Husqvarna HU775L Support Question
Husqvarna HU775L Support Question
Find answers below for this question about Husqvarna HU775L.Need a Husqvarna HU775L manual? We have 2 online manuals for this item!
Question posted by Anonymous-139489 on July 6th, 2014
What Size Plug?
I need to buy a lug to replace the mower plug but can't determine the size
Current Answers
Answer #1: Posted by freginold on July 7th, 2014 3:19 AM
freginold
Member since:
December 20th, 2011 Points: 23,253,885
Member since:
December 20th, 2011 Points: 23,253,885
Hi, if you mean the spark plug, according to the owner's manual you need a Champion 696073 spark plug.
If you mean the plug for the top of the handles, according to the parts manual you need part# 532 43 75-16.
If you mean the plug for the top of the handles, according to the parts manual you need part# 532 43 75-16.
Related Husqvarna HU775L Manual Pages
Operation Manual - Page 2
....
• Watch for proper operation and installation of a new lawn mower. Keep clear of the discharge opening at all instructions on a slope, do not mow it cannot contact spark plug in the manual(s) before starting when setting up and down and behind power lawn mowers conform to the safety standards of California to vibrate abnormally...
Operation Manual - Page 3
... liner. cool before restarting. lbs.
• Maintain or replace safety and instruction labels, as a water heater or on ...plug to the presence of this is an open device.
• If fuel is spilled on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine's exhaust system is sharp and can occur if the operator is available through your lawn mower...
Operation Manual - Page 4
... of those parts left unassembled for shipping purposes. Vinyl bindings 2. IMPORTANT: THIS LAWN MOWER IS SHIPPED WITHOUT OIL OR GASOLINE IN THE ENGINE.
If bag gets wet, ...the parts bag.
To ensure safe and proper operation of bag on your lawn mower to familiarize yourself with your lawn mower or in warm water for future reference. Description
Qty. Handle Bolt
2
Handle...
Operation Manual - Page 5
... section of carton and lay end panel down two end corners of this manual.
1
LIFT UP
LIFT UP
MOWING POSITION
2 3 4
Figure 3 1. Handle knob 4. TO REMOVE LAWN MOWER FROM CARTON
1. Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to be adjusted for additional...
Operation Manual - Page 7
... to be replaced.
1
2
1
TO ENGAGE DRIVE CONTROL
Figure 6
1. Drive control levers
Figure 8 1.
The further toward the handle a lever is not adjustable. Turn unit off; The operation of the operator control.
ENGINE ZONE CONTROL
CAUTION: Federal regulations require an engine control to minimize the risk of blade contact injury. NOTE: Your lawn mower is...
Operation Manual - Page 8
... or discharging:
REAR BAGGING 1. Grass catcher frame hook 2. Move wheel up or down to be positioned between the plate tabs.
LEVER BACKWARD TO LOWER MOWER
2
TO CONVERT MOWER
Your lawn mower was shipped ready to suit your requirements. Lever
1
Figure 10 1. To convert to mulching operation, remove grass catcher and close rear door.
2
3
1
4
LEVER...
Operation Manual - Page 9
... operation (Figure 13).
Rear door closed . 1. Mulcher door 2. SIDE DISCHARGING NOTE: Rear door must be closed . 2.
Discharge deflector
Figure 13
CAUTION: Do not run your lawn mower without rear door closed or approved grass catcher or clipping deflector in place. FOR SIDE DISCHARGING 1. Latch
Figure 11
2. Grass catcher installed. 2. OPERATION
3.
Operation Manual - Page 11
... engine life.
2
1
Figure 17 1. NOTE: Do not drag the bag when emptying; It may also be necessary to reduce ground speed and/or run the lawn mower over the area a second time.
• For extremely heavy cutting, reduce the width of cut by overlapping previously cut path and mow slowly.
• For...
Operation Manual - Page 12
...cut by overlapping previously cut area will recut the grass clippings
many times and reduce them in size so that the lawn mower cuts off only the top one week then east to week. Always mulch with the mulching ...not be exposed to direct sunlight. • For best results, adjust the lawn mower cutting height so that as this time the grass has dried, yet the newly cut path and mow slowly....
Operation Manual - Page 13
... under a heavy load or in this lawn mower does not cover items that have been subjected to clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge Empty fuel...
Operation Manual - Page 14
...mower blade must be in good condition to prevent blade from spark plug and place
wire where it cannot come in adapter and crankshaft keyway are up toward the engine.
5. Install the blade bolt with heavy cloth.
4. IF BOLT NEEDS REPLACING, REPLACE ONLY WITH APPROVED BOLT.
1
2
7
CAUTION: Use only a replacement...shield using screw.
3. MAINTENANCE
LAWN MOWER
Always observe safety rules when ...
Operation Manual - Page 15
... of continuous use a nail for balancing blade. If catcher needs replacing, replace only with a file or on the mower. • To check blade balance, you check the oil level. Select the oil's SAE viscosity grade according to the proper level at least once a year if the lawn mower is balanced (Figure 21).
1
2 3
Figure 21
1. SAE VISCOSITY...
Operation Manual - Page 16
... filter.
4. Pre-cleaner
Figure 23
16 Disconnect spark plug wire from lawn mower or side of engine (Figure 22).
4. Wait a minute to allow it cannot come in contact with plug.
2.
Do not use pressurized air to the filter.
6. Make sure the fastener is excessively dirty, replace with an optional pre-cleaner. DO NOT overfill, or...
Operation Manual - Page 17
... of each season.
With engine cool, remove filter and plug fuel line sections (Figure 24).
2. Connect a garden hose to carburetor, replacement is clean.
1
1
2
1. Clamp 2. SPARK PLUG
Replace spark plug at the fitting. CLEAN THE UNDERSIDE OF YOUR MOWER AFTER EACH USE. CAUTION: Do not remove hose from lawn mower.
3. Remove grass catcher and discharge chute assembly from fitting...
Operation Manual - Page 18
..., is provided to avoid serious injury, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: 1. Turn lawn mower on its side with plug. Remove blade bolt, lockwasher, hardened washer and blade.
5. Remove screw securing debris shield.
6.
TO REPLACE DRIVE BELT 1.
Reinstall gearcase belt keeper. Reinstall rear baffle screws.
2
1
3
2
2 13
5
4 12
6
7
8 9
10
11
Figure 26
1. Blade adapter...
Operation Manual - Page 19
...3. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to an authorized service center for repair and adjustment. OVERSPEEDING THE ENGINE ABOVE THE FACTORY... PROPER ENGINE SPEED. Knob 2. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER, WHICH HAS PROPER EQUIPMENT AND EXPERIENCE...
Operation Manual - Page 21
.... (See "ENGINE" in fuel tank or storage container. IMPORTANT: NEVER COVER MOWER WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.
CAUTION: Never store the lawn mower with new spark plug. Add stabilizer to distribute oil. 4. ENGINE OIL
Drain oil (with engine warm) and replace with a suitable protective cover that
does not retain moisture. Do not...
Operation Manual - Page 22
... "Loose" drive control system.
1. Check/reinstall drive belt. 3. Put belt on when control bar is released.
2. Replace spark plug.
7. Depress control bar to push
1. Weak battery (if equipped).
11.
Rear of mower housing.
5. Clean underside of lawn mower housing or cutting blade dragging in heavy grass.
2. Clean underside of fuel.
2. Contact a qualified service center...
Parts List - Page 3
... be hazardous, damage your lawn mower and void your warranty. HU775L (96145000800) PRODUCT NO. 961 45 00-08
KEY PART NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. NO.
41 532...10-16 x 5/8 Control Bar Rear Door Assembly Hairpin, Door/Handle Pivot Handle Knob, Standard Plug, Lower Handle Bar Rear Baffle Keps Locknut 1/4-20 Rope Guide Rear Skirt Spring, Rear ...
Parts List - Page 5
...
KEY PART NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NO. HU775L (96145000800) PRODUCT NO. 961 45 00-08
KEY PART NO. inches. 1 inch = 25.4 mm. Failure to do so could be hazardous, damage your lawn mower and void your warranty. HUSQVARNA ROTARY LAWN MOWER - NO.
30 532 19 17-30 31 532 40...
Similar Questions
Hu775l White Smoke And Oil Spray/leak
when started there is a continuous white smoke and oil mists out of the exhaust port and runs down f...
when started there is a continuous white smoke and oil mists out of the exhaust port and runs down f...
(Posted by Tallguy2032015 2 years ago)
What Is A 2012 Husqvarna Hu 775l Lawn Mower In Very Good Condition Worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
(Posted by kpcastles 7 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)
How Can I Get A Side Discharge Deflector For Model Hu775l
how can I get a side discharge deflector for my model HU775L
how can I get a side discharge deflector for my model HU775L
(Posted by bmills1 10 years ago)