Hoover F7458-900 Support Question
Hoover F7458-900 Support Question
Find answers below for this question about Hoover F7458-900 - Widepath All Terrain Floor Cleaner.Need a Hoover F7458-900 manual? We have 1 online manual for this item!
Question posted by karenritter39 on August 15th, 2011
Cleaner Will Not Come Out, Rinse Will
When I turn it to wash the cleaner will not come out, put it on rinse and water will come out!
Current Answers
Related Hoover F7458-900 Manual Pages
Product Manual - Page 2
... product to the store.
2
Please enter the complete model and Manufacturing Code in China
Manufacturing code
(Label located on bottom of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5 How To Use...7
Cleaner Description 7 The Tanks...8 How to Clean...10 Tools...13 Maintenance...17 Nozzle...17 Brushes...17 Valve...18 Storage...18 Lubrication...18 Troubleshooting...
Product Manual - Page 3
...Hoover®; Do not immerse product.
• Connect to run appliance over floor electrical outlets. • Do not use . If an extension cord is..., matches, or hot ashes.
3 Turn off all controls before unplugging. • Unplug before servicing the carpet cleaner. • Do not unplug by pulling...into water, take it to be
followed, including the following: READ ALL INSTRUCTIONS...
Product Manual - Page 4
Do not use with the carpet cleaner.
Grounding Instructions
This appliance must be installed by a qualified electrician. DANGER: Improper ...lug, or the like the plug (A) illustrated in . • DO NOT USE THIS EXTRACTOR ON HARD FLOORS UNLESS YOU HAVE THE PROPER
HARD FLOOR ATTACHMENT. Do not modify the plug provided with a qualified electrician or service person if you are in a...
Product Manual - Page 5
...*
*Available on select models only.
Hose/Cord Hook E. Make sure all parts from images shown. Cleaner B. 1. NOTE: Phillips screwdriver needed for assembly. Tighten with screwdriver.
1.2
1.3 Cord Protector -V2
... Caddy* G Hose H Stair/Upholstery Nozzle I
B
E
A
A. Cleaner ASSEMBLY
Carton contents
1.1
Carpet Upholstery
Cleaner
Bare floor cleaner
PreCleaner
G
C
H
D
F
I .
Product Manual - Page 6
...15
IMPORTANT
Tool caddy is secure. Attach hose/cord hook
1.9 1.9 Snap hook onto
cleaner.
1.7
1.8
Attach tool caddy
(for storage on select models only)
1.10 Insert... Store Tools on back side of cleaner with other hand.
1.8 Push up on hook (C). Notch (B) rests on handle to cleaner. Check tank to make sure it to latch it is removable for storage on cleaner) (Available on wall or in...
Product Manual - Page 7
... Water Tank
12. Hose Connection Port
16
24
23
15
18. SpinScrub® Mode Selector 14. CAUTION !
24. Solution Tube Connection Port
11
15. Hand Grip 2. SpinScrub® Hand Tool*
5
19
20
6. Detergent Container
9
10. Hose/Tool Caddy* 21. ON-OFF switch
To turn cleaner OFF, push switch up.
2.2
Rinse ON
OFF
WASH AUTO RINSE
Handle...
Product Manual - Page 8
... on the unit.
2.11
IMPORTANT
The tank pivots towards the back of the tank to the water tank.
How to rinse the carpet or floor. CAUTION ! Replace container cap and tighten.
2.11 Position bottom of tank onto cleaner using one hand on each side of the unit. Non-Hoover® cleaning solutions may vary...
Product Manual - Page 9
... handle to unlock lid. G
How to Empty
Turn cleaner off will engage, suction will damage your SteamVac® detergent container (A), Clean Water Tank (B) or Dirty Water Tank (C).
Dirty Water Tank
(lower tank)
The Dirty Water Tank holds the dirty solution that the Dirty Water Tank lid is properly secured before putting cleaner in place.
9
Actual model may vary...
Product Manual - Page 10
...cleaner as a dry vacuum cleaner. Automatic shut off
When the Dirty Water Tank (lower tank) is marked with a "W" (for "wet" clean) or "S/W" (for best results.
When this happens, turn cleaner off and empty Dirty Water...the surface with HOOVER® Spot & Stain Spray Cleaner*- Wait ten minutes and check for colorfastness - When cleaning entire floor, move area rugs/ carpet to be cleaned). ...
Product Manual - Page 11
....
It is visible passing through the Dirty Water Tank lid (Pass over floor electrical outlets. Turn cleaner ON.
3.2 Squeeze trigger to RINSE.
To avoid walking on both forward and reverse strokes.
3.3 If you (second wet stroke). Turn cleaner ON.
3.2a Squeeze trigger to Wash/Auto Rinse.
Release trigger and slowly push cleaner forward over one wet stroke).
Continue to squeeze...
Product Manual - Page 12
...over the spill initially with the SpinScrub® mode selector to be rotating slowly, disconnect cleaner from electical outlet and check and clean this screen.
3.4
3.5
Actual model may also be... nozzle or floor nozzle with suction only. After cleaning
Allow carpet or upholstery to walk on damp carpet, place towels or white cloths on carpet or uholstery. Rinse the Dirty Water Tank lid ...
Product Manual - Page 13
.... 4. To reduce the risk of tool storage area. To reposition the tool, reverse this procedure. TOOLS
Attach hose
! Remove solution tube from moving parts, unplug cleaner.
4.1
A
How to the scrub module.
(Available on select models only)
4.4 To remove the SpinScrub® hand tool pull tool down and outward.
Product Manual - Page 14
... tools attach to remove tool.
After Using Tool
Drain suction hose by turning cleaner ON and holding nozzle up on the cleaner.
4.7
4.8
Actual model may vary from images shown. 14 CAUTION !
4.6
G
To reduce the risk of injury from moving parts, unplug cleaner. CAUTION ! Press the trigger.
4.8 The tool caddy can be removed and hung...
Product Manual - Page 15
... any one wet stroke).
4.9
4.10
A
B
Position tool against riser.
Turn cleaner ON.
4.9 Pre-spray the carpeted stair by 1/2 inch to end of carpet... Water Tank when the motor sound becomes higher pitched and there is best to instructions for Figs. 2.9 to WASH.... Attach hose and solution tube as described above the carpet and push it into a properly grounded outlet.
Set Rinse...
Product Manual - Page 16
... handle is not available during tool use hard floor cleaning solution when cleaning upholstery. Turn cleaner ON.
4.11 Gently press the tool onto ...the fabric.
Make no more moisture. Use your upholstery. Place handle in suction (see "Automatic Shut-Off", Fig. 2.17).
Do not use . IMPORTANT
rinse is in upright position.
Empty Dirty Water...
Product Manual - Page 17
... water.
5.4
A
B
D
B
A
How to snap into place.
17 Actual model may vary from cleaner.
5.2 To replace nozzle, line up tabs (A) on the floor....Water Tank and Dirty Water Tank. B A
Slide nozzle completely onto cleaner. Replace Dirty Water Tank (Fig. 2.16).
Slide nozzle up rear edge of your cleaner will ensure continued cleaning effectiveness. 5. With handle in Fig. 2.16.
Turn...
Product Manual - Page 18
... images shown. 18 Allow brushes and underside of carpet cleaner to motor bearings.
Therefore, do not add lubricant to air dry thoroughly before storing carpet cleaner on a carpeted or wood surface.
The addition of the motor.
Turn cap clockwise to Unclog
Remove Clean Water Tank.
5.5-5.6 Turn valve cap (A) counter clockwise and remove. valve:
How to...
Product Manual - Page 19
.... TROUBLESHOOTING
If a minor problem occurs, it usually can be done by using the checklist below ).
1. PROBLEM
POSSIBLE CAUSE
Cleaner won 't rotate during floor cleaning.
1.
No voltage in home.
1.Remove and empty Dirty Water Tank.
Valve cap clogged.
1. B
• Use extra dry strokes to instructions for surface being cleaned.
3 .Make sure lid is found...
Product Manual - Page 20
7. Do not send your vacuum by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". • Visit our website at hoover.com (U.S. Mon-Fri 8am-7pm EST. This will only result in Glenwillow for service. Follow the service ...
Product Manual - Page 21
...
detergents, wipes, and spot cleaners available at
Hoover.com and retailers...61520;
Hoover® MaxExtractTM Dual V® All Terrain
Hoover
Platinum
Collection&#... Brush Hoover® part # 48417008. Anti-Allergen1
Hard Floor
Hoover Platinum
Collection® Professional
Strength
Hoover Platinum
Collection®...
Similar Questions
How To Change A Belt On A Hoover Steam Vac F7425-900
(Posted by dolndhat 9 years ago)
Brushes Won't Turn On Hoover Max Extract All Terrain Carpet Cleaner
(Posted by whh5an 9 years ago)
Hoover Maxextract All-terrain Carpet Cleaner Detergent Won't Come Out
(Posted by Hennnewma 9 years ago)
Hoover Steam Vac #6207-900-how Do I Change The Belt To The Brushes
how to change the belt that drives the brushes on hoover steam vac #6207-900
how to change the belt that drives the brushes on hoover steam vac #6207-900
(Posted by matflip93 12 years ago)
Brushes Won't Spin On Hoover Maxextract All Terrain Carpet Cleaner
Everything works fine EXCEPT the brushes don't spin. I have cleaned the filter as the manual suggest...
Everything works fine EXCEPT the brushes don't spin. I have cleaned the filter as the manual suggest...
(Posted by tsbequette 12 years ago)