Hayward HeatPro Support Question
Hayward HeatPro Support Question
Find answers below for this question about Hayward HeatPro.Need a Hayward HeatPro manual? We have 3 online manuals for this item!
Question posted by nicolegraniero on October 7th, 2011
Intermitten Problems With Control Buttons
I just purchased a heat pro and, since yesterday, my control buttons don't always work. Is that a recurrent problem ?
Current Answers
Related Hayward HeatPro Manual Pages
Heat Pro Owners Operations & Parts Manual - Page 2
...permanently installed pool is constructed so that is designed for electrocution and could result in or on the heat pump, pumps or filters. WARNING To reduce the risk of 22
HEATPRO HEAT PUMP
...(disembowelment). Before working on permanently installed swimming pools and may also be installed.
Failure to bond heat pump to near point. To reduce
the risk of swimming pool or spa, and to ...
Heat Pro Owners Operations & Parts Manual - Page 3
...pressure test plugs and/or plugs used in winterization of the pool/spa from your supplier. Do not change filter control valve position while system pump is damaged, broken, cracked, missing,...fires, which could cause property damage, severe personal injury, or death. Page 3 of 22
HEATPRO HEAT PUMP
HP13023772 Rev: D
o Dual suction fittings shall not be located on seating areas or on...
Heat Pro Owners Operations & Parts Manual - Page 4
... safety controls are not in any hot surface layer of heart disease, circulatory problems, diabetes or blood pressure problems should obtain a physicians advice
before entering the pool/spa to leave the spa.
4. Unconsciousness resulting in this manual. The use is recommended. Failure to recognize the need to
mix in proper working order.
7. Unawareness of 22
HEATPRO HEAT PUMP...
Heat Pro Owners Operations & Parts Manual - Page 5
... temperature control of pool and spa o Display of self diagnostic codes to read display; Digital Electronic Control (All Models):
o Easy to monitor heat pump performance; o Defrost Function to heat a pool 1°... 11 14 35
71 141
Features:
-
Page 5 of 22
HEATPRO HEAT PUMP
HP13023772 Rev: D
The following table lists the minutes it will take to prevent evaporator coil freeze up; -
Heat Pro Owners Operations & Parts Manual - Page 10
... fails to start .
6. Control System components must be replaced if submerged in water. Blocking airflow could damage the unit
and will cause property damage.
When the unit starts, confirm that power is flowing through the unit as setup by ensuring the light above the "POOL" button (and "SPA" button for the Heat Pump to the "ON...
Heat Pro Owners Operations & Parts Manual - Page 11
... 11 of the controller. Activates the pool function of 22
HEATPRO HEAT PUMP
Becoming Familiar with HeatPro Heat Pump Controls
Display Window
HP13023772 Rev: D
Up Arrow Button Down Arrow Button
Spa Button (Optional)
Run Light
Heat Pump Control Panel
Pool Button
Display Window (All Models)
Up Arrow Button (All Models) Down Arrow Button (All Models) Pool Button (All Models) Spa Button (All...
Heat Pro Owners Operations & Parts Manual - Page 12
... standby first. Page 12 of 22
Control Operation
HEATPRO HEAT PUMP
HP13023772 Rev: D
Dual Thermostat (Models HP20654T, HP20654BT, HP20854T, HP20854BT & HP21104T)
On/Off: To enter Standby mode:
To exit Standby mode:
This control does not have a true on the display. If spa mode is active (indicated by using the POOL / SPA buttons. Scrolling dots in the display indicate...
Heat Pro Owners Operations & Parts Manual - Page 13
... life of the heat pump.
Lock Out Feature (All Models):
A lock out function is near 50°F (10°C). The control display will read "LOC" while the lock out function is no exact temperature at which this function in the pool or spa mode press the up arrow button, down arrow button and pool button at the same...
Heat Pro Owners Operations & Parts Manual - Page 15
.... Ensure that the pool / spa water is illuminated).
4.
Ensure the swimming pool filtration system is set at a temperature above 50°F [10°C] for most of 22
HEATPRO HEAT PUMP
HP13023772 Rev: D
Some heat pump owners desire their pool to the troubleshooting section on .
2. If temperatures fall below freezing, be a problem, refer to be heated during the winter months...
Heat Pro Owners Operations & Parts Manual - Page 18
... flow to "ACP" if the unit has the heat / cool option. Call Pool Service Provider. If button does not release. Control communication problem. Board Failure Frost build up on Normal operation for Hayward HeatPro Heat Pump
Display
Problem
Possible Cause
Solution
(Blank)
No power to owner's manual of 22
HEATPRO HEAT PUMP
HP13023772 Rev: D
Display Diagnostic Codes - Sensor...
Heat Pro Owners Operations & Parts Manual - Page 21
... coverage begins from HAYWARD. Page 21 of 22
HEATPRO HEAT PUMP
HP13023772 Rev: D
HAYWARD® HEAT PUMP POOL HEATER LIMITED WARRANTY
The HAYWARD heat pump pool heater is warranted to be free of defects in... or repair is the exclusive remedy available from the date of purchase, or sixty days after October 1, 2008
Hayward Pool Products, Inc. 620 Division Street Elizabeth, NJ 07207
Retain this...
Heat Pro Installation - Page 3
... pressure test plugs and/or plugs used in winterization of the pool/spa from the suction outlets can
result in an increase potential for ...pool and spa water circulation system, all system and pump controls must be in off . Before servicing pool and spa circulation system, filter manual air relief valve must be in open position. WARNING-Fire and burn hazard.
Page 3 of 20
HEATPRO HEAT...
Heat Pro Installation - Page 4
... - INSTALLATION:
Materials needed for all power to exit the spa.
5. This switch MUST be done with controls, because scalding can result if safety controls are needed at the heat pump; Fetal damage in Hg) -
Unconsciousness resulting in danger of Mercury (in pregnant women.
6. Always stir pool/spa water before using as few fittings as water flows...
Heat Pro Installation - Page 7
... of condensation and rainwater from the roof to the bottom of the pool, spa, solid fence, or permanent barrier. Equipment Pad
Place the heat pump on all sides.
2. Page 7 of the unit. NOTE:...surface such as proximity and height of rainwater, mixed with debris from the base of 20
HEATPRO HEAT PUMP
HP13023770 Rev: E
Placement / Clearances
All criteria given in property damage and a voided...
Heat Pro Installation - Page 12
... line to the pool. If the heat pump is installed below ). This pressure switch setting should be adjusted so that the heat pump is running . This will create adequate backpressure at the heat pump to install a positive flow switch in the control panel of the pressure switch.
Adjustment knob - Installation of 20
HEATPRO HEAT PUMP
HP13023770 Rev...
Heat Pro Installation - Page 15
...the figures above. Always disconnect power circuit before connecting the heat pump, or working on the front cover of ground fault devices, are ...pool or spa users, installers, or others due to this bonding grid. An outdoor waterproof disconnect should be installed under the factory warranty. Label all heat pumps. The preceding standards govern the installation of 20
HEATPRO HEAT...
Heat Pro Installation - Page 17
... three wires marked as pool, spa, and common from the remote system. CAUTION -
The proper flow rate ranges for ALL Hayward HeatPro Heat Pumps are compatible, in the heating mode only, with one wire into terminal 1, and the other into terminal 2.
• The thermostat on the heat pump must be in the unit Control Box
• The...
Heat Pro Installation - Page 18
... from the unit and the air is suspected that power is installed correctly.
If the light(s) are lit, depress the "POOL" button (and "SPA" button for the Heat Pump to Performance Monitoring Section of 20
HEATPRO HEAT PUMP
HP13023770 Rev: E
Start-Up Procedures
1.
Page 18 of this installation manual. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA...
Heat Pro Installation - Page 20
... outside temperature to owner's manual of 20
HEATPRO HEAT PUMP
HP13023770 Rev: E
Display Diagnostic Codes -Troubleshooting Guide for Hayward HeatPro Heat Pump
Display (blank)
Problem
No power to heat pump
Faulty electrical component
Possible Cause
Tripped circuit breaker/ no water flow
valve is closed . Check pool temp. Push button stuck Control not receiving data from panel Panel not...
Heat Pro - Page 24
...only and is the exclusive remedy available from HAYWARD. This warranty is applicable to improper pool chemistry. There are returned to be approved by best and most economical means.
22
... and workmanship for a period of the heat exchanger has a ten (10) year warranty. Hayward® Heat Pump Pool Heater Limited Warranty
The HAYWARD heat pump pool heater is not liable for damages of any...
Similar Questions
Heatpro - Turns On And Shuts Right Off, Not Sure Why No Error Message???
We got the Hayward Heatpro for our new pool. First day we used it - it worked great!e The next day w...
We got the Hayward Heatpro for our new pool. First day we used it - it worked great!e The next day w...
(Posted by janetmarenghi 6 years ago)
My Hayward 250fd Control Is Frozen And Digital Switch Will Not Move Off 'pool'
Panel lights are on "pool" and 82 degrees, but nothing is working, not any of the switches to change...
Panel lights are on "pool" and 82 degrees, but nothing is working, not any of the switches to change...
(Posted by dhtraveler 10 years ago)
Hayward Heatpro Fan Problem...
I have a hayward heatpro and the big circular fan after about 10 minutes slowdown and stop with a hu...
I have a hayward heatpro and the big circular fan after about 10 minutes slowdown and stop with a hu...
(Posted by Michaud548 10 years ago)
Dual Pool Spa System But The Settings Menu Doesn't Show Pool Heater Only Spa Hea
(Posted by Anonymous-39619 12 years ago)