. • Connect ONLY to a single gang box (Figure 1). If additional wall controls are no obstructions...
3850 Elite Series Manual - Page 14
... ONLY incandescent. ALWAYS wear protective gloves and eye protection when changing the battery or working around the battery compartment. Light bulb size should be A19, standard neck only. To prevent damage to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is connected. Release Tab
100 Watt...
3850 Elite Series Manual - Page 15
... a falling garage door: • If possible, use emergency release handle unless garage doorway is 6 feet (1.8 m) above the floor.
To make it is required by your garage door opener has a... electrocution or fire:
• Disconnect ALL electric and battery power BEFORE performing ANY service or maintenance.
• Garage door installation and wiring MUST be grounded.
• Reinstall ...
3850 Elite Series Manual - Page 16
... eye (with an amber indicator light) transmits an invisible light beam to the garage door opener BEFORE installing the safety reversing sensor. Safety Reversing Sensor 6" (15 cm) max. above garage floor. To prevent SERIOUS INJURY or DEATH from inside the garage so that the sending and receiving eyes face each location to clip onto the...
3850 Elite Series Manual - Page 24
... reverse on contact with 1-1/2" (3.8 cm) high object (or 2x4 laid flat) on garage door will interfere with proper operation of force required to open and close the door fully, inspect the door to ensure that it , repeat Program the Travel Limits. Push the door control or programmed remote control a third time to close (DOWN).
3.
Figure 1
n n
LED
Black...
3850 Elite Series Manual - Page 25
... flat) on the floor, centered under the garage door.
• Operate the door in the down position.
Without a properly installed safety reversing sensor, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door. • Safety reversal system MUST be tested. If the opener closes the door when the safety reversing sensor is obstructed (and...
3850 Elite Series Manual - Page 26
... no effect in SEVERE INJURY or DEATH.
13. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 3). Your opener will close the door with up to pull garage door open or closed , it can close . See Programming. If the door has been stopped in an open , the door will operate with the door control, the Outside Keylock, or Keyless Entry, if you wish...
3850 Elite Series Manual - Page 31
... direction. • Verify the safety reversing sensors are properly installed,
aligned and free of the battery. • A flashing LED with beep, sounding approximately every 2 seconds, indicates the motor unit is activating the door and is operating off when door is open: • The garage door opener is normal. If it does, deactivate the Lock Mode following page.
2. My...
3850 Elite Series Manual - Page 32
...
Diagnostic Chart
Diagnostics Located On Motor Unit
"Learn" Button LED or Diagnostic LED "Learn" Button
Installed Safety Reversing
Sensor
Your garage door opener is programmed with jumper wire. If motor unit activates, replace door control wires. If the sensor indicator lights do not glow steady.
• Inspect sensor wires for the sensors. The "Learn...
3850 Elite Series Manual - Page 34
... light bulbs are instructions for 30 seconds.
2. If light bulbs are now erased.
PROGRAMMING
NOTICE: If this Security✚® garage door opener is operated with your garage door opener, the large button is factory programmed to operate it has learned the code.
USING THE "LEARN" BUTTON
To Add or Reprogram a Hand-held remote that technical measure. The...
3850 Elite Series Manual - Page 35
... of your garage door opener.
The door should move . The opener light will be heard.
2. If light bulbs are not installed, two clicks will glow steadily for 30 seconds. The opener light will ...programmed to operate your choice on the keypad.
Press the PROG button again to 0 in step 3. It has learned the code. Press the four buttons for your choice on the door control.
2....
3850 Elite Series Manual - Page 38
... for the largest door of your garage door is designed to protect LiftMaster® garage door openers against damage from ...operate garage door opener from lightning and power surges.
38
Includes battery.
Tells you if your home! SECURITY✚® 4-Button Remote Control : Includes visor clip. Surge Protector: The Garage Door Opener Surge Protector is open garage door...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
How To Change The Battery In Elite Series 3850 Garage Door Opener Bad Battery
message
message
(Posted by alcodaca 10 years ago)
If You Take Out The Back Up Battery On A Elite 3850 Garage Door Opener, It Will
still operate when the electric is on won't it. i have a low back up battery.
still operate when the electric is on won't it. i have a low back up battery.
(Posted by szenov 10 years ago)
Where To Buy Batteries For A Model 3850 Elite Series Garage Door Opener
(Posted by NADGmark85 10 years ago)