Husqvarna HU775H Support Question
Husqvarna HU775H Support Question
Find answers below for this question about Husqvarna HU775H.Need a Husqvarna HU775H manual? We have 2 online manuals for this item!
Question posted by davyka on September 8th, 2014
Husqvarna Lawn Mower Hu775h Won't Start
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Husqvarna HU775H Manual Pages
Owners Manual - Page 2
... Be thoroughly familiar with side shields when operating mower.
MEETS CPSC SAFETY REQUIREMENTS
Husqvarna rotary walk-behind before and while moving backwards.
...lawn mowers conform to cause cancer and birth defects or other safety protective devices in the manual(s) before starting the engine (motor).
• If the equipment should start to give you leave the equipment, before starting...
Owners Manual - Page 3
... Do not use extra caution when servicing it on or near any ).
WARNING: This lawn mower is equipped with a spark arrester meeting applicable local or state laws (if any unimproved ..., damage, and deterioration, which could expose moving parts or allow children to prevent accidental starting.
• Keep nuts and bolts, especially blade attachement bolts, tight and keep wire away...
Owners Manual - Page 4
...frame handle is outside of bag on your new lawn mower.
To ensure safe and proper operation of your lawn mower to assemble or operate your lawn mower or in the parts bag. Use the correct ...for shipping purposes. Description
Qty. These symbols may appear on the bottom. Your new lawn mower has been assembled at the factory with the location of those parts left unassembled for ...
Owners Manual - Page 5
... and padding holding operator presence control bar to be adjusted for additional loose parts.
1
LIFT UP
LIFT UP
MOWING POSITION
2 3
HOW TO SET UP YOUR LAWN MOWER
TO UNFOLD HANDLE
IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES.
1. Remove protective padding, raise upper handle section into place...
Owners Manual - Page 7
...6
1. NOTE: If after the above steps
(forward speed remains the same), your lawn mower or performing any circumstances attempt to the handle and pulling either the operator presence control bar... require an engine control to the handle. NOTE: Your lawn mower is a turnbuckle on drive control to start and operate the mower.
The further toward the handle a lever is not adjustable...
Owners Manual - Page 8
...bagging operation, clipping deflector must be used as a mulcher. Wheel adjuster lever
TO CONVERT MOWER
Your lawn mower was shipped ready to desired position. Grass catcher frame hook 2.
Rear door 3. Handle ... door of the clipping deflector and secure it will rest on the top of the lawn mower and place the grass
catcher frame hooks onto the grass bag brackets (Figure 10). ...
Owners Manual - Page 9
Mower is now ready for side discharging operation (Figure 14). Figure 14
1
2
Figure 13 1. Grass catcher ... BAGGING 1. OPERATION
3. Discharge deflector
CAUTION: Do not run your lawn mower without rear door closed . 2. Mulcher door closed and locked.
1
1. FOR SIDE DISCHARGING 1. NOTE: To convert to operate the lawn mower with the rear door removed or propped open. SIMPLE STEPS TO ...
Owners Manual - Page 11
... of the product and should be set in the FAST position.
• When using a rear discharge lawn mower in cloth grass catchers can become filled with dirt and dust with water and let dry before starting. 1. To start engine, hold operator presence control bar
down to snap back (Figure 17).
1
2
Figure 17 1. Empty clippings...
Owners Manual - Page 12
...best recutting action of grass and grass conditions may require that the lawn mower cuts off only the top one week then east to provide nutrients for the lawn. At this will disperse into the grass and not be mulched ... keep from week to direct sunlight. • For best results, adjust the lawn mower cutting height so that an area be noticed. Always mulch with the mulching action.
Owners Manual - Page 13
...MAINTENANCE
Check for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace ...HOURS 100 OR SEASON HOURS
BEFORE STORAGE
* (if so equipped)
** Electric-Start mowers
*** Power-Propelled mowers
****
Use a scraper to see if you should make any of the adjustments ...
Owners Manual - Page 14
... WITH APPROVED BOLT.
1 2
7
CAUTION: Use only a replacement blade approved by the manufacturer of blade (opposite sharp edge) is inside the tabs of blade adapter. Turn lawn mower on the blade adapter. The key must be in contact with plug.
2. Position blade on its side. Blade adapter 4. Blade 7. Hardened washer 10. Be sure...
Owners Manual - Page 15
...not used for damage or deterioration. NOTE: Multi-viscosity oils (5W30, 10W30 etc.) improve starting the engine and after every 25 hours of continuous use a nail for balancing blade. Change... with the ground. An unbalanced blade will wear.
If blade is balanced. Give the lawn mower model number when ordering. Select the oil's SAE viscosity grade according to be sure the...
Owners Manual - Page 16
...starting engine.
9. Service air cleaner more often under dusty conditions. Remove the cover (Figure 24).
2. Wash the pre-cleaner in the base.
7. Do not use pressurized air to check the oil level with the dipstick.
6. Assemble the dry pre-cleaner to remove any spilled oil from lawn mower...MAINTENANCE
TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to drain oil, empty fuel tank by ...
Owners Manual - Page 17
... no fuel line leaks and clamps are shown in the "PRODUCT SPECIFICATIONS" section of this manual. Clamp 2.
Start engine (as it cannot come in contact with plug.
• Clean the underside of your lawn mower by scraping to remove build-up any spilled gasoline. A clogged engine runs hotter and shortens engine life.
•...
Owners Manual - Page 18
...damaged, it cannot come in the Operation section of the gearcase belt keeper.
3. Turn lawn mower on its side with plug. Remove gearcase belt keeper.
7.
Reinstall gearcase belt keeper. ...sure the blade and all moving parts have
completely stopped. 3. Disconnect spark plug wire from mower.
4. LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in contact with air filter and ...
Owners Manual - Page 19
... CARBURETOR
Your carburetor is running too fast or too slow, take your lawn mower to suspected carburetor problems, take your lawn mower has three (3) height positions - Knob 2.
OVERSPEEDING THE ENGINE ABOVE THE...1
High Medium
Low 3
Figure 28 1. Bolt 3. Remove knob and carriage bolt on your lawn mower to increase engine speed or it may result in personal injury. IF YOU THINK THE ENGINE...
Owners Manual - Page 21
... the fuel lines and carburetor are empty. • Never use plastic. CAUTION: Never store the lawn mower with a suitable protective cover that
does not retain moisture. Always follow the mix ratio found on... spark. Pour one season to another. • Replace your gasoline can if your can starts to rust. Do not use engine or carburetor cleaner products in any enclosure.
21
STORAGE
ENGINE...
Owners Manual - Page 22
... bar in fuel.
4. Weak battery (if equipped).
11. Connect battery to upper handle before starting. Raise cutting height. 3. Check oil level. 6. Cut at same height. 3. Wheel heights ...is disconnected.
5. Raise cutting height. 2. Stale fuel.
3. Bad spark plug.
6. Loss of lawn mower housing or cutting blade dragging in engine. 6. Worn, bent or loose blade. 2. Contact a qualified...
Parts List - Page 3
HUSQVARNA ROTARY LAWN MOWER - Failure to do so could be hazardous, damage your lawn mower and void your warranty. inches. 1 inch = 25.4 mm. MODEL NO. NO.
1 ...English / French Operator's Manual, Spanish
3
NOTE: All component dimensions given in U.S. HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Parts List - Page 5
...inches. 1 inch = 25.4 mm. MODEL NO. Failure to do so could be hazardous, damage your lawn mower and void your warranty. NO.
1 532 43 09-95
9 532 43 16-50 10 532 43 27... Assembly, Rear Nut, Flangelock 3/8-16
KEY PART NO. HU775H (96145001000) PRODUCT NO. 961 45 00-10
KEY PART NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. HUSQVARNA ROTARY LAWN MOWER -
Similar Questions
How To Adjust The Speed Of A Husqvarna Lawn Mower Model Hu775h
(Posted by Bdbi 9 years ago)
I Got A Husqvarna Walk Behind Mower #hu775h It Wont Start Tryed Verything Any He
(Posted by lozanovicky1960 9 years ago)
