Hoover FH50005 Support Question
Hoover FH50005 Support Question
Find answers below for this question about Hoover FH50005.Need a Hoover FH50005 manual? We have 1 online manual for this item!
Question posted by jimhoopes on November 11th, 2011
Assembly The Unit
4 boly=ts ans nuts required but only 3 in packing list. 2 small bolts olny but not indicsted where to install
Current Answers
Related Hoover FH50005 Manual Pages
Manual - Page 1
... returning this product to the store. Owner's Manual
Operating and Servicing Instructions
Español - página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. IF USED COMMERCIALLY WARRANTY IS VOID.
©2010 Techtronic Floor Care Technology Limited.
Manual - Page 2
... 3-4
Cleaner Assembly 5 Carton Contents 5 Attach Base and Midsection 5 Attach Handle 5
How To Use...6-10 Cleaner Description ...6 Preparing The Carpet 7 Remove Clean Water Solution Tank 7 Preparing Clean Water Solution Tank with a customer service representative; CODE
Hint: Attach your HOOVER® product. Verification of date of purchase may be required...
Manual - Page 3
... TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
• Fully assemble before operating. • Operate vacuum only at bottom of
cleaner. • Do not leave appliance when plugged in place.
3 Close supervision ...always be present. • Connect to a properly grounded outlet only. Do not place cleaner on stairs or furniture, as gasoline, or fine wood sandings, or use by pulling on...
Manual - Page 4
... over heating.
If it should be inserted into your cleaner may cause damage.
• Store in the sketch above stepes, your cleaner to protect it will stop running can result in accordance with this appliance. The plug must be certain the area is properly installed and grounded in a risk of electric shock. Do...
Manual - Page 5
...identify each
D
item shown. 1. ASSEMBLY- E
B F
G
ASSEMBLY- While holding nut in back of upper handle. Repeat... front of packing materials.
While holding nut in upright position. Screws...unit. One at a time, place nut into recess located on upper handle.
1.3
MIDSECTION TABS
5
UPPER CORD HOOK
CORD
BASE CVlaecaunuemr AASSSSEEMMBBLLYY
Carton contents
A. Place nut...
Manual - Page 6
...
12. Handle Release Pedal 16. Dirty Water Tank 8. Carry Handle 14. Clean Water Solution Tank 4. Quick Cord Release 15. 2. Power Cord 13. HOW TO USE
Cleaner Description
2.1
FRONT
BACK
17
FRONT
1. Non-Slip Grip Handle 2. Dirty Water Tank Latch 5.
Manual - Page 7
Preparing the Carpet
Vacuum carpet thoroughly. Remove as much furniture from cleaner and remove.
2.3
7 If unable to dry completely. Test a small area in garage or area where unit could freeze. Gently rub the cloth over previously cleaned areas. Check each color for color fastness.
See page 10. Try not to walk on the ...
Manual - Page 8
... Solution Tank with Detergent
2.4 Unscrew measuring cap from back side of Clean Water Solution Tank into cleaner and rotate top into position until the lever snaps into place.
2.7
2.8 Plug cord into electrical... Clean Water Solution Tank.
2.6 Fill remaining Clean Water Solution Tank with power on cleaner.
• NOTICE •
• Never leave unit unattended with hot tap water.
Manual - Page 9
...water tank handle and push latch to remove dirty water and solution from moving parts- Release trigger and pull unit backward in the same path to release.
2.10
2.11 Grasp handle and pull tank out of tank)...results use any chemicals when cleaning the tank.
9
EMPTYING DIRTY WATER TANK
Your Carpet Cleaner is equipped with hot tap water. WARNING
To reduce the risk of dry vacuuming.
Manual - Page 10
...2.16). Failure to settle and reset.
• If the float repeatedly shuts off of the cleaner. Tipping the cleaner and breaking the seal of the nozzle and carpeting will cause the float to rise and shut ... water tank does not appear full, turn the power switch off and wait for the float to install the Dirty Water Tank correctly (Diagram 2.18), will result in the dirty water tank lid, and...
Manual - Page 11
... call 1-800-944-9200.
1. Power cord not firmly plugged
into outlet. 2. Plug unit in home. Empty Dirty Water Tank - Mon-Fri 8am-7pm EST. Dirty Water Tank...THIS PRODUCT TO THE STORE.
11 UNPLUG CLEANER BEFORE SERVICING. Pg. 9.
1. Dirty Water tank is not installed correctly.
3. Review Clean Water Solution Tank Installation -Pg. 8.
2. TROUBLESHOOTING GUIDE
WARNING
TO...
Manual - Page 12
...-944-9200 OR visit Hoover® online at no cost to products purchased outside the United States, including its territories and possessions, outside of purchase. Military Exchange and outside a ...this product is not an authorized retailer, dealer, or distributor of the product in the United States, U.S. However, if you mail your HOOVER® product is warranted against original defects...
Similar Questions
Hoover Carpet Cleaner Fh50005 Ready To Clean Carpet, Ran 1 Minute And Stopped.
Is it power switch or motor. Everything in place properly. Water in tank. Just wont run.
Is it power switch or motor. Everything in place properly. Water in tank. Just wont run.
(Posted by concernedforu 9 years ago)
Hoover Dual V Steam Cleaner Upholstery Hose Won't Work
(Posted by hamidirferz 10 years ago)
Which Carpet Steam Cleaner Models Have Heat, Auto Rinse & Beltless Features?
looking for models that offer heat (heated air and/or heated water, cleaning when pushed forward and...
looking for models that offer heat (heated air and/or heated water, cleaning when pushed forward and...
(Posted by wytche1 12 years ago)