Husqvarna HU700L Support Question
Husqvarna HU700L Support Question
Find answers below for this question about Husqvarna HU700L.Need a Husqvarna HU700L manual? We have 2 online manuals for this item!
Question posted by jandjgabor on May 3rd, 2016
Replacing Drive Belt
how to remove the gearcase belt keeper
Current Answers
Answer #1: Posted by Odin on May 3rd, 2016 7:53 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,660
Member since:
April 10th, 2010 Points: 41,236,660
See if the video at http://bit.ly/23nNKaw will solve.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Husqvarna HU700L Manual Pages
Owners Manual - Page 1
HU700L
Operator's Manual
532 43 81-57 Rev. 2 06.07.11 BY
Printed in U.S.A.
Owners Manual - Page 2
...of ignition. • Use only an approved container. • Never remove gas cap or add fuel with side shields when operating mower. BECOME ALERT!!! Reduced footing could lose footing or balance. • ...hot during operation and remain hot after handling.
• Stop the blade(s) when crossing gravel drives, walks, or roads.
• Stop the engine (motor) whenever you feel uneasy on ...
Owners Manual - Page 3
... 16
OPERATION 5-8
WARRANTY 17-20
MAINTENANCE SCHEDULE 9
3 V. Frequently check components and replace with an internal combustion engine and should be used , it on the ground away ... Remove gas-powered equipment from your nearest authorized service center. YOU SHOULD RECORD BOTH SERIAL NUMBER AND DATE OF PURCHASE AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
WARNING: This lawn mower...
Owners Manual - Page 4
... nuts, washers, bolts, etc., necessary to "ADJUST HANDLE" in the parts bag.
Remove loose parts included with knob.
3. Remove any packing material from around control bar. ASSEMBLY
Read these instructions and this manual in its entirety before using. IMPORTANT: THIS LAWN MOWER IS SHIPPED WITHOUT OIL OR GASOLINE IN THE ENGINE. To ensure safe...
Owners Manual - Page 5
These symbols may appear on your lawn mower or in literature supplied with your lawn mower to stop
pelled forward motion lawn mower.
MEETS CPSC SAFETY REQUIREMENTS
Husqvarna rotary walk-behind power lawn mowers conform to start the engine. must be held
DRIVE CONTROL LEVERS - down to the handle to the safety standards of the American National Standards Institute and...
Owners Manual - Page 6
... toward
wheel.
CAUTION: Federal regulations require an engine control to suit your drive belt is a turnbuckle on the drive control housing to increase tension on drive control to increase drive
speed.
6
LEVER
ROTATE LEVER AWAY FROM ENGINE TO RAISE MOWER
FIG. 6
TO CONVERT MOWER
Your lawn mower was set at the factory for high cut, adjust cutting height to...
Owners Manual - Page 7
... CATCHER (See Fig. 9)
1.
able accessory) legs into the engine. 4. CLIPPING DEFLECTOR
FIG. 8
CAUTION: Do not run your lawn mower without oil in the Maintenance section of oil with clippings from bag using the frame handle.
2. Remove grass catcher with the unit.
GRASS CATCHER
FRAME HANDLE
GRASS CATCHER FRAME HOOK
FIG. 7
REAR DISCHARGING (See...
Owners Manual - Page 8
...direct sunlight.
• For best results, adjust the lawn mower cutting height so that the lawn mower cuts off with your mower. Reduce ground speed (pushing speed) and/or run until... for additional information. CAUTION: Alcohol blended fuels (called gasohol or using a rear discharge lawn mower in moist, heavy grass, clumps of cut , mow across (perpendicular) to protective coatings...
Owners Manual - Page 9
... 10
HOURS
EVERY 25 HOURS OR SEASON
EVERY 100
HOURS
BEFORE STORAGE
Check for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler...
Owners Manual - Page 10
... Position blade on its side. lbs. Turn lawn mower on the blade adapter.
TO REPLACE BLADE (See Fig. 12)
1.
FIG. ...lawn mower or engine.
• The blade can harm rubber.
• Avoid stumps, stones, deep ruts, sharp objects and other hazards that the drive belt is balanced, it cannot come in a horizontal position. Make sure air filter and carburetor are aligned; Remove...
Owners Manual - Page 11
...drive cover twice a season.
• The gear case is filled with lubricant to the proper level at least once a year if the lawn mower is not used .
• Check your expected operating temperature. Remove.... 14 & 15)
NOTE: Before tipping lawn mower to remove any non-road engine repair establishment or individual. If catcher needs replacing, replace only with plug. DO NOT thread the ...
Owners Manual - Page 12
...lawn mower is clean.
CAUTION: Disconnect spark plug wire from accumulating. SPARK PLUG
Replace spark plug at the fit- WATER WASHOUT FEATURE (See Fig. 17)
Your lawn mower is running. Remove... the cartridge.
WARNING: Do not engage the drive system during the washout process. 2. Install cartridge, then replace cover.
Connect a garden hose to clean cartridge. FITTING
FIG...
Owners Manual - Page 13
... Reinstall blade.
7. Turn lawn mower on its side with plug. Remove debris shield.
6. Remove blade bolt, lockwasher, hardened washer and blade.
5. TO REPLACE DRIVE BELT 1. Reinstall gearcase belt keeper. Be sure the new drive belt is inside the tabs of the belt retainer.
4. Remove drive belt. Reinstall rear baffle screws. Remove gearcase belt keeper.
7.
Release control bar...
Owners Manual - Page 14
...control devices and systems, which are securely fastened. Remove knob and carriage bolt on one side of time, clean it thoroughly, remove all nuts, bolts, screws, and pins are being...and reassemble bolt and knob and tighten securely. 3. Clean entire lawn mower (See "CLEANING" in the Maintenance section of this manual).
2. Replace if necessary.
4. sand lightly before painting. IMPORTANT: WHEN ...
Owners Manual - Page 15
...stabilizer. Remove spark plug.
2. Pull starter handle slowly a few times to reach the carburetor. IMPORTANT: NEVER COVER MOWER WHILE ENGINE...stabilizer container. ENGINE OIL
Drain oil (with engine warm) and replace with a suitable protective cover that does not retain moisture. ...products in any enclosure.
15 CAUTION: Never store the lawn mower with new spark plug.
ACIDIC GAS CAN DAMAGE THE...
Owners Manual - Page 16
... to handle.
9. Cutting too much oil in fuel.
4.
Buildup of lawn mower housing or cutting blade dragging in grass.
1. Excessive vibration
1. not filling
2. Raise rear of power
1. Belt wear. 2. Check/replace drive belt. 2. Adjust drive control.
16 Tighten blade bolt or replace blade adapter.
8. Wheel heights uneven. 3. Blade dragging in heavy grass...
Parts List - Page 1
NUMBER 96143006900
438679 Rev. 3 06.30.11 BY ILLUSTRATED PARTS LIST
MODEL NUMBER HU700L PRODUCT NUMBER 961 43 00-69 MFG. ID.
Parts List - Page 3
..., Rear Skirt Clip, Cable Belt Keeper Front Shroud Assembly Operator's Manual, English / French Clipping Deflector (available accessory, not shown)
3
NOTE: All component dimensions given in U.S. MODEL NUMBER HU700L (96143006900) PRODUCT NUMBER 961 43 00-69
KEY PART NO. Failure to do so could be hazardous, damage your lawn mower and void your warranty...
Parts List - Page 5
..., Lock, Internal Tooth Locknut, Hex, with O-Ring Spring, Tension Support Bracket Screw
5
NOTE: All component dimensions given in U.S. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty. MODEL NUMBER HU700L (96143006900) PRODUCT NUMBER 961 43 00-69
KEY PART NO.
Similar Questions
Remove And Replace Drive Belt On Husqvarna 7021r Lawnmower
I need to remove and replace the drive belt on my 7021R Husqvarna lawn mower and the instructions in...
I need to remove and replace the drive belt on my 7021R Husqvarna lawn mower and the instructions in...
(Posted by michaelhynek43 2 years ago)
Drive Control Cable
how to change the drive control cable on the hu700l. The end on the Handel is simple but the end und...
how to change the drive control cable on the hu700l. The end on the Handel is simple but the end und...
(Posted by mtnmn64 3 years ago)
The Drive Shaft Pully
the pully that holds the blade comes in two pieces...one fits inside of the other. The part # sinter...
the pully that holds the blade comes in two pieces...one fits inside of the other. The part # sinter...
(Posted by Evered1980 7 years ago)
Drive Control
my drive control quit working , how do I check it, adjust it
my drive control quit working , how do I check it, adjust it
(Posted by timm276 8 years ago)
Can I Repair / Replace Drive Belt On A Husquevarna 7021 Rs Mower?
(Posted by prosphaton 9 years ago)