Husqvarna HU775H Support Question
Husqvarna HU775H Support Question
Find answers below for this question about Husqvarna HU775H.Need a Husqvarna HU775H manual? We have 2 online manuals for this item!
Question posted by brianscroggins13 on March 25th, 2017
Self Propelled Drives Slow
the self propelled drives slow already replaced the belt but still driving slow just didn't know if it would be the wheels on the back are something else is
Current Answers
Answer #1: Posted by BusterDoogen on March 25th, 2017 1:54 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Most likely the drive cable needs adjusting or the transmission is failing.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Husqvarna HU775H Manual Pages
Owners Manual - Page 2
... the self-propelled mechanism or drive clutch on wet grass.
DO: • Mow across the face of slopes: never up , transporting, adjusting or making repairs.
• Do not operate the mower without proper... in order to prevent accidental starting when setting up and down and behind power lawn mowers conform to the safety standards of the machine before starting the engine (motor).
...
Owners Manual - Page 3
...Replace gas cap and tighten securely. YOU SHOULD RECORD BOTH SERIAL NUMBER AND DATE OF PURCHASE AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE. Disconnect spark plug wire, and keep equipment in maintaining, caring for and using your lawn mower...• Never fill containers inside a closed area.
• Never make wheel height adjustments while the engine (motor) is not alert to the machine and...
Owners Manual - Page 4
...of those parts left unassembled for shipping purposes. Your new lawn mower has been assembled at the factory with rigid part of the...KNOW YOUR LAWN MOWER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER.
Make sure the frame handle is outside of bag on your lawn mower, all parts have been placed in its entirety before using.
2. IMPORTANT: THIS LAWN MOWER...
Owners Manual - Page 5
... 4).
3. Repeat for additional loose parts.
1
LIFT UP
LIFT UP
MOWING POSITION
2 3
HOW TO SET UP YOUR LAWN MOWER
TO UNFOLD HANDLE
IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES.
1.
TO REMOVE LAWN MOWER FROM CARTON
1. Your handles may be used as a mulcher. Knob 2. Bolt 3. Upper handle 3. Handle knob 4. Remove...
Owners Manual - Page 7
..., release a drive control lever only. Proceed as
required. 4. DRIVE CONTROL DISENGAGED
Figure 7
1. Self-propelling is controlled by holding the operator presence control bar down against handle to be replaced.
1
2 1
TO ENGAGE DRIVE CONTROL
Figure 6
1. Adjustment turnbuckle
7 Hold operator presence control bar down to test drive speed. Rotate turnbuckle on this lawn mower in decreased...
Owners Manual - Page 8
... bag bracket 4. Handle bracket holes
8 OPERATION
TO ADJUST CUTTING HEIGHT
All four wheels are adjusted by a single lever.
1.
Rear door 3. To lower mower, move lever forward to mulching operation, remove grass catcher and close rear door. Wheel adjuster lever
TO CONVERT MOWER
Your lawn mower was shipped ready to be removed.
1
4
2
3
Figure 11 1. Deflector bar "leg...
Owners Manual - Page 9
...12
2. Rear door closed . 2. FOR REAR BAGGING 1.
SIMPLE STEPS TO REMEMBER WHEN CONVERTING YOUR LAWN MOWER:
FOR MULCHING 1. FOR SIDE DISCHARGING 1. Rear door closed . 2. Never attempt to mulching or ...shown (Figure 13).
Grass catcher installed. 2. NOTE: To convert to operate the lawn mower with the rear door removed or propped open. Mulcher door closed or approved grass catcher...
Owners Manual - Page 11
...grass, clumps of cut grass may also be necessary to reduce ground speed and/or run the lawn mower over the area a second time.
• For extremely heavy cutting, reduce the width of grass... clippings and chaff. Empty clippings from bag using a rear discharge lawn mower in cloth grass catchers can become filled with dirt and dust with a small overlap to collect ...
Owners Manual - Page 12
...recut the grass clippings
many times and reduce them in size so that the lawn mower cuts off only the top one week then east to mow your highest engine (blade) speed as they ... to reduce pushing effort and to keep from week to direct sunlight. • For best results, adjust the lawn mower cutting height so that as this time the grass has dried, yet the newly cut path and mow slowly....
Owners Manual - Page 13
... mowing in this manual. • At least once a year, replace the spark plug, clean or
replace air filter element and check blade for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level...
Owners Manual - Page 14
... must be sure they move freely. TO REMOVE BLADE 1. Turn lawn mower on the blade adapter. Remove blade bolt by the manufacturer of the belt retainer (Figure 20).
2.
TO REPLACE BLADE
1.
Crankshaft keyway
2. Debris shield 5. Blade 7. Hardened washer 10. DRIVE WHEELS
Check rear drive wheels each time you mow to be kept sharp. If necessary to work properly...
Owners Manual - Page 15
...wheel. ENGINE
LUBRICATION
Use only high quality detergent oil rated with approved replacement catcher. Check the crankcase oil level before starting in one year. MAINTENANCE
TO SHARPEN BLADE NOTE: We do , be sure the blade is balanced, it will cause eventual damage to lawn mower... once a year if the lawn mower is filled with the ground.
Clean under the drive cover twice a season.
&#...
Owners Manual - Page 16
... as shown and drain oil into the base. Install the filter and pre-cleaner into a suitable container. Filter 4. Make sure the fastener is excessively dirty, replace with plug.
2.
Rock lawn mower back and forth to clean cartridge. Disconnect spark plug wire from the muffler on the dipstick.
Owners Manual - Page 17
..., obstructing fuel flow to carburetor, replacement is equipped with a fitting that allows quick and easy cleaning of the underside of the housing.
Move lawn mower to the fitting where shown (Figure 26).
IMPORTANT: BE SURE THE GARDEN HOSE IS NOT ROUTED UNDER THE LAWN MOWER HOUSING OR ENTANGLED IN THE WHEELS.
5. If no fuel line leaks...
Owners Manual - Page 18
...blade adapter on gearcase pulley (Figure 27). Reinstall blade.
7. Hardened
2. Turn lawn mower on its side with plug. TO REPLACE DRIVE BELT 1.
Be sure the new drive belt is inside the tabs of the gearcase belt keeper.
3.
Remove blade bolt, lockwasher, hardened washer and blade.
5. Drive belt
11.
Place rear baffle in adapter and crankshaft keyway are aligned, and...
Owners Manual - Page 19
... AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.
19 Remove knob and carriage bolt on your lawn mower to increase engine speed or it may result in handle with bolt and knob.
2
...1
High Medium
Low 3
Figure 28 1. CARBURETOR
Your carburetor is running too fast or too slow, take your lawn mower has three (3) height positions - Knob 2. If you believe that suits you. 1. adjust to...
Owners Manual - Page 20
Replace if necessary.
4. sand lightly before painting.
1
FOLD FORWARD
FOR STORAGE
MOWING POSITION
2
HANDLE
You can fold your lawn mower handle for damage, breakage and wear. Upper handle 3. Lower handle
..., the lower handle will not be stored for a period of this manual).
2. LAWN MOWER
When lawn mower is to rest on sides of the lower handle and pivot entire handle assembly forward ...
Owners Manual - Page 22
... to cut - Grass is too high or wheel height is disconnected.
5. Grass catcher too full. 4.
Loss of drive (or slowing of mower housing. Belt wear. 2. Drive cable worn or broken. 4. Put belt on when control bar is on pulleys/replace belts if broken. 4. Check oil level. 6. Tighten blade bolt. 2. Move lawn mower to push
1.
Rear of fuel.
2. Check/reinstall...
Parts List - Page 3
HUSQVARNA ROTARY LAWN MOWER - IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NO. HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. inches. 1 inch = 25.4 mm. NO.
42 532 19 30-00 43 532 19 17-30 ...
Parts List - Page 5
...25.4 mm. HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. Failure to do so could be hazardous, damage your lawn mower and void ... Front Screw, Hi-Lo Thread, 12 x 5/8 Nut, Hex Bolt Wheel & Tire Assembly, Front Pinion Belt, Drive Kit, Water Washout Assembly Fitting, Water Washout Washer, Lock, Internal Tooth ... (O.E.M.) replacement parts. MODEL NO. HUSQVARNA ROTARY LAWN MOWER -
Similar Questions
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
How To Adjust The Speed Of A Husqvarna Lawn Mower Model Hu775h
(Posted by Bdbi 9 years ago)
I Got A Husqvarna Walk Behind Mower #hu775h It Wont Start Tryed Verything Any He
(Posted by lozanovicky1960 10 years ago)