Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by htevanz on August 22nd, 2011
How To Use Rinse Cycle On Washer Model 110, Type 501?
How do I use rinse onbly cycle on this washer? This is not clearly shown in the manual that came with the washer.
Thanks,
Tom Evans
Current Answers
Related Kenmore HE2t Manual Pages
User Guide - Page 1
CONSUMER SERVICES TECHNICAL
EDUCATION GROUP PRESENTS L-78
FRONT-LOADING AUTOMATIC WASHER
MODELS: WFW8300SW, WFW8500SW, WFW8500SR
JOB AID Part No. 8178558
User Guide - Page 3
iii - TABLE OF CONTENTS
Page
GENERAL 1-1 Washer Safety 1-1 Model & Serial Number Designations 1-2 Model & Serial Number Label And Tech Sheet Locations 1-3 Specifications 1-4
INSTALLATION INFORMATION 2-1 Installation Requirements 2-1 Installation Instructions 2-6
PRODUCT OPERATION 3-1 Features And Benefits 3-1 Washer Use 3-3 Washer Care 3-12 Troubleshooting 3-15
COMPONENT ACCESS 4-1...
User Guide - Page 8
...Speed
Motor Voltage Frequency Amps Water Consumption Average DOE (Gallons-Per-Cycle) Rated Load Load Pounds
Height Install Depth: Min - SPECIFICATIONS
Model Number Model Description
Color
Capacity (Cu.Ft. Max
Width Product Weight (approx)
WFW8300SW
WFW8500SW
WFW8500SR
Front Load Washer
Front Load Washer
Front Load Washer
White with Gray Accents
White with Gray Accents
White with Sterling...
User Guide - Page 19
... a conventional washer. For some cycles, the default spin speed can handle slow speeds needed for delicate items and is used, the washer saves energy, too.
DYNAMIC BALANCE
A precision balancing system allows the washer to give the optimum cleaning, rinsing, and spinning conditions. The time of the washer will illuminate for small and large loads size. The washer spins faster...
User Guide - Page 20
SMART DISPENSERS
The three compartments in the dispenser allow loading of the cycle, and the bleach is
added after the enzymes have had a chance to do their cleaning. The bleach release system is dispensed in the rinse cycle or in the detergent advantage system. Use only HE High Efficiency detergent.
3-2
The fabric softener is included in...
User Guide - Page 21
... not store laundry products on it (including cooking oils). Vibration is a guide to using the washer. Do not dry anything that are dampened with gasoline or other flammable fluids. The following is normal during operation.
3-3 Please refer to persons, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. WASHER USE
MODEL WFW8300S
MODEL WFW8500S
STARTING...
User Guide - Page 22
... will likely result in washer errors, longer cycle times, and reduced rinsing performance. If desired, select the END OF CYCLE SIGNAL. USING THE PROPER DETERGENT
Use only High Efficiency detergents. It may also result in the "Changing Cycles and Options Section."
3. First Wash Cycle Without Laundry
Before washing clothes for the best performance. Load evenly.
• Wash small...
User Guide - Page 23
... compartment since liquid detergents may seep out of detergent to use the proper dispensers when adding laundry additives. Always use .
The washer powers down the washer manually after the cycle is complete, the CYCLE COMPLETE status light illuminates, the door unlocks, and the wash load can be removed from the washer. The countdown to add them. It is for your...
User Guide - Page 24
....
To drain the washer manually
1. Items can add an additional item to add powdered chlorine or any time, select PAUSE/CANCEL.
2. NOTE: Overfilling could cause garment damage. To pause the washer at the best time during the first rinse after the cycle has started
1. To stop a cycle and select a new cycle
1. The washer powers down...
User Guide - Page 25
... controls while the washer is operating. You can also use of your water pressure, water temperature, detergent, and clothes load.
Estimated Time Remaining
The cycle times vary automatically based on your garments. The SUDs routine removes extra suds and assures proper rinsing of the washer. The door is designed for different types of the wash cycle.
The indicator...
User Guide - Page 26
..., high-speed spin, and a load cooling process to shorten drying time. Preset Cycle Settings
Each cycle has a preset Cycle Time, WASH/ RINSE TEMP, and SPIN SPEED.
It is especially designed for the selected cycle. Quick Wash
Use this cycle. Cycle
Sanitary Whitest Whites Heavy Duty Normal/Casual Quick Wash (2-3 items) Delicate/ Hand Wash Clean Washer Rinse/Spin Drain/Spin Soak
Estimated...
User Guide - Page 27
... the laundry, and a soaking time without spin assures gentle treatment, even for delicate items.
NORMAL SOUNDS
As with a selected cycle, there will be a short tone and the light for :
• Loads that option will hear water spraying and splashing during the wash and rinse cycles. Delay Wash Use this cycle to drain your washer fresh and clean. This cycle uses...
User Guide - Page 28
... on the type of the dispenser drawer.
• Use powdered detergent to keep laundry additives from prewash into the wash system. Soils may select or deselect by pressing EXTRA RINSE.
To change the spin speed, select the SPIN SPEED button until the desired setting is selected. Use the warmest wash water safe for loads of Cycle Signal...
User Guide - Page 29
Listed to the right are the options available to the chart below for suggested load types and their corresponding cycles.
CYCLE
SUGGESTED LOAD TYPE
Sanitary
Heavily soiled underwear, towels, work cloths, diapers, etc. LAUNDRY GUIDE
Refer to each of
Wash Cycle Signal
3-11 Whitest Whites Soiled white fabrics
Heavy Duty
Heavily soiled underwear, towels, shirts, etc., made of cotton...
User Guide - Page 31
...type antifreeze in the drum.
2. When replacing your installation and usage conditions for better ventilation and drying of your washer. Always do the following to maintain washer freshness
• Use...Non-use to faucets.
3. Turn on a Drain/Spin cycle.
3. To use abrasive products.
NOTE: Do not wash components in the hoses, freezing can damage your washer to the washer. ...
User Guide - Page 32
... the "Installation Instructions" to the rear panel of R.V.-type antifreeze in death, fire, or electrical shock.
4. Use 1/2 the manufacturer's recommended amount for a medium sized load. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Use 1/2 the manufacturer's recommended amount for a medium sized load.
3-14 If washer will be moved during freezing weather, put in...
User Guide - Page 33
...rinse cycles.
The four feet should be properly installed, and the nuts should be level. You may be shown in the washer. These new sounds and pauses are part of draining. Do not use an adapter. Refer to cancel the cycle.... If the washer is excessive water in the Estimated Time Remaining display (on some models).
• "Spin" and "Wash" (HT "Rinse" and "Cycle Complete") illuminated...
User Guide - Page 35
...is a low sudsing detergent. Do not use an adapter. Wash smaller loads.
• Is the washer door firmly shut? The door must be closed again to the standpipe? WASHER CONTINUES TO FILL OR DRAIN, DRAIN CYCLE SEEMS STUCK
• Is the top of...suds? Do not remove ground prong. Remove any accumulated film or particles. WASHER OPERATION
WASHER WON'T RUN, FILL, RINSE, OR TUMBLE;
User Guide - Page 36
... bulky load?
For best performance, use small loads. Use hot or warm washes if safe for your garments. CYCLE TIME CHANGES/CYCLE TOO LONG
• Estimated cycle time? The SUDs routine removes extra suds and assures proper rinsing of the washer and try to evenly distribute your water pressure, water temperature, detergent, and clothes load. When excessive suds are shown in...
User Guide - Page 82
... drained and it is not plugged or kinked.
2. They use the status lights on the touchpad/LED. Run a NORMAL cycle without tumbling, the water will rest without adding any
cycle. This should clear the unit of water and during the drain or spin phases, the washer will try to spin or drain again. Check drain...
Similar Questions
Kenmore He2 Model 110.47561600 F20 Error Code.
6 minutes into any cycle the washer stops filling and shows the F20 error code. After researching th...
6 minutes into any cycle the washer stops filling and shows the F20 error code. After researching th...
(Posted by riskoj 6 years ago)
Where Is The Filter Located On A Kenmore Washing Machine Model 110 24622300?
(Posted by rlhaan36 8 years ago)
Kenmore Model 110.22722101 Washer Capacity?
what is the washer tub capacity of a kenmore model 110.22722101 washer?
what is the washer tub capacity of a kenmore model 110.22722101 washer?
(Posted by msp82756 10 years ago)
Kenmore He2t Front Loading Washer Model# 110.4756
When I turn power on the front panel lights up, but when I push start it all shuts down. Tried unplu...
When I turn power on the front panel lights up, but when I push start it all shuts down. Tried unplu...
(Posted by cpcalder 11 years ago)
Kenmore Washer Not Working Model 110.21202010
Washer not working. comes on, fill light on lid lock light on , moves a few times no fill, then lid ...
Washer not working. comes on, fill light on lid lock light on , moves a few times no fill, then lid ...
(Posted by dalston613 12 years ago)