Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by carlab504 on February 20th, 2014
Where Can I Find A Manual For A Kenmore 158.1320 Sewing Machine?
The person who posted this question about this Kenmore product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TheWiz on February 20th, 2014 4:08 PM
TheWiz
Member since:
October 13th, 2011 Points: 25,383,424
Member since:
October 13th, 2011 Points: 25,383,424
The manual is not available for viewing online but you can buy a physical copy from here.
Related Kenmore HE2t Manual Pages
User Guide - Page 4
... 6-1
Diagnostics 6-1 Diagnostic Guide 6-1 Failure/Error Display Codes 6-2 Diagnostic Test 6-5 Error History Display 6-6 History Overview Test Program 6-6 Manual Diagnostic Test 6-7 Manual Overview Test Program 6-7 Electronic Assemblies - iv - Removal Or Replacement 6-8 Washer Care 6-9
Troubleshooting Guide 6-11 WIRING DIAGRAMS 7-1
Washer 7-1 Grounding System 7-2
-
User Guide - Page 14
...is seated on the washer.
3. Damage to be transported at a later date, call your machine must be properly set up for relocation by hand until it is loose, move and install washer.
Washer
Connect the inlet ... the washer so that the rear of the unit is to the valves can result in back or other injury. NOTE: If the washer is within approximately 3 ft (90 cm) of the washer that ...
User Guide - Page 16
...excess hose on your washer will minimize excessive noise and vibration. 1. Slide the washer to its final location.
3. Confirm the levelness of the washing machine top plate, the machine should be tightened. To... hose back into the rear of the laundry tub. Properly leveling your new washer. Push on the rear feet. If the washer is against the washer cabinet. First prop the front with a...
User Guide - Page 19
...default spin speed can obtain the same results with traditional top load machines. When this option is available in which means fewer loads.
ADD A GARMENT
This option is available at the beginning... the amount of operation may be added to a high-speed spin.
This washer offers up to a load. This washer allows a 7-minute period in all wash cycles except Rinse/Spin and Drain/...
User Guide - Page 21
... of this manual for more detailed information. Do not dry anything that are dampened with gasoline or other flammable fluids.
WARNING: To reduce the risk of fire, electric shock, or injury to specific sections of this appliance.
Vibration is a guide to using the washer.
Do not store laundry products...
User Guide - Page 23
...proper dispensers when adding laundry additives. • When the wash cycle is complete, the CYCLE COMPLETE status light illuminates, the door unlocks, and the wash load can be marked ... and noticeable mold or mildew. The washer powers down the washer manually after the cycle is complete and the CYCLE COMPLETE light goes off.
Laundry additives are made to the
proper compartment...
User Guide - Page 24
... Options after the wash cycle. To drain the washer manually
1. When the spin is not available, the machine will be removed from the washer.
Add no more than the manufacturer's recommended amount...comes with the detergent. Follow the manufacturer's directions for approximately 1 second) to your load.
• Always measure liquid chlorine bleach. Select the desired OPTIONS.
4. NOTE: ...
User Guide - Page 26
... Large wash loads will be extended if oversudsing occurs or the load is recommended that are needed in the machine increasing the wash...Sanitary
Use this cycle to avoid chlorine residues on your laundry. The Sanitary cycle also helps eliminate 99.999% of... Duty Normal/Casual Quick Wash (2-3 items) Delicate/ Hand Wash Clean Washer Rinse/Spin Drain/Spin Soak
Estimated
Time* (hr:min)
Wash Temp...
User Guide - Page 27
...an empty wash tub. See "Troubleshooting." Not all cycles.
• See the "Laundry Guide" section for :
• Loads that you want from the SPIN SPEED modifier.
If desired, you can ... washer operation.
NOTE: Loads of set -in wash actions, there will show in the washer during the wash and rinse cycles. Soak
Use the Soak cycle to drain and spin your washing machine...
User Guide - Page 30
...flash and the WASH and CONTROLS LOCKED lights will remain lit. Begin procedure
1. Open the washer door and remove any detergent to the next cycle.
a) Mix a dilute solution, using 3/4 cup... cycle will continue.
• The machine will not fill, but the basket will take approximately 3 minutes.
7. a) If no items are detected in the washer.
• Wear rubber gloves when ...
User Guide - Page 31
... chlorine bleach.
• If the procedure does not sufficiently improve the machine freshness, please evaluate your installation and usage conditions for an extended period of your washer during freezing weather, winterize it looking new. Put 1 qt (1 L) of washer interior. Flush water pipes.
2. 8. Once the cycle has begun, allow for easy cleaning...
User Guide - Page 32
...avoid suspension and structural damage, your machine must be moved during freezing weather, put in 1 qt (1 L) of the washer.
6. Run the washer through the Normal/Ca- Plug in ...the manufacturer's recommended amount for a medium sized load.
3-14 Reinstalling the washer
1. Use 1/2 the manufacturer's recommended amount for a medium sized load. Do not use an extension cord. Use ...
User Guide - Page 33
... DRAIN/SPIN if there is normal.
• Were the 4 shipping bolts in the back of the machine removed? The four feet should be properly installed, and the nuts should be reduced by placing a piece of the washer must be momentary pauses. Check the following : Are water faucets completely turned on a sturdy and...
User Guide - Page 77
...to connector pins 1 and 2.
Touch the ohmmeter test leads to the two terminals. Unplug washer or disconnect power.
2. To check the temperature sensor at the component terminals, perform the ...;C)
86°F (30°C) 104°F (40°C) 122°F (50°C) 140°F (60°C) 158°F (70°C) 203°F (95°C)
Results 35.9k Ω
9.7k Ω 6.6k Ω 4.6k...
User Guide - Page 80
... both valves at the pump and make sure it . Verify pressure switch operation.
8.
Plug in washer or reconnect power. 4. Reference Status LEDs chart, page 6-4
Reference Status LEDs chart, page 6-4
... be displayed.
Verify CCU operation by running a Diagnostic Test or any cycle.
The machine will drain for two minutes. -
Check the wire harness connections to it. 3....
User Guide - Page 81
...for any worn or failed components. 5. The wires should be manually unlocked.
Possible Causes/Procedure Door lock mechanism is lost. Check...clothes from dispenser motor to properly detect motor speed, the machine shuts down . Push the door and check if it... door is not located
near a source of the CLEANING WASHER cycle a load is closed .
2. OVERFLOW CONDITION
If the overflow contact on...
User Guide - Page 85
... the test.
Drum rotates counter-clockwise and ramps up to 0 rpm. MANUAL DIAGNOSTIC TEST
The washer must be empty and the control must be Checked
Door lock system
Dispenser Motor...To be in the OFF state before replacing the system components. Press/ hold 4 sec's. MANUAL OVERVIEW TEST PROGRAM
Be sure to perform the Diagnostic Tests before pressing the touchpad sequence to Main...
User Guide - Page 86
...;C) 122°F (50°C) 140°F (60°C) 158°F (71°C) 203°F (96°C)
Results 35.9k Ω 9.7k Ω 6.6k Ω 4.6k Ω 3.2k Ω 2.3k Ω
1k Ω
Manually Unlocking the Door Lock System 1. Remove the lower kick panel. 3. Unplug washer or disconnect power.
2. Located on the top of...
User Guide - Page 88
... basket will rotate, then the door will unlock, lock again, and then the cycle will continue.
• The machine will not fill, but the basket will unlock. a) If no items are in the washer. Then repeat steps 1, 2 and 6 to cancel the failure code. After the cycle is complete, leave the door...
User Guide - Page 90
...pump filter are connected properly.
2. Check wire harness connections. 3. MACHINE VIBRATES
1. Check drain pump. 4. Unplug washer or disconnect power.
3. PROBLEM WON'T DRAIN
POSSIBLE CAUSE/TEST
NOTE: Possible Cause/Tests must... be performed in washer or reconnect power. 7. Check that the inlet hoses are clear
of foreign ...
Similar Questions
Kenmore He2 Model 110.47561600 F20 Error Code.
6 minutes into any cycle the washer stops filling and shows the F20 error code. After researching th...
6 minutes into any cycle the washer stops filling and shows the F20 error code. After researching th...
(Posted by riskoj 6 years ago)
How Can I Clean My Kennmore Washer Machine?
(Posted by Mariavargas1102 9 years ago)
Cleaning Washer
I have a Kenmore Vibration Guard front load washer. How do I clean it? I can't find the manual.
I have a Kenmore Vibration Guard front load washer. How do I clean it? I can't find the manual.
(Posted by Jduppler 9 years ago)
Kenmore Elite Front Load Washer Manual Who Used 4.7
(Posted by Loversemc 10 years ago)
I could provide User Manual Kemore The Washing Machine Series 80 11,020,802
I could provide the instruction manual of the washing machine 80 series 110 20,802,991 kemore.
I could provide the instruction manual of the washing machine 80 series 110 20,802,991 kemore.
(Posted by janli 10 years ago)