GE WPGT9150HMG Support Question
GE WPGT9150HMG Support Question
Find answers below for this question about GE WPGT9150HMG - Profile 27" Washer.Need a GE WPGT9150HMG manual? We have 1 online manual for this item!
Question posted by russellolin45 on May 31st, 2013
Code D2
We have a code d2 show up as soon as power is turned on. What does the d2 stand for.
thanks
Current Answers
Related GE WPGT9150HMG Manual Pages
Owners Manual - Page 1
Profile Washers
ge.com
Safety Instructions 2, 3
Operating Instructions
Control Panel 4-5 Features 6-8 Loading and Using the Washer 9, 10
Installation Instructions
Before You Begin 11-13 Step-by-Step Instructions . . . . . .13-16
Troubleshooting Tips . . . . . ... serial numbers here:
Model
Serial
You can find them on the rear cover of the washer backsplash.
175D1807P604 49-90336 09-07 JR
Owners Manual - Page 2
... water heater that has not been used by turning on , with the Installation Instructions before using ...below freezing or exposed to escape.
YOUR LAUNDRY AREA
I Install or store where it is... is connected to play on all governing codes and ordinances. Installation Instructions are included in... has not been used .
I Properly ground washer to conform with all hot water faucets and...
Owners Manual - Page 3
...WASHER
I Never reach into washer while it is moving. I Before discarding a washer, or removing it from the power supply
before attempting any part of fabrics.
I Never attempt to repair or replace any maintenance or cleaning. I Do not attempt to operate this appliance only for its intended purpose as
I The laundry...specifically recommended in I Turn off the circuit breaker ...
Owners Manual - Page 4
... manual, features and appearance may vary from the power supply. If the display is active, press to "wake up" the display.
Installation Instructions
Consumer Support Troubleshooting Tips
4 NOTE: Pressing POWER does not disconnect the appliance from your model.
1
3 45
26
1 Power Press to put the washer into idle mode.
Operating Instructions Safety Instructions
About...
Owners Manual - Page 5
... always cold to normal soil. NOTE: The first 10 seconds of soil. If the washer is not restarted within 15 minutes, the current wash cycle will pause the washer. Press again to clean the load. NOTE: If the washer is paused and the cycle is running, pressing it once will be cancelled. NOTE...
Owners Manual - Page 6
...hold down and start of the cycle, then press the START button.
Operating Instructions Safety Instructions
About the washer features.
Extra Rinse
Use an extra rinse when additional rinsing is 3 hours.
NOTE: If you open ...the MY CYCLE button before starting the cycle, the MY CYCLE light will turn off and you will sound to 24 hours. NOTE: When using MY CYCLE, wash options cannot be...
Owners Manual - Page 7
... of additives.
• Avoid overfilling or splashing when adding laundry products to the dispenser. At the end of the washer. Troubleshooting Tips Consumer Support
7
Also keep clothes away from ... result in early dispensing of bleach.
3 Before starting the washer, pour measured amount of laundry products. Overfilling could result in early dispensing of bleach directly into bleach dispenser. ...
Owners Manual - Page 8
...all remaining detergent is flushed through the dispenser at the beginning of presoak additives, which could result in your washer, as Tide® HE. You may stain the clothes.
NOTE: Do not pour fabric softener directly on...
Consumer Support Troubleshooting Tips
8
Avoid using liquid detergent, make sure all washer models. When using too much detergent in damaged clothes.
Owners Manual - Page 9
...). Overloading may not completely cover the load.
Because of the wash basket. To add items after washer has started, lift the lid, add items and close the lid.
• Do not wash fabrics... containing flammable materials (waxes, cleaning fluids, etc.)
• The washer will automatically detect the load size. The washer will not fill or operate with the lid open. HE detergents are ...
Owners Manual - Page 10
... be below freezing. Proper Use of the recess.
4 Return the inserts to remove traces of the Washer
Lid: Wash with a soft cloth. rinse the inserts and the drawer with liquid detergent; Care and Cleaning of accumulated laundry products.
3 To clean the drawer opening, use in the dispenser drawer. then rinse. (Do not...
Owners Manual - Page 11
...codes and ordinances. Must be supplied. Both hot and cold shutoff valves (faucets) should be drained into an appropriate outlet that is not
covered under any circumstances, cut or remove the third grounding prong from the power...
codes and ordinances. • Note to leave these instructions for electric current. Do not, under the Warranty. Improper connection
of the washer....
Owners Manual - Page 12
... a wood floor is installed. The washer should not be installed on this label are required to providing adequate clearances for installing and servicing.
27″ (68.6 cm)
Side View...8243; front • 3″ rear
Minimum vertical space from floor to weather. Minimum clearance between washer and adjacent walls or other surfaces:
• 0″ either side • 2″ front &#...
Owners Manual - Page 13
... the Styrofoam block containing the Owner's Manual, parts, water hoses and laundry product samples.
❑ Cable Tie
TOOLS YOU WILL NEED
❑ Adjustable Pliers ❑ Carpenter's Level
Remove the power cord from the back of the washer.
1 UNPACK THE WASHER
After the washer is in the home, remove the carton and Styrofoam shipping base from...
Owners Manual - Page 14
... rear clearance is a standpipe, fasten the drain hose to the standpipe with pliers.
3 MOVE WASHER CLOSE TO HOUSE UTILITIES
Move the washer as close to the final location as possible, leaving enough room to make an additional 1/8 turn with the cable tie provided.
3″
Cable Tie
Cable Tie
14
Hand tighten; Hot Cold...
Owners Manual - Page 15
...,
open the lid and place a level at the back of the opening above the dispenser drawer. • To check if the washer is not level, adjust the front leveling legs. Turn clockwise to raise, counterclockwise to 6 inches and gently lower the rear legs back onto the floor. This action will set rear...
Owners Manual - Page 16
... and other information, refer to warm up before pressing POWER. The washer is now ready for servicing phone numbers. Otherwise, the display will not come on. SERVICING
WARNING - Wiring errors can cause improper and dangerous operation after servicing/installation.
NOTE: If the washer has been exposed to temperatures below freezing for an extended...
Owners Manual - Page 17
... after a cycle was set properly Lid is optimized by disconnecting hose at machine. Press POWER.
• Make sure cord is opened during washer operation, all washer cycle operations. If the lid is plugged securely into a working outlet.
• Turn both hot and cold faucets fully on the following pages first and you call for...
Owners Manual - Page 18
...conditioning or water softening units are turned to premature dispensing. Always reference your wash cycle.
Installation Instructions
Problem
Possible Cause
What To Do
Washer will not dispense from the fabric ... used . For all fill and drain hose connections to help avoid overfilling.
water standing in the bins of bleach Poor stain removal
18
Kinked drain hose or drain
&#...
Owners Manual - Page 19
... added after the
spin or rinse cycle
main wash cycle. Water sloshing sound when washer is turned off and tub is diluting laundry additives to add to remove water from the basket. High-pitched noise during the • The washer has special rinse features to the wash load. Humming noise during the final rinse...
Owners Manual - Page 20
...will be responsible for home use the product.
The direct drive motor and outer washer tub if any labor or related service costs. During this Limited Warranty.
EXCLUSION...20 I Incidental or consequential damage caused by accident, fire, floods or acts of the washer which vary from state to obtain service
under operating conditions.
I Damage after delivery. ...
Similar Questions
Washer Will Not Start
What do I need to to went E7 come up when you push start?
What do I need to to went E7 come up when you push start?
(Posted by estherfallis57 6 years ago)
My Ge Gtwn5559dww Washer Does Not Agitate Or Spin.
I opened the front of the washer and the motor does not turn. How can I check power to the motor? Wh...
I opened the front of the washer and the motor does not turn. How can I check power to the motor? Wh...
(Posted by ywamdallas 8 years ago)
Washer Won't Fill. The Water Is Going Straight Out The Drain Hose
my washer started sounding like a plane taking off while spinning. Then it starred leaking out the b...
my washer started sounding like a plane taking off while spinning. Then it starred leaking out the b...
(Posted by cheryletebor 9 years ago)
My Washer Keeps Shutting Down During The Rinse Cycle.
Then I have to wait half an hour to restart the washer and it has to restart from the beginning of a...
Then I have to wait half an hour to restart the washer and it has to restart from the beginning of a...
(Posted by goldieadams 11 years ago)
My Model Wpgt9150hmg Is Showing Code 50 Cl
(Posted by gaby37nice 13 years ago)