Hoover FH50240 Support Question
Hoover FH50240 Support Question
Find answers below for this question about Hoover FH50240.Need a Hoover FH50240 manual? We have 1 online manual for this item!
Question posted by alpinelakemail on April 19th, 2013
Dirty Water Tank Handle
how do i put the springs back on the handle of the dirty water tanj
Current Answers
Related Hoover FH50240 Manual Pages
Manual - Page 2
Model
MFG. Manufacturing code
(Label located on lower handle of your HOOVER® product. CODE
Hint: Attach your product online at ...be required for warranty service of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5 How To Use...6
Cleaner Description 6 The Tanks...7 How to register by phone. Fri 8am- 7pm EST.
only) or to find the Hoover® authorized dealer ...
Manual - Page 3
.... Keep cord away from falling, always place cleaner at voltage specified on data plate on lower handle of stairs or on cord. Not intended for use by pulling on floor. keep children away ... an electrical appliance, basic precautions should , has been dropped, damaged, left outdoors, or dropped into water, take it to a service center prior to continuing use. • Do not pull or carry ...
Manual - Page 4
• Do not use without Tanks or Filters in place. • WARNING: This product contains chemicals known to the State of ... • To assist in the risk of California to
cause cancer, birth defects or reproductive harm. The plug must be held in tanks. • Do not allow cleaner to a 2-pole receptacle (E) if a properly grounded outlet is well ventilated when using
detergents and other...
Manual - Page 5
...
C. Solution Bottle
b
C
Carpet Upholstery
Cleaner
bare floor
E cleaner
PreCleaner
D
I . Attach the plug end to lock it into vacuum base. Base, Hose and Removable Dirty
1.1
Water Tank
A
B. Handle Bolt (located in handle of packing materials.
*Available on unit)
I
G
F*
Remove all parts are located before
H*
disposing of unit)
D. Make sure all parts from images...
Manual - Page 6
... lock into a single position but "floats" to allow convenient operation.
2.3
A
Actual model may vary) 1.8 Store Tools on pedal (A) to lower handle to operating position. SpinScrub® Hand
Tool* C. A
C
2. Dirty Water Tank Handle 11. Edge Cleaners* 14. Handle Release Pedal 19. Hard Floor Squeegee Tool*
2.1 1
2 5
7
8
10 11 12
3 6
4 16
9
17
14
13
15
20 18 19
*Available...
Manual - Page 7
... also be lifted by the upper clean water tank handle as shown. SPILL PICK-UP - brushes at maximum speed for delicate carpets and hard floors.
2.6
The tanks: CLEAN WATER/ SOLUTION TANK
2.7
(upper tank)
C
D
2.7 The clean water tank (C) holds the water that mixes with water.
2.11 Position bottom of tank onto cleaner and push upper part of tank to line with detergent and fill...
Manual - Page 8
....
2.17 Remove lint and debris from the surface being cleaned. how to empty
Turn cleaner off will engage, suction will
B
A
damage your (A) detergent container, (B) Clean Water Tank or (C) Dirty Water
Tank. Avoid contact with water.
C
Use only HOOVER® Oxy detergent for this tank's handle personal injury may vary from images shown. 8
2.14
2.16
C D
2.18 F
Manual - Page 9
....
3.
Automatic shut off
When the Dirty Water Tank (lower tank) is marked with white paper towel or cloth.
Do not clean fabric marked "S" ("solvent/dry" clean only). When cleaning entire floor, move area rugs/ carpet to an Authorized Dealer for best results.
B
Check clean water tank also; For carpet, use a HOOVER® vacuum cleaner with the detergent...
Manual - Page 10
...strokes until little water is visible passing through the Dirty Water Tank lid.)
Empty Dirty Water Tank when the motor sound becomes higher pitched and there is visible passing through
the Dirty Water Tank lid (Pass ... pull cleaner back toward you without ). Keep nozzle flat on handle release pedal and lower handle to operating position.
IMPORTANT
To avoid saturating carpet, do not...
Manual - Page 11
... handle rests on the floor. Do not use the cleaner on wood floors if any of the spill, pull the nozzle very slowly over the spill.
!
Fill clean water tank according... remove clean water tank (Fig. 2.8) and Dirty Water Tank (Fig. 2.13). Fill detergent container with the SpinScrub® mode selector to RINSE. It is desired, set tank on furniture).
1. To pick up dirty solution, release ...
Manual - Page 12
... converting to dry. To clean HARD floorS (Continued)
Rinsing is not necessary, but will not stain the carpet. Rinse it is completely dry. Rinse the Dirty Water Tank lid and let air dry.
3.5
Filter Screens A
IMPORTANT
3.5 To keep children and pets away from images shown. 12 Empty...
Manual - Page 13
...Water Tank, wash and rinse dirty Water Tank and let air dry. How to WASH. CAUTION ! Not to instructions for grooming a pet.
Do not point tools toward people or pets.
!
Position tool against riser.
Place handle... position. All tools attach to the hose in injury or damage.
Empty Dirty Water Tank when the motor sound becomes higher pitched and there is necessary, wait until...
Manual - Page 14
... fabric.
overlap each pass. Empty Dirty Water Tank when the motor sound becomes higher pitched and there is completely dry before using the tool again. Actual model may be necessary to remove more than 2 passes with the tool without pressing the trigger to repeat the cleaning process.
Vacuum up the solution with the solution...
Manual - Page 15
... assembly and pull firmly. Press down on nozzle to Remove
Turn off and unplug cleaner from electrical outlet. Replace Dirty Water Tank. Follow these home maintenance tasks as described in cleaner.
Make sure that handle rests on the floor.
5.1 Pull tab (A) at rear edge of brush assembly with holes (C) in Figs. 2.8 and 2.13.
Turn...
Manual - Page 16
... lid and plunger on a carpeted or wood surface.
5.6
C
16
Allow brushes and underside of tank. Make sure both move
freely. Remove dirt and debris from lint screens (C).
5.5
A
B
Storage
Before storing: • Empty Clean Water Tank and let air dry. Dirty Water Tank :
How to Clean
5.5 Clean and rinse inside of carpet cleaner to air dry thoroughly...
Manual - Page 17
... and hold the trigger for up ".*
setting.
*Available on correctly. 4.
PROBLEM
Cleaner won 't dispense.
2.
Low suction.
Check fuse or breaker in home.
1.Remove and empty Dirty Water Tank. Make sure lid is defective.
1. Clean the door and verify it usually can be done by using the checklist below. Refer to Fig. 3.5 for instructions...
Manual - Page 18
...Dirty Water Tank when full or when
automatic shut-off engages.
7. Customers) or hoover.ca (Canadian customers).
Mon-Fri 8am-7pm EST. Always identify your vacuum to Hoover®, Inc., Company in water tank. Do not send your vacuum... ordering parts. (Label located on lower handle of the carpet.
• 6.1 Fill tank (A) with hot (under "Vacuum Cleaners" or "Household". • Visit...
Similar Questions
Remove Dirty Water Tank
The dirty water tank on Hoover Max Extract 77 is stuck.
The dirty water tank on Hoover Max Extract 77 is stuck.
(Posted by myrock10 8 years ago)
Dirty Tank Handle
I need some instruction on how to put the springs and handle back on the dirty water tank. I dropped...
I need some instruction on how to put the springs and handle back on the dirty water tank. I dropped...
(Posted by libbynkids 9 years ago)
Hoover Fh50240 Clean Water Tank Starts Draining As Soon As Turned On
As soon as you push the red power button the clean water and detergent tanks start dispensing water ...
As soon as you push the red power button the clean water and detergent tanks start dispensing water ...
(Posted by chasefamily88 10 years ago)
Clean Water Tank Drains Directly Into Dirty Water Tank When Turned On.
My hoover max extract 77 clean water tank drains directly into my dirty water holding tank when turn...
My hoover max extract 77 clean water tank drains directly into my dirty water holding tank when turn...
(Posted by toothfxr 11 years ago)
Leaking Clean Water Tank
I have a brand new, first use hoover max extract 77 carpet washer. Upon the second filling of the cl...
I have a brand new, first use hoover max extract 77 carpet washer. Upon the second filling of the cl...
(Posted by muffe444 11 years ago)