Hoover UH71003 Support Question
Find answers below for this question about Hoover UH71003.Need a Hoover UH71003 manual? We have 1 online manual for this item!
Question posted by Anneormsby125 on April 20th, 2020
How To Disassemble To Replace Power Switch On Hoover Elite Rewind Uh 71003
Current Answers
Answer #1: Posted by Troubleshooter101 on April 20th, 2020 10:22 AM
Unplug the vacuum cleaner's power cord from the wall outlet, if it is plugged in. Rotate the Hoover so that the back is facing you. Remove the two screws at the top left and right sides where the handle tapers in -- use a Phillips screwdriver to do this.
Slide the handle down as you pull it toward you and off the back of the Hoover. Place the handle aside.
Step 3Rotate the Hoover 180 degrees. Open the bag compartment lid at the top of the Hoover and set it aside. Remove the three screws -- top and left and right sides -- that are now revealed using the Phillips screwdriver. Pull the plastic casing out from the top of the Hoover and place it aside.
Step 4Unbend the two contacts on the back of the switch with the needle-nose pliers. Grip the end of one of the wires attached to the back of the switch with the pliers. Pull the wire off the switch using the pliers. Repeat this procedure with the end of the other wire attached to the back of the switch.
Step 5Rotate the Hoover so that the back is again facing you. Insert the tip of a flat-edged screwdriver beneath the switch. Lift up on the tip to loosen the switch from the compartment it is in. Pull the switch off and dispose of it properly.
Step 6Place the replacement switch in the position that the original switch was occupying. Turn the switch to "Off" if it is not already set so. Rotate the Hoover 180 degrees.
Step 7Grip the end of one of the wires with the needle-nose pliers. Push the end of the wire through one of the contacts on the back of the switch. Bend the contact over with the pliers. Repeat this with the other wire.
Step 8Put the plastic casing back over the switch. Reattach the screws. Close the bag compartment lid.
Please check this link below:-
https://www.hunker.com/13407504/how-to-replace-a-defective-onoff-switch-on-a-hoover-vacuum
Thanks
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Troublshooter101
Similar Questions
I was vacuuming, and it just stopped in mid-vacuum. It will not turn back on, It has been cleaned re...
brush bar
My Hoover Floormate FH40030 won't turn on. It worked perfectly 2 days ago. It turned off normally. N...
How do you replace the power switch. The new switch we received for this model has two black wires a...