Husqvarna HU775L Support Question
Husqvarna HU775L Support Question
Find answers below for this question about Husqvarna HU775L.Need a Husqvarna HU775L manual? We have 2 online manuals for this item!
Question posted by bmills1 on July 31st, 2013
How Can I Get A Side Discharge Deflector For Model Hu775l
how can I get a side discharge deflector for my model HU775L
Current Answers
Related Husqvarna HU775L Manual Pages
Operation Manual - Page 2
...hands after engine has stopped. Always be picked up and down and behind power lawn mowers conform to complete stop the engine (motor) and check immediately for proper operation...whenever you to service or repair this lawn mower. SLOPE OPERATION
Slopes are familiar with the controls and the proper
caution.
Exer-
Avoid discharging material against a wall or obstruction. Should...
Operation Manual - Page 3
...center. SERIAL NUMBER
DATE OF PURCHASE
THE MODEL AND SERIAL NUMBERS WILL BE FOUND ON A DECAL ATTACHED TO THE REAR OF THE LAWN MOWER HOUSING.
Check their proper operation regularly.
&#...; Keep nuts and bolts, especially blade attachement bolts, tight and keep wire away from your lawn mower.
• Follow the instructions under "Maintenance" and "Storage" sections of children. Repair, if...
Operation Manual - Page 4
....
Setup
LOOSE PARTS
Use the chart below to familiarize yourself with the exception of your lawn mower or in warm water for shipping purposes. Handle Bolt
2
Handle Knob
2
Washout Adapter
... TROUBLESHOOTING 22 WARRANTY 23-26
KNOW YOUR LAWN MOWER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER.
Your new lawn mower has been assembled at the factory with...
Operation Manual - Page 5
... material from around control bar. Handle bracket
5 To convert mower to bagging or discharging, see "TO CONVERT MOWER" in handle with knob (Figure 4).
3. Repeat for opposite side of carton and lay end panel down flat.
3. Operator presence control bar 2. ASSEMBLY
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be adjusted for additional loose...
Operation Manual - Page 7
...
speed (Figure 8). 3. Adjustment turnbuckle
7 We recommend standard safety glasses or a wide vision safety mask over spectacles. Do not under any adjustments or repairs. IMPORTANT: This lawn mower is pulled, the faster the unit will stop forward motion without self-propelling (Figure 7). Forward motion will travel (Figure 6). Operator presence control bar 2. Always wear...
Operation Manual - Page 8
... 9). To convert to bagging or discharging:
REAR BAGGING 1. Rear door 3. NOTE: Adjuster is best for high cut, adjust cutting height to suit your requirements. Lever
1
Figure 10 1. Also, 9-position adjusters (if so equipped) allow lever to be used as a mulcher. Lift rear door of the lawn mower and place the grass
catcher frame...
Operation Manual - Page 9
...13
CAUTION: Do not run your lawn mower without rear door closed and locked.
SIDE DISCHARGING NOTE: Rear door must be closed . 2. OPERATION
3.
Open mulcher door and install discharge deflector under door as shown (Figure 12).
1 2
Figure 12 1. FOR REAR BAGGING 1. Discharge deflector installed.
9
NOTE: To convert to operate the lawn mower with the rear door removed or...
Operation Manual - Page 11
... will cause unnecessary wear. No priming or choking is equipped with water and let dry before starting. 1. NOTE: Your engine is required before using a rear discharge lawn mower in the FAST position.
• When using .
• Keep top of engine around starter clear and clean of grass clippings and chaff. This will help...
Operation Manual - Page 12
... the grass has dried, yet the newly cut to reduce pushing effort and to direct sunlight. • For best results, adjust the lawn mower cutting height so that the lawn mower cuts off only the top one week then east to form clumps and interferes with your highest engine (blade) speed as they fall...
Operation Manual - Page 13
... be made periodically to clean under
deck
1 - BEFORE EACH USE
1. MAINTENANCE
Check for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean...
Operation Manual - Page 14
... and other hazards that the drive belt is hazardous, could damage your mower and void your mower. Turn lawn mower on the blade adapter. TO REPLACE BLADE
1. IMPORTANT: TO ENSURE PROPER...crankshaft.
6. IMPORTANT: BLADE BOLT IS HEAT TREATED. Use a wood block between blade and lawn mower housing and tighten the blade bolt, turning clockwise.
• The recommended tightening torque is ...
Operation Manual - Page 15
...running low on a grinding
wheel.
Blade
GRASS CATCHER
• The grass catcher may appear to lawn mower or engine. • The blade can be centered, but must be dry when used for...case. If catcher needs replacing, replace only with API service classification SG-SL. Give the lawn mower model number when ordering. Clean under the drive cover twice a season.
• The gear ...
Operation Manual - Page 16
...dipstick.
6. Filter 4. Base 5. Pre-cleaner
Figure 23
16 lay aside on startup.
8. Tip lawn mower on its side as kerosene, are not to be used to settle.
7. Slowly pour oil ... base.
7.
Fastener 2. Install air filter cover and secure with an optional pre-cleaner. Rock lawn mower back and forth to thoroughly air dry. Replace paper cartridge every 100 hours of engine (Figure 22...
Operation Manual - Page 17
... are covered to the fitting where shown (Figure 25). Remove grass catcher and discharge chute assembly from fitting. SPARK PLUG
Replace spark plug at the fitting. Hose 2. IMPORTANT: BE SURE THE GARDEN HOSE IS NOT ROUTED UNDER THE LAWN MOWER HOUSING OR ENTANGLED IN THE WHEELS.
5. Spark plug type and gap setting are...
Operation Manual - Page 18
... CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in mower housing.
5. If the deflector becomes damaged, it cannot come in adapter and crankshaft keyway are aligned, and that objects will be replaced. Turn lawn mower on its side with plug. Remove screw securing debris shield.
6. Place new drive belt on the engine crankshaft. Reinstall rear...
Operation Manual - Page 19
...3. If your engine does not operate properly due to suspected carburetor problems, take your lawn mower to an authorized service center for repair and/or adjustment. OVERSPEEDING THE ENGINE ABOVE THE...suits you. 1. CARBURETOR
Your carburetor is running too fast or too slow, take your lawn mower has three (3) height positions - SERVICE AND ADJUSTMENTS
TO ADJUST HANDLE
The handle on one...
Operation Manual - Page 20
... for damage, breakage and wear. Upper handle 3. Bolt 3.
STORAGE
Immediately prepare your mower for storage at the end of the season or if the unit will require manually ... clean it to be used for storage.
1. Touch up your lawn mower handle for 30 days or more. Knob 2.
LAWN MOWER
When lawn mower is to rest on mower (Figure 29).
3. Lubricate as shown in a clean, dry...
Operation Manual - Page 21
...season to another. • Replace your gasoline can starts to rust.
IMPORTANT: NEVER COVER MOWER WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM. Add stabilizer to rust. Replace with clean ... lines and carburetor are empty. • Never use plastic. CAUTION: Never store the lawn mower with a suitable protective cover that
does not retain moisture. Allow the engine to give
protection...
Parts List - Page 3
..., damage your lawn mower and void your warranty. HU775L (96145000800) PRODUCT... Shroud Assembly Operator's Manual, English / French
3
NOTE: All component dimensions given in U.S. MODEL NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. inches. 1 inch = 25...Discharge Guard Handle Bracket, LH Handle Bracket, RH
KEY PART NO. HUSQVARNA ROTARY LAWN MOWER -
Parts List - Page 5
...inch = 25.4 mm. MODEL NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty. NO... Spring, Tension Support Bracket Screw Adapter, Quick-Connect Coupling
5
NOTE: All component dimensions given in U.S. HU775L (96145000800) PRODUCT NO. 961 45 00-08
KEY PART NO. NO.
1 532 44 66-66...
Similar Questions
Hu775l White Smoke And Oil Spray/leak
when started there is a continuous white smoke and oil mists out of the exhaust port and runs down f...
when started there is a continuous white smoke and oil mists out of the exhaust port and runs down f...
(Posted by Tallguy2032015 2 years ago)
What Is A 2012 Husqvarna Hu 775l Lawn Mower In Very Good Condition Worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
(Posted by kpcastles 7 years ago)
Husqvarna Hu775l
My Husqvarna HU775L will not crank. It is also leaking oil. I changed sparkling and it ran for a cou...
My Husqvarna HU775L will not crank. It is also leaking oil. I changed sparkling and it ran for a cou...
(Posted by melvinsmiley1 7 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)