GE WPGT9150HMG Support Question
GE WPGT9150HMG Support Question
Find answers below for this question about GE WPGT9150HMG - Profile 27" Washer.Need a GE WPGT9150HMG manual? We have 1 online manual for this item!
Question posted by estherfallis57 on April 5th, 2018
Washer Will Not Start
What do I need to to went E7 come up when you push start?
Current Answers
Related GE WPGT9150HMG Manual Pages
Owners Manual - Page 1
Profile Washers
ge.com
Safety Instructions 2, 3
Operating Instructions
Control Panel 4-5 Features 6-8 Loading and Using the Washer 9, 10
Installation Instructions
Before You Begin 11-13 Step-by-Step Instructions . . . . . .13-16
Troubleshooting Tips . . . . . ... serial numbers here:
Model
Serial
You can find them on the rear cover of the washer backsplash.
175D1807P604 49-90336 09-07 JR
Owners Manual - Page 2
... this manual must be produced in the back of damage or injury by or near children.
YOUR LAUNDRY AREA
I Install or store where it is connected to the weather. Do not allow any built-... or appliance during this manual. If the hot water has not been used . PROPER INSTALLATION
This washer must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property...
Owners Manual - Page 3
NOTE: Pressing the START/PAUSE or POWER button does NOT disconnect the appliance
described in this Owner's Manual.
WHEN NOT IN USE
I The laundry process can produce a toxic gas which may cause death.
SAVE THESE INSTRUCTIONS
Installation Instructions
Troubleshooting Tips Consumer Support
3
Do not add these substances around
your washer or dryer during operation...
Owners Manual - Page 4
... panel. Installation Instructions
Consumer Support Troubleshooting Tips
4
NOTE: Pressing POWER does not disconnect the appliance from your model.
1
3 45
26
1 Power Press to put the washer into idle mode. If the display is active, press to "wake up" the display. Control Panel Throughout this manual, features and appearance may vary from...
Owners Manual - Page 5
...household linens, work and play clothes.
SPEED WASH For lightly soiled items that they are needed in a hurry.
The prewash and rinse water is approximately 30 minutes, depending on ...help you match the wash setting with the loads.
NOTE: The washer performs automatic system checks after pressing the START button. Always follow the fabric manufacturer's care label when changing the...
Owners Manual - Page 6
... hours. NOTES:
• When selecting soak, it for heavily soiled clothes or for 3 seconds.
Delay Start
You can delay the start of cycle signal.
NOTE: When using MY CYCLE, wash options cannot be available on all washer models. Press the button until you change the saved cycle, set the desired settings for wash...
Owners Manual - Page 7
... can produce a toxic gas which may see water in early dispensing of bleach.
3 Before starting the washer, pour measured amount of the bleach into the bleach dispenser. This ensures performance won't be ... use bleach in early dispensing of additives.
• Avoid overfilling or splashing when adding laundry products to your clothes, never add more than the maximum fill level marked on the ...
Owners Manual - Page 8
...clothes. Installation Instructions
Consumer Support Troubleshooting Tips
8 Operating Instructions Safety Instructions
About the washer features.
Insert
Detergent box
Adding Detergent
NOTE: Use only low-sudsing, high-efficiency ...beginning of the load.
Detergent is removed from the wash load. Detergent usage may need to the maximum fill line.
• Do not exceed the maximum fill line...
Owners Manual - Page 9
... non-chlorine bleach (when needed)
Do not bleach
Washer Temperature Ranges
Category Tap Cold Cold Warm Hot
Target Temperature 60°F 66°F 90°F 120°F
NOTE: Use HE (high-efficiency) labeled detergent. Always follow fabric manufacturer's care label when laundering.
To add items after washer has started, lift the lid, add items...
Owners Manual - Page 10
... liquid detergent;
You can use a clean soft cloth dampened with warm water to remove traces of laundry problems. Today's detergents are formulated to be exposed to use harsh or gritty cleaners.)
Fill Hoses: Hoses connecting washer to evaporate.
If you have soft water, a smaller load or a lightly soiled load.
Do not touch...
Owners Manual - Page 11
...and carefully.
• IMPORTANT - Be sure to whether the appliance is the responsibility of the washer.
WATER TEMPERATURE - SHUTOFF VALVES - Discharge height MUST NOT BE LESS THAN 30 INCHES and no...more than 8 feet above requirements, call 1.800.561.3344 or visit geappliances.ca
Washer
WPGT9150
BEFORE YOU BEGIN
Read these instructions for
local electrical inspector's use an extension ...
Owners Manual - Page 12
... FHA standards.
A louvered door with lid
open area for installing and servicing.
27″ (68.6 cm)
Side View
523⁄ 4″ (133.7 cm)
(with equivalent...
Minimum vertical space from floor to overhead shelves, cabinets, ceilings, etc., is 52″. Minimum clearance between washer and adjacent walls or other surfaces:
• 0″ either side • 2″ front • ...
Owners Manual - Page 13
... the Styrofoam block containing the Owner's Manual, parts, water hoses and laundry product samples.
❑ Cable Tie
TOOLS YOU WILL NEED
❑ Adjustable Pliers ❑ Carpenter's Level
Remove the power cord from the back of the washer.
1 UNPACK THE WASHER
After the washer is in the home, remove the carton and Styrofoam shipping base from...
Owners Manual - Page 14
...tighten; Hand tighten, plus make an additional 1/4 turn with pliers.
3 MOVE WASHER CLOSE TO HOUSE UTILITIES
Move the washer as close to the final location as possible, leaving enough room to make an...to the standpipe with pliers.
Installation Instructions
2 ATTACH WATER HOSES TO WASHER
Thread the hot water hose onto the washer hot water connection (ORANGE) and the cold water hose onto the ...
Owners Manual - Page 15
... rear legs back onto the floor.
This action will set rear leg adjustments to correspond to front settings.
7 LEVEL THE WASHER
Move the washer into final position. • To check if the washer is level side to back, place a level at the back of the opening above the dispenser drawer. • To check...
Owners Manual - Page 16
... freezing for an extended period of time, allow it to disconnection when servicing controls. Otherwise, the display will not come on. The washer is now ready for servicing phone numbers.
Installation Instructions
8 PLUG IN WASHER
9 WASHER STARTUP
Press the POWER button. SERVICING
WARNING - Label all wires prior
to warm up before pressing POWER.
Wiring...
Owners Manual - Page 17
...need to call for service... Prevents the washer from filling and operating when lid is up before pressing POWER. Washer should have separate outlet.
• Unplug washer, wait 2 minutes, plug back in and press POWER.
• Press START.
• Press START again.
• If the washer... will not come on . This is open positions.
• The washer lid must be closed for service.
Owners Manual - Page 18
...Bleach bin is used . Insufficient cleaning
• You may be put into place before starting the cycle. If powdered detergent is not seated
• Make sure that you call for...• When stain inspector is used . Installation Instructions
Problem
Possible Cause
What To Do
Washer will be removed from the detergent bin for occasional cleaning with bleach may be over 8&#...
Owners Manual - Page 19
... needed.
• The wash load may be diluting laundry additives to add to the cycle as it will make a series of the wash cycle. draining
Pinging noise during the • The washer ...sound during the wash cycle
• The washer will stop and refill to redistribute the load.
• The washer may hear:
Sound
Description
Repeated starting and • The HydroWash™ action spins...
Owners Manual - Page 20
...
Lifetime of Product From the date of the original purchase
We Will Replace:
Any part of circuit breakers. The washer basket if it is needed to state.
I Replacement of house fuses or resetting of the washer which vary from state to obtain service
under operating conditions.
Operating Instructions Safety Instructions
Installation Instructions
GE...
Similar Questions
Shattered Glass In Lid
The glass in my washer lid is shattered. Can I replace it or buy a new lid?
The glass in my washer lid is shattered. Can I replace it or buy a new lid?
(Posted by ladysuzeq 3 years ago)
Wahser Will Not Start Cycle
My front loading washer turns on. And when I push the start button the door locks after a few second...
My front loading washer turns on. And when I push the start button the door locks after a few second...
(Posted by kaganriverranch 5 years ago)
Ge Front Load Washer Start Pause Button Flashing And Wont Start
(Posted by mapskl 9 years ago)
My Washer Keeps Shutting Down During The Rinse Cycle.
Then I have to wait half an hour to restart the washer and it has to restart from the beginning of a...
Then I have to wait half an hour to restart the washer and it has to restart from the beginning of a...
(Posted by goldieadams 11 years ago)
My Model Wpgt9150hmg Is Showing Code 50 Cl
(Posted by gaby37nice 13 years ago)