Frigidaire GLEQ2152ES Support Question
Frigidaire GLEQ2152ES Support Question
Find answers below for this question about Frigidaire GLEQ2152ES - Electric Dryer.Need a Frigidaire GLEQ2152ES manual? We have 4 online manuals for this item!
Question posted by bsmegreen on February 22nd, 2011
Frigidaire Dryer Model Gleq2152es1
Lights are on on front of dryer,push start button, a DR shows on timer
Lights are on on front of dryer, push start button, a DR [ error code ?] on timer window and beeps 3 times, will not run.
Would like to know how to fix.
thank you, brad
Current Answers
Related Frigidaire GLEQ2152ES Manual Pages
Use and Care Manual - Page 2
... about :
The model and serial numbers of the door opening.
By ensuring this or any electrical switch;
Record and • Care
retain these numbers.
Use the dryer only as household waste... Clear the room, building or area of correctly, you to light any appliance. • Do not touch any other models. do not use accessories certified by the safety alert symbol and the ...
Use and Care Manual - Page 3
... to fabrics can become airtight chambers. • Keep laundry products out of children is necessary when the dryer is removed from electrical power cord.
These substances give off vapors that may...personal injury, observe all warnings on or near dryer at any time. • Do not use of the dryer. An excessive amount of fire, electrical shock, or injury to the rubber or plastic...
Use and Care Manual - Page 4
... come to persons, read and follow fabric care labels and laundry product labels. The third grounding prong must never be installed and electrically grounded by a qualified service person. • To prevent personal injury or damage to the dryer, the electrical power cord of fire, electrical shock, or injury to a complete stop when the door is...
Use and Care Manual - Page 5
... items hang over time. Hazardous fumes or electrical shock could result in Important Safety Instructions and those listed below.
• Before cleaning the dryer interior, unplug the electrical power cord to persons...longer drying times. End of Cycle Signal A signal will come on whenever the door is located at the volume level selected. (some models) Drum Light (some models) Use the...
Use and Care Manual - Page 6
...120 ml) in washer or dryer to
electricity.
• Or, add a fabric softener sheet and
reduce static electricity.
• Lint screen not... spray starch or fabric
finish on top of load
before starting the dryer. Or, touch residue with a mixture of warm water ... several times with ammonia or any time. Care and Cleaning con't
Do not store or place laundry products on top of dryer at medium...
Use and Care Manual - Page 7
Avoid Service Checklist
Before calling for service, review this dryer. OCCURRENCE
Dryer does not start.
Gas supply valve is not open . LP gas supply tank is open (gas models). See INSTALLATION INSTRUCTIONS for replacement.
Outside exhaust hood or exhaust duct may save both time and expense. High humidity. Make sure all lint has been removed from...
Technical Data Sheet - Page 1
Press and hold the START and Pause Cancel buttons simultaneously for 4 seconds. 4. On better model dryers, the error code will flash the number of times for the first digit of the code and the START indicator light will appear in the code stands for anything that cycle. The code is shorted. The five indicator lights and the START indicator light start dryer. Note: A letter appearing...
Technical Data Sheet - Page 2
... program knob can now be rotated to be a key beep with each setting. "H" and the control thermistor reading will flash. 1 O'clock: Drive motor runs; Key test: a. When the START key is pressed, all LED'S will sound 3 times and all the cycle status LED's should light. When the Pause Cancel key is pressed, all the Option...
Installation Instructions - Page 2
...10-30R (3-wire) receptacle or NEMA 14-30R (4-wire) receptacle to light any appliance. · Do not touch any other appliance.
-
...time delay fuses or circuit breakers. do not use with upturned ends or closed loop connectors and marked for use gasoline or other flammable vapors and liquid in this or any electrical switch; The dryer is in a manufactured (mobile) home, the dryer...
Installation Instructions - Page 3
...start the dryer. 3.
Excessive lint can build up of water column. Plugging the system could create a fire hazard, as well as increasing drying times.
Set the dryer timer and temperature to follow these instructions can create excessive drying times...to exhaust the dryer. The system back pressure MUST NOT be exhausted into the laundry area.
When the dryer stops, the...
Installation Instructions - Page 4
...• Running the exhaust system through your parts distributor. On gas dryers, exhausting...codes, with local codes, or in excess of the dryer. In an area where it for proper
ventilation. Installation MUST conform with the National Fuel Gas Code...dryer MUST be installed immediately upstream of stainless steel or plasticcoated brass.
4. However, on electric dryers,...
Installation Instructions - Page 5
...cm)
CLOSET DOOR
0" (0 cm)
15" (38.1 cm)
1" (2.54 cm) 0" (0 cm)
5 The following illustrations show minimum clearance dimensions for sides, rear, and top. cm)
60 sq. This dryer MUST be exhausted outdoors.
5.
MINIMUM INSTALLATION CLEARANCES - NOTE: Under counter and stack models - 0 inches (0 cm) for proper operation in a recess or closet installation.
0" (0 cm)
0" (0 cm)
1" (2.54...
Installation Instructions - Page 6
... (70.49cm) 28.5 to clear door handle (72.39cm)
2.375" (6.03cm)
(34.29cm) 13.5" To rear & base exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to clear...
Installation Instructions - Page 7
... a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is accomplished by transferring hinges to the dryer front panel (see below). MOBILE HOME INSTALLATION
1. This dryer MUST be reversed at any time without additional parts. CAN/CSA C22.2 (latest editions) for outside the enclosure with the four screws.
4. Conversion is...
Installation Instructions - Page 9
... of your protection against shock hazard and should be run with the circuit conductors and connected to whether the appliance is a copper wired power cord with all local codes and ordinances. A U.L.
GROUNDING REQUIREMENTS
ELECTRIC Dryer
Improper connection of the cord, resulting in the cord. Electrical shock can be plugged into a properly grounded three-prong receptacle...
Installation Instructions - Page 10
...MOUNTING B R A C K E T POWER CORD
POWER CORD
ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM
ELECTRIC Dryer
ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEM
ELECTRIC Dryer
1. Remove the screws securing the terminal block access cover and the... the power cord.
8. Install a U.L. Finger tighten the nut only at this time.
3. Reattach the strain relief mounting bracket to the outer brass colored terminals on...
Installation Instructions - Page 11
...dryer are needed for your dryer, contact the source where you purchased your dryer, call 1-800-944-9044, or visit our website, www.frigidaire.com, for future reference. With the dryer in your dryer...timer to be installed by brushing on , the safety switch will light, it is off . If the burner does not light within 45 seconds the first time the dryer... the dryer.
Run the dryer through...
Operating Instructions - Page 1
...steps in your Owner's Guide. If desired, add a dryer fabric softener sheet. Close the door.
4. If a temperature...electrical voltage or gas pressure can also affect drying time. Room temperature and humidity, type of drying time...START again. • To stop or change the temperature or dryness level, press TEMP or DRYNESS until the indicator for more details.
7. The load will not light...
Operating Instructions - Page 2
..., blanket, sleeping bag or similar item.Cool Down is lighted.
Dryer Features
Control To avoid having someone accidentally start or stop the dryer, press OPTIONS and SELECT at the end of the cycle...• Control
PN 134431300A (0501) Note: Using No Heat in any Auto Dry cycle will beep 3 times. Follow the same steps to the desired heat. Cycle Selection (Con't)
Bulky Select this cycle to...
Operating Instructions - Page 3
...Reduce load size. Press buttons lightly and release.
Make necessary corrections, then select a cycle and press START.
Solutions
Remove lint;
DRYER SETTINGS CHART
AVAILABLE CYCLE SETTINGS - Consult the Error Code Chart below or the "Avoid Service Checklist" in the control panel.
ERROR CODE CHART
If the dryer stops, the status lights flash, the signal beeps and a code is based on...
Similar Questions
Frigidaire Electric Dryer Model Gleq2152es1
My dryer started out by displaying "dr" and wouldn't start. I finally got an error code of E68 with ...
My dryer started out by displaying "dr" and wouldn't start. I finally got an error code of E68 with ...
(Posted by kathymoffatt61 7 years ago)
Is There A Heating Element In My Frigidaire Dryer Model Gleq2152es1
(Posted by devidWA 9 years ago)
My Frigidaire Gallery Series Gleq2152eso Coded E9e Then Had No Heatyty
g
g
(Posted by Anonymous-116803 10 years ago)
Error Code E56
dryer will run for a few minutes then the timer will go away while it is still running and it wont h...
dryer will run for a few minutes then the timer will go away while it is still running and it wont h...
(Posted by trevorcoleneuman 11 years ago)
Dryer Model Gleq2152es1 Panel Lights Up Okay But Won't Start. What To Do?
(Posted by phenocryst 12 years ago)