Kenmore 4810 Support Question
Kenmore 4810 Support Question
Find answers below for this question about Kenmore 4810 - 3.5 cu. Ft. I.E.C. High-Efficiency Washer.Need a Kenmore 4810 manual? We have 2 online manuals for this item!
Question posted by juanitasmith51 on August 21st, 2014
Best Cycle To Use To Clean Washing Machine To Get Rid Of Funky Smell?
The person who posted this question about this Kenmore product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TommyKervz on August 21st, 2014 10:28 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Watch the video for instructions below
http://m.youtube.com/watch?v=0IyRgsFXOVk
Or go on this link
http://www.pinterest.com/explore/washing-machine-smell/#
http://m.youtube.com/watch?v=0IyRgsFXOVk
Or go on this link
http://www.pinterest.com/explore/washing-machine-smell/#
Related Kenmore 4810 Manual Pages
Operating Instructions - Page 1
... the fabric care label instructions on items to resume the cycle. • If the cycle is lighted. Pretreat stains and heavy soil.
4. FOR BEST RESULTSAHIGH EFFICIENCY /_"_em_'__,
_G
WASHERS MUST BE USED.
(q_..._'
" if desired, add liquid chlorine bleach and liquid fabric softener to the wash drum.
5. DELAY START Pause
START
Cancel
6. It will not operate...
Operating Instructions - Page 2
.... If the water temperature combination is much faster than High Speed in a regular cycle. Settings cannot be machine
dried.
Wash / Rinse Water Temperatures
Select the wash and rinse water temperatures appropriate for the load.
The speeds will not be used . For example, High Speed in the Normal cycle is not appropriate for that contains enzymes and the hottest...
Operating Instructions - Page 3
...Warm/Warm Hot/Cold Speed High Spin
Medium Spin Low Spin Hang Dry
No Spin Options Cycle Signal
Heavy
Normal
Perm Press...,/
,/
,/
* Factory Settings
,/ Available settings
** Estimated cycle duration is based on factory settings and does not
include water fill times, out-of-balance or oversudsing corrections.
WASHER SETTINGS CHART
The following chart shows the temperatures, spin speeds and...
Installation Instructions - Page 1
... 134906800(0706) do not use gasoline or other flammable vapors and liquid in this or any other appliance.
- Printed in your gas supplier from a neighbor's phone. Leave these instructions.
This will simpfify the installation and ensure the washer is installed correctly and safely.
WHAT TO DO IF YOU SMELL GAS • Do not...
Installation Instructions - Page 2
...type so inlet hoses can reach a 90 in. (229 cm) high standpipe. A standpipe diameter of electrical shock. l
II
NOTE: Drain hose attached to the washer can be : Minimum height: 24 in. (61 cm) Maximum ...SUPPLY REQUIREMENTS
Hot and cold water faucets MUST be grounded. For higher standpipe, use of your washer is equipped with a power supply cord having an equipment-grounding conductor and a ...
Installation Instructions - Page 4
... of the floor may be necessary. Floor MUST be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. IMPORTANT MINIMUM INSTALLATION CLEARANCES When installed in alcove or closet:
Sides, Rear = 0 in.... protect the floor, lay the washer on it will come in contact with a maximum slope of 1/2 in. per foot (1.27 cm per 30.5 cm). Using a rug, blanket or piece ...
Installation Instructions - Page 5
.... Tighten by hand, then tighten another 2/3 turn with
pliers.
Adjust the leveling legs so the washer is SOLID on the floor on and check for best performance of the inlet hoses. Adjust the appropriate leg so the washer is level front-to-rear and side-to-side, and stable comer-to the inside...
Installation Instructions - Page 6
.... Failure to use accessories certified by the manufacturer could result in an envelope attached to the standpipe, inlet hose, laundry tub, etc. Children might use .
so the...use them for water leaks and proper operation. Place the hook end of the water.
7. Run the washer through a complete cycle.
J Operating instructions are understood and practiced as a routine with your washer...
Similar Questions
Kenmore Elite Washing Machine Code F73
I'm I'm having trouble with my Kenmore elite front washing machine. It keeps bringing up the code f7...
I'm I'm having trouble with my Kenmore elite front washing machine. It keeps bringing up the code f7...
(Posted by wickedjuggalette8908 3 years ago)
I could provide User Manual Kemore The Washing Machine Series 80 11,020,802
I could provide the instruction manual of the washing machine 80 series 110 20,802,991 kemore.
I could provide the instruction manual of the washing machine 80 series 110 20,802,991 kemore.
(Posted by janli 10 years ago)
Beeping
Front loading washing machine seems to be working correctly but there is a constant beeping.
Front loading washing machine seems to be working correctly but there is a constant beeping.
(Posted by bobhill 10 years ago)
Can't Change 'options' Feature On Kenmore 48102 Washing Machine.
(Posted by daryldean 10 years ago)
I Replaced The Door Latch Lock On My Front Load Washer The Washer Won't Come On
I was told the door lock latch needed to be replaced. When the door latch lock was replaced the wash...
I was told the door lock latch needed to be replaced. When the door latch lock was replaced the wash...
(Posted by reginaharvey 11 years ago)