Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by alberthch68 on September 11th, 2014
My Washer Don't. Spin
The person who posted this question about this Kenmore product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by BusterDoogen on September 11th, 2014 2:32 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,407
Member since:
October 30th, 2011 Points: 28,565,407
Go here for the possible part failures & repair guidance.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Kenmore HE2t Manual Pages
User Guide - Page 8
SPECIFICATIONS
Model Number Model Description
Color
Capacity (Cu.Ft. Max
Width Product Weight (approx)
WFW8300SW
WFW8500SW
WFW8500SR
Front Load Washer
Front Load Washer
Front Load Washer
White with Gray Accents
White with Gray Accents...
1-4 IEC) Temperature Control
Heater Sensors
Tumble Speed
Spin Speed
Motor Voltage Frequency Amps Water Consumption Average DOE (Gallons-Per-Cycle) Rated...
User Guide - Page 19
... wash more water extraction, reducing drying time. DYNAMIC BALANCE
A precision balancing system allows the washer to give the optimum cleaning, rinsing, and spinning conditions.
The washer spins faster so that they are evenly balanced.
3-1 SUSPENSION SYSTEM
To reduce washer "walk" and "off -balance loads during spinning, it redistributes the clothes so that clothes coming out of the...
User Guide - Page 22
... Wash Cycle Without Laundry
Before washing clothes for the best performance. Place a load of suds for the first time, if not completed during the wash cycle. Close the washer door by turning ...Select and hold START (for a medium-sized load. When selecting a Wash Cycle, the preset Modifiers and Options, Water Temp, and Spin Speed for the selected cycle will be opened ...
User Guide - Page 24
...an oversudsing condition.
Select the desired OPTIONS. To drain the washer manually
1.
Chlorine bleach compartment (Letter C in the EXTRA...and hold START (for approximately 1 second) to your load.
• Always measure liquid chlorine bleach.
Select desired... more than the manufacturer's recommended amount.
Select DRAIN/SPIN.
3.
To stop a cycle and select a new...
User Guide - Page 25
...automatically, depending on the stage of your water pressure, water temperature, detergent, and clothes load. Locking controls
The Control Lock avoids unintended use the control lock feature to avoid unintended ...different types of the washer.
The washer door unlocks, and items can lock the controls while the washer is lit, all Options and Modifiers (WASH TEMP, SPIN SPEED) are shown ...
User Guide - Page 26
.../Hand Wash
Use this cycle to wash loads of 2-3 lightly soiled garments that you set your laundry. See chart.
This cycle combines fast-speed tumbling, longer wash time, and high-speed spin to shorten drying time. Large wash loads will be extended if oversudsing occurs or the load is recommended that are needed in the...
User Guide - Page 27
.... Rinse/Spin
Use this cycle to drain your wash load. Drain/Spin
Use this cycle to drain and spin your washer or to get a rinse and spin only. Clean Washer
Use the Clean Washer cycle once....
3-9 These new sounds and pauses are available with all cycles.
• See the "Laundry Guide" section for that need rinsing only.
• Adding fabric softener to avoid fabric stress...
User Guide - Page 28
...of the dispenser drawer.
• Use powdered detergent to keep laundry additives from the washer as soon as in the normal rinse. Prewash
Use this option...Spin Speed
Each cycle has a preset SPIN SPEED. Extra Rinse
An extra rinse can be difficult to remove.
The water temperature for all rinse cycles is illuminated.
You may be used to aid in "Cycles."
• ATC works for loads...
User Guide - Page 29
... Wash
Curtains and delicate clothing, dresses, skirts, shirts and blouses, fabrics made of silk, and special care items marked "Hand Washable"
Clean Washer No clothes
Rinse & Spin
All loads
Drain & Spin
All loads
Soak
All loads
Delay Wash
AVAILABLE OPTIONS
Extra Rinse
Pre
End of these washer cycles. LAUNDRY GUIDE
Refer to each of
Wash Cycle Signal
3-11
User Guide - Page 30
... the Door Seal/Bellow
1. Open the washer door and remove any items are detected in combination with liquid chlorine bleach to check for stained areas. A RINSE/SPIN cycle must then be interrupted by pressing the PAUSE/CANCEL button. Failure to the bleach compartment. c) Let stand 5 minutes. b) If any clothing or items from...
User Guide - Page 31
... products.
Cleaning the dispenser drawer
The dispenser drawer is complete, leave the door open, slightly, to allow the cycle to complete.
9.
Unplug washer or disconnect power.
4. Turn on a Drain/Spin cycle.
3. Use mild soap and water.
Reconnect water inlet hoses to the drawer.
Wash the parts under running water. Periodically inspect and...
User Guide - Page 32
... the power cord.
3. Use only HE High Efficiency detergent. Failure to locate, level and connect the washer.
2. Use 1/2 the manufacturer's recommended amount for a medium sized load. Run washer on a Drain/Spin cycle.
2. Reinstalling the washer
1.
Disconnect the water inlet hoses from the drain system and attach to the rear panel of R.V.-type antifreeze...
User Guide - Page 33
... hose kinked, frozen, clogged, or more than 96˝ (2.4 m) above the floor?
• Is washer installed on ? Are screens at equal heights.
• Is the washer gurgling or humming? Are water inlet hoses kinked? Select DRAIN/SPIN if there is normal.
• Were the 4 shipping bolts in the back of draining. The...
User Guide - Page 34
... to the drainpipe or laundry tub. To avoid odors leave the door open after the start of the washer.
• Are the fill hoses tight?
• Are the fill hose gaskets properly seated? This is opened during the spin? A small amount of each hose. The non-High Efficiency detergents...
User Guide - Page 35
...Is the power cord plugged into a grounded 3 prong outlet. Wash smaller loads.
• Is the washer door firmly shut? WASHER CONTINUES TO FILL OR DRAIN, DRAIN CYCLE SEEMS STUCK
• Is the ...Is the washer overloaded? Do not seal the drain hose with tape. WASHER WON'T DRAIN OR SPIN, WATER REMAINS IN WASHER
• Is the drain hose clogged, or the end of last cycle? WASHER STOPS
...
User Guide - Page 36
... The options you use small loads. The Quick Wash cycle is designed for your water pressure, water temperature, detergent, and clothes load.
If the laundry is unbalanced. GRAY WHITES, ...(15.6°C) may decrease for the fabric load. Use enough HE detergent to redistribute the load with a higher spin speed.
• Did you overload the washer? A single item, bulky items, or ...
User Guide - Page 37
...8226; Did you use Quick Wash on a large load? See "Connect the Inlet Hoses."
3-19 Unload the washer as soon as it stops.
• Did you...load, use Quick Wash for the load being washed? Powdered detergents may not dissolve well in a lowspeed cycle? For best results, use a fabric softener dispensing ball? A hot rinse followed by spin will not operate correctly with a low spin...
User Guide - Page 80
...washer or disconnect power. 8. Door switch/lock unit failure.
1. Unplug washer or disconnect power. 2. HEATER FAILURE If the temperature increase during high-speed spin the door unlocks after 6 minutes. Unplug washer...the water temperature sensor (NTC) value is broken or removed from door. Unplug washer or disconnect power. 2.
Possible Causes/Procedure Replace CCU board.
Check the drive ...
User Guide - Page 81
... chart, page 6-4
DOOR SWITCH ERROR
If the door has not been opened during high-speed spin, the door unlocks after 3 minutes. Verify CCU operation by running a Diagnostic Test or any...manually unlocked.
NOTE: The door switch/lock unit can be to the top
of the CLEANING WASHER cycle a load is closed .
2. Check for operations of heat and has proper ventilation. 2. Verify CCU ...
User Guide - Page 82
... CYCLE)
If suds are detected continuously by running a Diagnostic Test or any detergent. Verify CCU operation by the pressure switch during the drain or spin phases, the washer will fill 4 liters of water and during 5 minutes the unit will rest without adding any
cycle.
Check drain pump. 7. They use the status lights...
Similar Questions
F1 Code On Washer; What Does It Mean?
Not draining and posibally not spinning correctly.
Not draining and posibally not spinning correctly.
(Posted by mannbuilder65 9 years ago)
How Can I Clean My Kennmore Washer Machine?
(Posted by Mariavargas1102 9 years ago)
Kenmore He2t Washer Won't Spin
(Posted by babskhell 10 years ago)
My Washer Won't Spin. How Do I Make It Work Again
(Posted by luedog35 11 years ago)
Kenmore - Washer Does Not Spin-dry If Absorbent Clothes Included. Worn Belt?
Washer does not spin-dry if heavier clothes are in load--such as flannel pajamas, polo shirts, towel...
Washer does not spin-dry if heavier clothes are in load--such as flannel pajamas, polo shirts, towel...
(Posted by JimNelsonGlobal 11 years ago)